Forced Forward Smoldering Propagation in Horizontally Oriented Flexible Polyurethane Foam

Abstract

A series of experiments was conducted in a small-scale wind tunnel to investigate the effect of forced flow on forward smoldering propagation in flexible polyurethane foam material located horizontally. In the wind tunnel, the air at a flow rate in the range of 0.01-1.5m/s passed over the foam layer surface. Foam samples of different lengths with the same cross-sectional area were studied. From the experimental results, it is seen that the foam length has no clear influence on the smolder propagation velocity. With an increase of air flow rate, firstly, the smolder propagation velocity increases and reaches a maximum at an air flow rate of around 0.8 m/s due to the increased mass transfer of oxygen into the smolder reaction region. It decreases with further increase of air flow rate as heat losses becomes dominant compared to the positive effect of the increase of oxygen transfer into the reaction zone. The variation of the steady smoldering temperature with the air flow rate follows the same trend as that of the smolder propagation velocity. In this paper, a simple analysis is also presented to analyze the co-effect of the mass transfer of oxygen to the smoldering reaction region and the heat loss to the surrounding on the smolder propagation under our current experimental conditions.

Keywords

flexible polyurethane foam forward smoldering propagation mass transfer smolder propagation velocity steady smoldering temperature

Get full access to this article

View all access options for this article.

References

Ohlemiller, T.J. (1985). Modeling of smoldering combustion propagation. Progress in Energy and Combustion Science, 11: 277-310.

Moussa, N.A. , Toong, T.Y. and Garris, C.A. (1976). Mechanism of smoldering of cellulosic materials. Sixteenth Symposium (International) on Combustion, The Combustion Institute. pp. 1447-1457.

Torero, J.L. , Fernandez-Pello, A.C. and Kitano, M. (1993). Opposed forced flow smoldering of polyurethane foam. Combustion Science and Technology, 91: 95-117.

http://www.pfa.org/ (1999). Flammability update: Flexible polyurethane foam industry strives to further reduce fire deaths and injuries. Polyurethane Foam Association: INTOUCH® Information on Flexible Polyurethane Foam.

Torero, J.L. , Fernandez-Pello, A.C. and Kitano, M. (1994). Downward smolder of polyurethane foam. In: Proceeding of the Fourth International Symposium on Fire Safety Science. pp. 409-420.

Torero, J.L. , Fernandez-Pello, A.C. and Urban, D. (1994). Experimental observations of the effect of gravity changes on smoldering combustion. AIAA Journal, 32: 991-996.

Torero, J.L. and Fernandez-Pello, A.C. (1995). Natural convection smolder of polyurethane foam, upward propagation. Fire Safety Journal, 24: 35-52.

Anthenien, R.A. , Walther, D. and Fernandez-Pello, A.C. (1995). An experimental study of smolder ignition of polyurethane foam. 1995Fall meeting, Western States Section/The Combustion Institute.

Torero, J.L. and Fernandez-Pello, A.C. (1996). Forward smolder of polyurethane foam in a forced air flow. Combustion and Flame, 106: 89-109.

10.

Walther, D.C. , Fernandez-Pello, A.C. and Urban, D.L. (1999). Space shuttle based microgravity smoldering combustion experiments. Combustion and Flame, 116: 398-414.

11.

Ortiz-Molina, M.G. , Toong, T.Y. , Moussa, N.A. and Tesoro, G.C. (1979). Smoldering combustion of flexible polyurethane foams and its transition to flaming or extinguishment. Seventeenth Symposium (International) on Combustion. pp. 1191-1200.

12.

Ohlemiller, T.J. (1990). Smoldering combustion propagation through a permeable horizontal fuel layer. Combustion and Flame, 81: 341-353.

13.

Ohlemiller, T.J. (1990). Forced smolder propagation and the transition to flaming in cellulosic insulation. Combustion and Flame, 81: 354-365.

14.

Chen, Y. , Kauffman, C.W. , Sichel, M. , Fangrat, J. , Gao, Y. (1990). The transition from smoldering to glowing to flaming combustion. Chemical and Physical Processes in Combustion, 68: 1-4.

15.

Leisch, S.O. (1983). Smoldering combustion in horizontal dust layers. PhD Dissertation, the University of Michigan, Ann Arbor, Michigan.

16.

Department of Consumer Affairs Bureau of Home Furnishing and Thermal Insulation, State of California, USA. California Technical Bulletin 117.

17.

Chao, C.Y.H. and Wang, J.H. (2001). Comparison of the thermal decomposition behavior of a non-fire retarded and a fire retarded flexible polyurethane foam with phosphorus and brominated additives. Journal of Fire Sciences, 19: 137-156.

18.

Wang, J.H. and Chao, C.Y.H. (2001). Smolder initiation of horizontally oriented flexible polyurethane foam under natural convection. 35th National Heat Transfer Conference. Anaheim, California. NHTC2001-20137.

19.

Chao, C.Y.H. and Wang, J.H. (2001). Transition from smoldering to flaming combustion of horizontally oriented flexible polyurethane foam with natural convection. Combustion and Flame, 127: 2252-2264.

20.

Tse, S.D. , Fernandez-Pello, A.C. and Miyasaka, K. (1996). Controlling mechanisms in the transition from smoldering to flaming of flexible polyurethane foam. 26th Symposium (International) on Combustion, The Combustion Institute, pp. 1505-1513.

21.

Tse, S.D. and F ernandez-Pello, A.C. (1995). Some observations of two-dimensional smoldering and the transition to flaming. Eighth International Symposium on Transport Phenomena in Combustion. Vol. 1, pp. 689-700.

22.

Di Blasi, C. (1995). Mechanisms of two-dimensional smoldering propagation through packed fuel beds. Combustion Science and Technology, 106: 103-124.

23.

Bird, R.B. , Stewart, W.E. and Lightfoot, E.N. (1960). Transport Phenomena. New York: John Wiley and Sons. pp. 647.

24.

Incropera, F.P. and DeWitt, D.P. (1981). Fundamentals of Heat Transfer. New York: John Wiley and Sons.

25.

Rogers, J.A. and Kaviany, M. (1990). Variation of heat and mass transfer coefficients during drying of granular beds. Journal of Heat Transfer, 112: 668-674.

26.

Morris, C.E. (1999). Moisture removal from a two-layer porous media: a conceptual model and experimental results. Transport in Porous Media, 36: 23-42.