Comparing the fracture toughness of 3-D braided preform composites with z-fiber-reinforced laminar composites

Abstract

Organic polymer engineering composite materials based on layered fabrics have many advantageous properties and processing features. However, performance properties of the layered OPECs, especially impact strength, delamination resistance, and fracture toughness are poor. Three-dimensional preforms fabricated with 3-D weaving, knitting and braiding techniques, are employed to improve the shortcomings of 2-D layered fabric reinforcements. z-directional microfiber-reinforced laminar composites were recently developed to improve impact strength and fracture toughness without reducing in-plane performance properties at minimal added cost and at higher productivity in the Flock Materials Laboratory at the University of Massachusetts Dartmouth. The effectiveness of laminar composite z-directional microfiber reinforcement (by a flocking process) in improving fracture toughness was compared with that of a 3-D braided 8-layer glass fiber preform/epoxy composite plate. The results show that the Mode I fracture toughness (G_I) of the 3-D braided preform reinforced composites are about 10 times of the 2-D layered glass fabric laminar composites (control) as expected. This is comparable to the results of z-directional microfiber-reinforced composites; up to 9 times increase in G_I over that of 2-D glass fabric/epoxy laminar composite (control). The presence of through-thickness microfiber (flock fiber) reinforcements in the matrix resin between reinforcement layers is found not to reduce the in-plane mechanical properties; the fracture toughness however, increases significantly.

Keywords

3-D braiding Mode I fracture toughness z-directional microfiber reinforcement

Get full access to this article

View all access options for this article.

References

Reedy Jr ED , Mello FJ and Guess TR Modeling the initiation and growth of delaminations in composite structures . J Compos Mater 1997; 31: 812-831.

Gillespie Jr JW Damage tolerance of composite structures. J Offshore Mech Arct Eng 1991; 247-252.

Morley JW High-Performance Fiber Composites. New York: Academic Press.

Takeda N. , Kobayashi S. , Ogihara S. and Kobayashiobuo A. Effect of toughened interlaminar layers on fatigue damage progress in quasi isotropic CRPF laminates. Int J Fatigue 1999 ; 21: 235-242.

Watanabe N. , Tanzawa Y. and Ishikawa T. Interlaminar fracture toughness of 3-D orthogonal interlocked fabric composites . Compos Sci Technol 1999; 59: 1261-1270.

Massabo R. , Cox BN , Mumm DR , Turrettini A. and Kedward K. Delamination fracture in the presence of through-thickness reinforcement. Aust Compos Struct Soc 1997; I-159 and I-177.

Hoskote S. and Kim YK Fracture toughness of flock fiber-reinforced layered composites. Proceedings of 1 st International Simulation Conference, Valencia, Spain. 2003; 477-482.

Feng L. Fracture Toughness of Through Thickness Flock Fiber Reinforced Laminar Composites . MS Thesis from Mechanical Engineering, University of Massachusetts Dartmouth, September 2006.

Wang Y. and Zhao D. Effect of fabric structures on the mechanical properties of 3-D textile composites . J Ind Text 2006; 35: 239-256.

10.

Gillespie Jr JW and Carlsson IA Interlaminar fracture of laminated composite materials. Delaware Composites Design Encyclopedia Vol. 6. Lancaster, PA, USA: Technomic Publishing Co, 1990.