Improvement of the creep resistance of glycidyl azide polyol energetic thermoplastic elastomer-based propellant by nitrocellulose filler and its mechanism

Abstract

To investigate the effects of nitrocellulose (NC) content on the creep properties of glycidyl azide polyol energetic thermoplastic elastomer (GAP-ETPE)-based propellant, creep behaviour was studied by rotary rheometer under various shear stress and temperatures. Experimental results showed that creep strain and creep rate of samples increase with the increasing shear stress level, and similar creep behaviour tendency was observed under elevated temperature. When filled with 1 and 2 wt% NC, the creep strain and creep rate of GAP-ETPE/NC-based propellant were significantly less than the unfilled state, indicating that the NC contents partly inhibited the mobility of the binder segment and improved the creep resistance of GAP-ETPE-based propellant. Moreover, the constitutive equations of the creep curves were obtained from the four-element mechanical model, and the fitting results coincided well with the experimental data. Among the fitting parameters, the elastic modulus of high elastic deformation, E ₂, and the viscosity of Voigt units, η ₂, were sensitive and promising for the evaluation of creep strain of the GAP-ETPE-based propellant. Finally, the creep resistance model was established and verified by Fourier transform infrared spectroscopy, glass temperature and physical crossing point density of GAP-ETPE/NC-based propellant. Upon analysis of the experimental data, we concluded that the creep resistance mechanism of GAP-ETPE/NC-based propellant came from NC altering the flow lines of the continuous phase and restricted chain mobility in the propellant, which improved the creep resistance.

Keywords

GAP-ETPE-based propellant NC creep constitutive equation creep model creep resistance mechanism

Get full access to this article

View all access options for this article.

References

Sikder

Reddy

. Review on energetic thermoplastic elastomers (ETPEs) for military science. Propell Explos Pyrot 2013; 38: 14–28.

Mulage

Patkar

Deuskar

. Studies on a novel thermoplastic polyurethane as a binder for extruded composite propellants. J Energ Mater 2007; 25: 233–245.

Miller

. Research on new energetic materials. J Mater Res Soc Symp Proc 1996; 418: 3–14.

Murphy

Ntozakhe

Murphy

. Characterization of poly(3,3-bisethoxymethyl oxetane) and poly (3,3-bisazidomethyl oxetane) and their block copolymers. J Appl Polym Sci 1989; 37: 267–281.

Diaz

Brousseau

Ampleman

. Polymer nanocomposites from energetic thermoplastic elastomers and Alex®. Propell Explos Pyrot 2003; 28: 210–215.

Wang

Zhang

Zhao

. Effect of nitrocellulose (NC) on morphology, rheological and mechanical properties of glycidyl azide polymer based energetic thermoplastic elastomer/NC blends. Polym Int 2017; 66: 705–711.

Wang

Zhang

. Effect of hard-segment content on rheological properties of glycidyl azide polyol-based energetic thermoplastic polyurethane elastomers. Polym Bull 2016; 73: 3095–3104.

You

Kang

Kweon

. Thermal decomposition kinetics of GAP ETPE/RDX-based solid propellant. Thermochim Acta 2012; 537: 51–56.

Guo

. Effect of varied proportion of GAP-ETPE/NC as binder on thermal decomposition behaviors, stability and mechanical properties of nitramine propellants. J Therm Anal and Calorim 2017; 130(2): 909–918.

10.

Ampleman

Brousseau

Thiboutot

. Evaluation of GIM as a greener insensitive melt-cast explosive. Int J Energ Mater Chem Propul 2012; 1: 59–87.

11.

Kawamoto

Diniz

Lourenço

. Synthesis and characterization of GAP/BAMO copolymers applied at high energetic composite propellants. J Aerosp Technol Manag 2010; 2: 307–322.

12.

Beaupré

Ampleman

Nicole

. Insensitive propellant formulations containing energetic thermoplastic elastomers. United States Patent 6508894, 2003.

13.

Zhang

Wang

. Synthesis and characterization of novel energetic thermoplastic elastomers based on glycidyl azide polymer (GAP) with bonding functions. Polym Bull 2015; 72: 1835–1847.

14.

Monteil

Deschamps

Ampleman

. Dissolution of a new explosive formulation containing TNT and HMX: Comparison with octol. J Hazard Mater 2010; 174: 281–288.

15.

Lin

Liu

Gong

. High-temperature creep properties of TATB-based polymer bonded explosives filled with multi-walled carbon nanotubes. RSC Advances 2015; 5: 21376.

16.

Yao

Chen

. Creep behavior of polyurethane nanocomposites with carbon nanotubes. Compos Part A-Appl Sc 2013; 50: 65–72.

17.

Zandiatashbar

Picu

Koratkar

. Control of epoxy creep using graphene. Small 2012; 8: 1676–1682.

18.

Tang

Wang

Gong

. Creep and recovery of polystyrene composites filled with graphene additives. Compos Sci Technol 2014; 91: 63–70.

19.

Lietz

Yang

Bosch

. Improvement of the mechanical properties and creep resistance of SBS block copolymers by nanoclay fillers. Macromol Mater Eng 2007; 292: 23–32.

20.

Zhao

Liu

(eds) Handbook of Energetic Materials and the Related Compounds. Beijing: National Defense Industry Press, 2011, pp. 423–435.

21.

Zheng

Zhou

. Preparation and performance of GAP-ETPE/NC polymer blends. Chin J Energ Mater 2016; 24: 331–335.

22.

Wang

Fan

Zhou

. Surface and interface properties of less smoke composite modified double-base propellant contain nitramine and aluminium. Chin J Expl Propell 2011; 34: 64–68.

23.

You

Noh

. Rheological and thermal properties of glycidyl azide polyol-based energetic thermoplastic polyurethane elastomers. Polym Int 2013; 62: 158–164.

24.

. Preparation and characterization of HMX/GAP-ETPE nanocomposites. Int Energ Mater Chem Propul 2016; 2: 131–140.

25.

Pisharath

Ang

. Synthesis and thermal decomposition of GAP-Poly(BAMO) copolymer. Polym Degrad Stabil 2007; 92: 1365–1377.

26.

Zhang

Zhou

. Research on creep characteristics of the double-base solid propellant. Adv Mater Res 2012; 591–563: 1062–1066.

27.

Sahu

Patra

Szpunar

. Experimental study and numerical modelling of creep and stress relaxation of dielectric elastomers. Strain 2015; 51: 43–54.

28.

Farfán

CLR

Pascual

FJB

Barragán

. Determination of creep compliance, recovery and Poisson’s ratio of elastomers by means of digital image correlation (DIC). Polym Test 2017; 59: 245–252.

29.

Rubin

Favier

Danieau

. Direct observation of contact on non transparent viscoelastic polymers surfaces: a new way to study creep and recovery. Prog Org Coat 2016; 99: 134–139.

30.

Catherine

Krystyn

JVV

. Contact creep compliance of viscoelastic materials via nanoindentation. J Mater Res 2006; 21: 1576–1589.

31.

Chailleux

Davies

. Modelling the non-linear viscoelastic and viscoplastic behaviour of aramid fibre yarns. Mech Time-depend Mat 2003; 3: 291–303.

32.

Teipel

Orter

BUF

. Rheological behavior of nitromethane gelled with nanoparticles. J Propul Power 2005; 21: 40–43.

33.

Rahimi

Peretz

Natan

. On shear rheology of gel propellants. Propell Explos Pyrot 2007; 32: 165–174.

34.

Siengchin

Jozsef

. Creep behavior of polystyrene/fluorohectorite micro- and nanocomposites. Macromol Rapid Comm 2006; 27: 2090–2094.

35.

Yang

Zhang

Schlarb

. On the characterization of tensile creeps resistance of polyamide 66 nanocomposites. Part II: modeling and prediction. Polymer 2006; 47: 6745–6758.

36.

Lee

Yang

Kim

. Creep behavior and manufacturing parameters of wood flour filled polypropylene composites. Compos Struct 2004; 65: 459–469.

37.

Jia

Peng

Gong

. Creep and recovery of polypropylene/carbon nanotube composites. Int J Plast 2011; 27: 1239–1251.

38.

Zhang

HD,

Chen

. (eds) Polymer Physics. Shang Hai: Fudan University Press, 2008, pp. 32–54.

39.

Pan

Luo

Tan

. Study on interaction between CL-20 and dendritic bonding agent. Chin Energ Mater 2004; 12: 199–202.

40.

Zuo

Xiao

Jia

. Preparation and characterization of polymer blends of NC and GAP-TPE. J Solid Rock Technol 2011; 34: 488–491.

41.

Hine

Leejarkpai

Khosravi

. Structure property relationships in linear and cross-linked poly(imidonorbornenes) prepared using ring opening metathesis polymerisation (ROMP). Polymer 2001; 42: 9413–9422.

42.

Garbaczyk

Grinberg

Nestle

. A novel approach to the determination of the crosslink density in rubber materials with the dipolar correlation effect in low magnetic fields. J Polym Sci Pol Phys 2001; 39: 2207–2216.