The combined effect of hypervelocity space debris impact and atomic oxygen (AO) attack on the degradation of reinforced polyhedral oligomeric silsesquioxanes (POSS)-polyimide films was studied. A laser-driven flyer (LDF) system was used to accelerate aluminum flyers to impact velocities of up to 3 km s -1. The impacted films were exposed to an RF-plasma source, which was used to simulate the effect of AO in the low Earth orbit. Scanning electron microscopy (SEM) was used to characterize the fracture morphology. The extent of damage in POSS-polyimide impacted films was found to be much smaller compared to POSS-free films, insinuating on a toughening mechanism developed due to POSS incorporation. When exposed to air RF-plasma, the impacted POSS-free film revealed a synergistic effect associated with a large increase in the erosion rate while impacted POSS-containing samples showed improved erosion resistance. The increased erosion rate of the impacted POSS-free film is explained by formation of residual stresses that affect the oxidation mainly by increasing the diffusivity of oxygen.
Grossman, E. , Gouzman, I., Viel-Inguimbert , I. and Diguirard, M. (2003). Modification of a 5-eV atomic-oxygen laser detonation source. J. Spacecraft and Rockets, 40: 110.
2.
Houdayer, A. , Cerny, G., Klemberg-Sapieha , J.E., Czeremuszkin, G. and Wertheimer, M.R. (1997). MeV proton irradiations and atomic oxygen exposure of spacecraft materials with SiO2 protective coatings . Nucl. Instrum. Methods Phys. Res. B, 131: 335.
3.
Tennyson, R.C. and Shortliffe, G., (1997). MOD impact damage on composite materials in space In Proc. 7th Inter. Symp. Mater. in Space Env. ESA Publication, ESTEC Noordwijk , The Netherlands.
4.
Hastings, D. and Garrett, H. (1996). Spacecraft-Environment Interactions. Cambridge University Press, Cambridge, UK, p.45.
5.
Miao, J. and Stark, J.P.W. (2001). Direct simulation of meteoroids and space debris flux on LDEF spacecraft surfaces. Planetary and Space Sci. , 49: 927.
6.
Silverman, E.M. (1995). Space Environmental Effects on Spacecraft - LEO Material Selection Guide, NASA Contractor Report No. 4661. Langley Research Center , p. 1-4.
7.
Stein, C., Roybal, R. and Tlomak, P. (2000). The production of contamination on spacecraft surfaces by hypervelocity debris impacts. In Proc. 8th Inter. Symp. Mater. in Space Env. CNES Publication , Toulouse, France.
8.
Medina, D.F. , Wright, L. and Campbell, M. (2001). Parametric investigation of solar panel hypervelocity impact damage. Adv. Space Res. , 28: 1347.
9.
Rutledgs, S.K. and Olle, R.M. (1993). Space station freedom solar array blanket coverlay atomic oxygen durability testing results . In Proc. 38th Inter. Symp. SAMPE Symposium. Anheim, California, USA.
10.
Brunsvold, A.L., Minton, T.K., Gouzman , I., Grossman, E. and Gonzales, R. (2004). An investigation of the resistance of polyhedral oligomeric silsesquioxane polyimide to atomic-oxygen attack. High Performance Polymers , 16: 303.
Gonzales, R.I. (2002). Synthesis and In-Situ Atomic Oxygen Erosion Studies of Space Survivable Hybrid Organic/Inorganic Polyhedral Oligomeric Silsesquioxane Polymers. Ph.D. Thesis, University of Florida, USA.
13.
Philips, S.H., Haddad, T.S. and Tomczak, S.J. (2004). Developments in nanoscience: polyhedral oligomeric silsesquioxane (POSS)-polymers . Current Opinion in Solid State and Materials Science, 8: 21.
14.
Lichtenhan, J. (2006). Private Communication .
15.
Fu, B.X. (2005). Private Communication.
16.
Tighe, A., Gabriel, S. and Van Eesbeek, M. (2000). Ground based simulation of orbital debris using laser driven flyer plates. In Proc. 8th Inter. Symp. Mater in Space EnvCNES Publication, Toulouse, France.
17.
Roybal, R. , Tlomak, P., Stein , C. and Stokes, H. (1999). Simulated space debris impact experiments on toughened laminated thin solar cell cover glass. Inter . J. Impact Eng., 23: 811.
18.
Eliezer, S. (2002). The Interaction of High-Power Lasers with Plasmas . Institute of Physics, Bristol , UK.
19.
Gouzman, I., Grossman, E., Lempert , G., Noter, Y., Lifshitz, Y., Viel-Inguimbert , V. and Dinguirard, M. (2004). Atomic-oxygen durability of a silicone paint: comparison between two simulation methods. J. Spacecraft and Rockets, 41: 350.
20.
Intrater, R., Lempert, G., Gouzman , I., Grossman, E., Cohen, Y., Rein, D.M., Khakfin, R.L. and Hoffman, A. (2004). Simulated low Earth orbit environment interaction with different types of polyethylene. High Performance Polymers, 16: 249.
21.
Astm E-2089-00. (2002 ). Standard practices for ground laboratory atomic oxygen interaction evaluation of materials for space applications. In: Annual book of ASTM standards, vol. 15.03. West Conshohocken, PA, USA: ASTM International, p. 752.
Du-Pont. Inc. (1993). Technical Bulletin, PYRALIN® Polyimide Coating PI 2545 PI 2540 Product Information .
24.
Verker, R., Eliaz, N., Gouzman, I., Eliezer, S., Fraenkel, M., Maman, S., Beckmann, F., Pranzas, K. and Grossman, E. (2004). The effect of simulated hypervelocity space debris on polymers. Acta Materialia, 52: 5539.
25.
Verker, R., Grossman, E., Gouzman, I., Laikhtman, A., Katz, S., Freankel, M., Maman, S., Lempert, G. and Eliaz, N. (2006). Mechanical and morphological behavior of POSS-polyimide films under hypervelocity impacts and atomic oxygen exposure. Soreq NRC Report No. 3689.
26.
Verker, R., Grossman, E., Gouzman, I. and Eliaz, N. (2007). Residual Stress Effect on Degradation of Polyimide under Simulated Hypervelocity Space Debris and Atomic Oxygen. Polymer, 48: 19.
27.
Klopffer, M.H. and Flaconnèche, B. (2001). Transport properties of gases in polymers: bibliographic review. Oil & Gas Science and Technology - Rev. IFP, 56: 223.
28.
Larche, F.C. and Cahn, W.J. (1982). The Effect of Self-Stress on Diffusion in Solids . Acta Metall., 30: 1835.
29.
Oriani, R.A. (1969). Hydrogen in metals. In Proc. of the conference on fundamental aspects of stress corrosion cracking , National Association of Corrosion Engineers, Houston, Texas.
30.
Eliaz, N. and Banks-Sills, L. (2008). Chemical potential, diffusion and stress - common confusions in nomenclature and units. Corrosion Reviews, 26(2-3): 87-103.
31.
Tyler, D.R. (2004). Mechanistic aspects of the effects of stress on the rates of photochemical degradation reactions in polymers. Journal of Macromolecular Science, 44: 351.
32.
O'Donnell, J.B. and White, J.R. (1994). Photo-oxidation of polystyrene under load. Journal of Materials Science, 29: 3955.
33.
Whitaker, A.F. and Jang, B.Z. (1993). The mass loss mechanism of polymers in a radio frequency induced atomic oxygen environment . Journal of Applied Polymer Science, 48: 1341.
34.
Klein, R. and Scheer, M.D. (1968). Mechanism of O(3P) Addition to Condensed Films. II. Propene, 1-Butene, and Their Mixtures . The Journal of Physical Chemistry, 72: 616.
35.
Grossman, E., Gouzman, I., Lempert , G., Noter, Y. and Lifshitz, Y. (2004). Assessment of Atomic Oxygen flux in LEO ground simulation facilities. Journal of Spacecraft and Rockets41: 356.
