Modelling and microcomputer control of a nonlinear pneumatic servomechanism

Abstract

A mathematical model is proposed for a low-pressure experimental pneumatic servomechanism which exhibits hysteresis characteristics at the torque motor and the servo spool valve assembly, nonlinear mass flow through the spool valve opening, and friction at piston and rod-end seals. Systems parameters are determined experimentally and correlated empirically. A single-board microcomputer is used for both servomechanism control and data acquisition purposes. The model predicts the experimental responses of three control algorithms with good accuracy. In particular, the response of PD with hysteresis compensation control shows no overshoot and minimal steady-state error when a step change of reference input is applied.

Get full access to this article

View all access options for this article.

References

Blackburn, J.F. , Reethof, G. and Shearer, J.L. 1960. Fluid power control, MIT Press , USA.

Bowns, D.E. , Ballard, R.L. and Stiles, L. 1973. The effect of seal friction on the dynamic performance of pneumatic actuators', Paper G3, 3rd Int Fluid Power Symposium, Turin, Italy.

Brann, R.P. 1966. 'Linear analysis of a pneumatic differential actuator with position feedback for prosthesis control Control (Aug) 428-430 and (Sept) 484-487.

Burger, P. and Ronchinsky, S. 1976. 'A microprocessor driven digital servo system', Proc IECI 77, Industrial Electronics and Control Instrumentation (March), 159-163.

Burrows, C.R. 1972. Fluid power servomechanisms, Van Nostrand Reinhold Co., London.

Cox, J.B. , Williams, L.J. , Banks, R.S. and Kirk, G.J. 1966. A practical spectrum of DDC chemical-process control algorithms ', ISA Journal, October, 65-72.

Harned, J.L. and Robertson, J. 1962. 'Low pressure pneumatic servos show promise for rapid power control', General Motors Eng J (First Quarter), 22-29.

Itkis, U. 1976. Control system of variable structure, John Wiley & Sons, Inc., New York, USA.

Jacob, D. and Donaghey, L.F. 1977. 'Microcomputer implementation of direct digital control algorithms for thermal process control applications', J Dyn Sys, Meas &Cont , Trans ASME, 99 (4), 232-240.

10.

Lang, C.M. 1967. 'Friction of flexible seals for hydraulic cylinders' , Maschinenmarkt, 73 (61), 1314-1322 (English translation edited by B.S. Nau , The British Hydromechanics Research Association , February 1968).

11.

McCloy, D. and Martin, H.R. 1973. The control of fluid power, 191-192, Longman , London.

12.

Sambrano, E. and Sipfle, R.E. 1976. 'Load simulation testing with electro-pneumatic servo systems', Paper No. 760315, presented at the SAE Automotive Engineering Congress and Exposition, Detroit, Michigan, USA.

13.

Sanville, F.E. 1971. 'A new method of specifying the flow capacity of pneumatic fluid power valves', Paper D3, 2nd Fluid Power Symposium, Guildford, England.