Effect of plasticity at out-of-plane electronic speckle pattern interferometry diagnostics of axisymmetric stresses by the hole-drilling method

Theoretical, calculated, and experimental results of studies on the registration of the accounting effect of plasticity in the diagnosis of axisymmetric stresses by the hole method and speckle-interferometric detection of the field of normal displacements in its vicinity are presented. Theoretical and computational studies were carried out on a disk model of finite thickness from an ideally elastic–plastic material. The theoretical model considers the formation of elastoplastic deformations in the vicinity of the through hole; the calculated finite element model considers in the vicinity of both through and blind holes of different depths. It was noted that at the blind hole, the most informative are the movements of the axisymmetric bend caused by the violation by the blind hole of symmetry of the disk with respect to its median plane. At the same time, an approximate analytical method has been developed to calculate the stresses that cause only elastic deformations. Experimental studies were carried out on a series of samples in the form of steel disks with axisymmetric stresses near the yield point. These stresses were induced by the hot fit of grinded rings from hardened high-strength steel onto disks made of steel with a low yield strength. Examples are given which show that the stress values determined from normal displacements in the vicinity of the probe holes from the calculated–theoretical and experimental are similar.