Assessment on Heat Release Rate of Furniture Foam Arrangement by a Cone Calorimeter

Abstract

Heat release rate of a typical furniture foam sofa was assessed with a cone calorimeter. The sofa arrangement included two layers of fabric, cotton and foam. Individual component materials and combination of them were tested. A high radiative heat flux of 50 kW m ² was used to consume all materials in the tests. The sustained ignition time, peak heat release rate and total heat release rate were deduced from the heat release rate curves. These data are useful for classifying the materials by calculating two parameters describing the possibility to flashover. The superposition of heat release rate curves and total heat released (THR) were studied. It is observed that adding the heat release rate curves for component materials would not give the heat release rate curve of a furniture arrangement with different combinations of materials. However, the THR for the components can be added to give the THR of the arrangement.

Keywords

heat release rate cone calorimeter flashover radiative heat flux

Get full access to this article

View all access options for this article.

References

South China Morning Post, (17 April 1997).

Sundström, B. (ed.) (1995). Fire Safety of Upholstered Furniture, The Final Report on the CBUF Research Programme (Report EUR 16477 EN). Directorate-General Science, Research and Development (Measurements and Testing), European Commission, Distributed by Interscience Communications Ltd., London.

Parker, W.J. (1997). Procedure for Predicting the Heat Release Rate of Furniture Composites from Measurements on their Components, 5th International Symp., pp. 129-140, Intl. Assoc. for Fire Safety Science, Boston, MA.

Krasny, J.F. , Parker, W.J. and Babrauskas, V. (2001). Fire Behavior of Upholstered Furniture and Mattresses, William Andrew Publishing, Norwich, NY.

Ogle, R.A. and Schumacher, J.L. (1998). Fire Patterns on Upholstered Furniture: Smoldering Versus Flaming Combustion, Fire Technology, 34(3): 247-265.

Chow, W.K. and Au Yeung, H.W. (2000). On the Combination of Heat Release Rates for Two Polymeric Materials, Fire and Materials, Submitted for consideration to publish.

Mowrer, F.W. and Williamson, R.B. (1990). Methods to Characterize Heat Release Rate Data, Fire Safety Journal, 16: 367-387.

Babrauskas, V. (1984). Upholstered Furniture Room Fires - Measurements, Comparison with Furniture Calorimeter Data, and Flashover Predictions, Journal of Fire Sciences, 2: 5-19.

Petrella, R.V. (1994). The Assessment of Full-Scale Fire Hazards from Cone Calorimeter Data, Journal of Fire Sciences, 12(1): 14-43.

10.

Thomas, P.H. (1981). Testing Products and Materials for their Contribution to Flashover in Rooms, Fire and Materials, 5: 103-111.

11.

Chow, W.K. and Au Yeung, H.W. (April 2002). Necessity of Testing Furniture Materials with a Cone Calorimeter, International Journal on Engineering Performance-Based Fire Codes, Accepted to publish.