Two-phase flow widely exists in many industries. Understanding local characteristics of two-phase flow under different flow conditions in piping systems is important to design and optimize the industrial process for higher productivity and lower cost. Air–water two-phase flow experiments were conducted with a 16×16 conductivity wire-mesh sensor (WMS) in a horizontal pipe of a multiphase flow facility. The cross-sectional void fraction time series was analysed by the probability density function (PDF), which described the void fraction fluctuation at different flow conditions. The changes and causes of PDFs during a flow regime transition were analysed. The local structure and flow behaviour were characterized by the local flow spectrum energy analysis and the local void fraction distribution (horizontal, vertical and radial direction) analysis. Finally, three-dimensional transient flow fluctuation energy evolution and characteristic scale distribution based on wavelet analysis of air–water two-phase flow were presented, which revealed the structural features of each phase in two-phase flow.
AbdulahiAAzzopardiBJ (2014) Two-phase upward flow in a slightly deviated pipe. Journal of Fluids Engineering136: 51302.
2.
AbdulkadirMHernandez-PerezVLowndesIS. (2014) Detailed analysis of phase distributions in a vertical riser using wire mesh sensor (WMS). Experimental Thermal and Fluid Science59: 32–42.
3.
AssimaGPLarachiFSchleicherE. (2015) Capacitance wire mesh imaging of bubbly flows for offshore treatment applications. Flow Measurement and Instrumentation45: 298–307.
4.
BarneaDRoitbergEShemerL (2013) Spatial distribution of void fraction in the liquid slug in the whole range of pipe inclinations. International Journal of Multiphase Flow52: 92–101.
5.
CartellierAAchardJL (1991) Local phase detection probes in fluid/fluid two-phase flows. Review of Scientific Instruments62: 279.
6.
CarvalhoRDMVenturiniOJTanahashiEI. (2009) Application of the ultrasonic technique and high-speed filming for the study of the structure of air–water bubbly flows. Experimental Thermal and Fluid Science33: 1065–1086.
7.
Da SilvaMJHampelU (2013) Capacitance wire-mesh sensor applied for the visualization of three-phase gas–liquid–liquid flows. Flow Measurement and Instrumentation34: 113–117.
8.
Da SilvaMJDos SantosENHampelU. (2011) Phase fraction distribution measurement of oil–water flow using a capacitance wire-mesh sensor. Measurement Science and Technology22: 104020.
9.
Da SilvaMJSchleicherEHampelU (2007) Capacitance wire-mesh sensor for fast measurement of phase fraction distributions. Measurement Science and Technology18: 2245–2251.
10.
Da SilvaMJThieleSAbdulkareemL. (2010) High-resolution gas–oil two-phase flow visualization with a capacitance wire-mesh sensor. Flow Measurement and Instrumentation21: 191–197.
11.
DaubechiesI (1992) Ten Lectures on Wavelets. Philadelphia, PA: Society for Industrial and Applied Mathematics.
12.
FargeM (1992) Wavelet transforms and their applications to turbulence. Annual Review of Fluid Mechanics1: 395–457.
13.
FischerFHampelU (2010) Ultra fast electron beam X-ray computed tomography for two-phase flow measurement. Nuclear Engineering and Design240: 2254–2259.
14.
JeanmeureLFCDyakowskiTZimmermanWBJ. (2002) Direct flow-pattern identification using electrical capacitance tomography. Experimental Thermal and Fluid Science26: 763–773.
15.
JiaJWangMSchlabergHI. (2010) A novel tomographic sensing system for high electrically conductive multiphase flow measurement. Flow Measurement and Instrumentation21: 184–190.
16.
JohnsonID (1987) Method and apparatus for measuring water in crude oil. United States Patent, No. 4,644,263.
17.
KanaiTFuruyaMAraiT. (2012) Three-dimensional phasic velocity determination methods with wire-mesh sensor. International Journal of Multiphase Flow46: 75–86.
18.
KimSFuXYWangX. (2001) Study on interfacial structures in slug flows using a miniaturized four-sensor conductivity probe. Nuclear Engineering and Design204: 45–55.
19.
LeiJWangXYLiuQB. (2013) Dynamic reconstruction algorithm based on the split Bregman iteration for electrical capacitance tomography. Transactions of the Institute of Measurement and Control35: 476–490.
20.
LiuWLTanCDongF (2015) A wire-mesh sensor for air–water two-phase flow imaging. In: 2015 IEEE International Instrumentation and Measurement Technology Conference (I2MTC), Pisa, Italy, 11–14 May, pp. 364–369.
21.
MandhaneJMGregoryGAAzizK (1974) A flow pattern map for gas–liquid flow in horizontal pipes. International Journal of Multiphase Flow1: 537–553.
MurzynFMouazeDChaplinJR (2005) Optical fibre probe measurements of bubbly flow in hydraulic jumps. International Journal of Multiphase Flow31: 141–154.
24.
NyforsE (2000) Industrial microwave sensors – a review. Subsurface Sensing Technologies and Applications1: 23–43.
25.
OliveiraJLGPassosJCVerschaerenR. (2009) Mass flow rate measurements in gas–liquid flows by means of a venturi or orifice plate coupled to a void fraction sensor. Experimental Thermal and Fluid Science33: 253–260.
26.
PetritschGReineckeNMewesD (1997) Visualization of the phase distribution in two-phase slug flow by conductive tomography. In: 8th International Conference on Multiphase 97, Cannes, France, 18–20 June, pp. 409–417.
27.
PrasserHBeyerMCarlH. (2007) Evolution of the structure of a gas–liquid two-phase flow in a large vertical pipe. Nuclear Engineering and Design237: 1848–1861.
28.
PrasserHMBöttgerAZschauJ (1998) A new electrode-mesh tomograph for gas–liquid flows. Flow Measurement and Instrumentation9: 111–119.
29.
PrasserHMMisawaMTiseanuI (2005) Comparison between wire-mesh sensor and ultra-fast X-ray tomograph for an air–water flow in a vertical pipe. Flow Measurement and Instrumentation16: 73–83.
30.
PrasserHMScholzDZippeC (2001) Bubble size measurement using wire-mesh sensors. Flow Measurement and Instrumentation12: 299–312.
31.
PuchtlerTJWoolfAZhuT. (2015) Characterisation of air–water two-phase flow using a wire-mesh sensor. ACS Photonics2: 137–143.
32.
ReineckeNBoddemMPetritschG. (1996) Tomographisches Messen der relativen Phasenanteile in zweiphasigen Strömungen fluider Phasen. Chemie Ingenieur Technik68: 1404–1412.
33.
ReineckeNPetritschGBoddemM. (1998) Tomographic imaging of the phase distribution in two-phase slug flow. International Journal of Multiphase Flow24: 617–634.
34.
RitterathMÖztürkOCPrasserHM (2011) Thermo-resistive mesh sensors (TMS) for temperature field measurements. Flow Measurement and Instrumentation22: 343–349.
35.
RodriguezIHYamagutiHKBde CastroMS. (2011) Slip ratio in dispersed viscous oil–water pipe flow. Experimental Thermal and Fluid Science35: 11–19.
36.
SantosENDVendruscoloTPMoralesREM. (2015) Dual-modality wire-mesh sensor for the visualization of three-phase flows. Measurement Science and Technology26: 105302.
37.
TanCZhaoJDongF (2015) Gas–water two-phase flow characterization with electrical resistance tomography and multivariate multiscale entropy analysis. ISA Transactions55: 241–249.
38.
ThornRJohansenGAHjertakerBT (2013) Three-phase flow measurement in the petroleum industry. Measurement Science & Technology24: 12003–12017.
39.
VieiraREKesanaNRMcLauryBS. (2014a) Experimental investigation of the effect of 90° standard elbow on horizontal gas–liquid stratified and annular flow characteristics using dual wire-mesh sensors. Experimental Thermal and Fluid Science59: 72–87.
40.
VieiraREKesanaNRTorresCF. (2014b) Experimental investigation of horizontal gas–liquid stratified and annular flow using wire-mesh sensor. Journal of Fluids Engineering, Transactions of the ASME136: 121301–121316.
41.
VieiraREParsiMTorresCF. (2015) Experimental characterization of vertical gas–liquid pipe flow for annular and liquid loading conditions using dual wire-mesh sensor. Experimental Thermal and Fluid Science64: 81–93.
42.
WangJZTianGYLucasGP (2007) Relationship between velocity profile and distribution of induced potential for an electromagnetic flow meter. Flow Measurement and Instrumentation18: 99–105.
43.
WangjiraniranWAritomiMKikuraH. (2005) A study of non-symmetric air water flow using wire mesh sensor. Experimental Thermal and Fluid Science29: 315–322.
44.
WangjiraniranWMotegiYRichterS. (2003) Intrusive effect of wire mesh tomography on gas–liquid flow measurement. Journal of Nuclear Science and Technology40: 932–940.
45.
WuZ (2015) Developing a microwave tomographic system for multiphase flow imaging: advances and challenges. Transactions of the Institute of Measurement and Control37: 760-768.
46.
ZhangZBieberleMBarthelF. (2013) Investigation of upward cocurrent gas–liquid pipe flow using ultrafast X-ray tomography and wire-mesh sensor. Flow Measurement and Instrumentation32: 111–118.
