Numerical Simulation of Pressure Variation and Resin Flow in Injection Pultrusion

Abstract

Injection pultrusion is a continuous process for manufacturing composite materials. To produce good quality parts it is essential that complete wet out of the reinforcement fibers is achieved in the injection chamber. To achieve good wet out of the fibers, the magnitude of the resin injection pressure is extremely important. The present study is focused on the effects of pull speed, fiber volume fraction, resin viscosity and compression ratio (taper) of the injection chamber on resin fiber wet out within the injection chamber for polyester-glass roving composites. The recommended injection pressures for complete wet out are predicted for a wide and comprehensive variety of processing variables; this work is novel in that it has new and comprehensive results not available in the existing literature. Darcy's law is used to model the fiber/resin system of injection pultrusion. The Gutowski [Gutowski, T.G., Morigaki, T. and Cai, Z. (1987). The Consolidation of Laminate Composites, Journal of Composite Materials, 21(7): 172-187.] permeability model is used to determine the transverse permeability and the Kozeny-Carman [Carman, P.C. (1939). Flow Through Granular Beds, Trans. Int. Chem. Eng., 15: 150-166.] model is used to predict the longitudinal permeability. The finite volume method is used to predict the resin pressure field, resin velocity field, and resin moving flow front location.

Get full access to this article

View all access options for this article.

References

1. Gutowski, T.G., Morigaki, T. and Cai, Z. (1987). The Consolidation of Laminate Composites , Journal of Composite Materials, 21(7): 172-187 .

2. Carman, P.C. (1939). Flow Through Granular Beds , Trans. Int. Chem. Eng., 15: 150-166 .

3. Kommu, S., Khomami, B. and Kardos, J.L. (August 1998). Modeling of Injected Pultrusion Processes: A Numerical Approach , Polymer Composites, 19(4): 335-346 .

4. Ding, Z., Li, S., Yang, H., Lee, L.J., Engelen, H. and Puckett, P.M. (1999). Simulation and Experimental Verification of Resin Flow and Cure in the Injection Pultrusion , SPI, Session 21-B, pp. 1-6 .

5. Voorakaranam, S., Joseph, B. and Kardos, J.L. (1999). Modeling and Control of an Injection Pultrusion Process , Journal of Composite Materials, 33(13): 1173-1203 .

6. Raper, K., Roux, J.A., McCarty, T.A. and Vaughan, J.G. (September 1999). Investigation of the Pressure Behavior in a Pultrusion Die for Graphite/Epoxy Composites , Composites Part A: Applied Science and Manufacturing, 30(9): 1123-1132 .

7. Patankar, S. (1980). Numerical Heat Transfer and Fluid Flow, McGraw-Hill, New York .