Epoxy matrix toughness improvement via reactive bio-resin alloying

Abstract

A facile solvent-less approach to toughen epoxy thermosets by means of a bio-based resin, that is, poly(furfuryl alcohol) (PFA; furan resin) is reported. The bio-resin PFA was firstly synthesized through polycondensation reaction of furfuryl alcohol as a bio-monomer and maleic anhydride as a catalyst. Different amounts of PFA were blended with diglycidyl ether of bisphenol A epoxy resin and cured by diethylenetriamine as a hardener, which simultaneously cross-linked both of the epoxy and PFA resins. The curing process was studied by Furrier transform infrared spectroscopy and differential scanning calorimetry. Scanning electron microscopy of the chemically cured blends revealed no phase separation. It was found remarkable increase in flexural modulus and strength of the neat and modified epoxies with increasing PFA content up to around 15%. Moreover, in comparison with neat epoxy, the epoxy-PFA thermosets showed 60% increase in critical stress intensity factor and 123% increase in critical strain energy release rate. In fact, chemical reaction of PFA-incorporated epoxy could toughen the epoxy matrix without sacrificing the flexural strength and modulus. Toughening was obtained through cross-link density reduction. As exhibited by dynamic mechanical thermal analysis, Tan δ and magnitude of β-relaxation were also increased for the epoxy-PFA alloys. Overall, this green, simple, concise and cost-effective approach was suggested for being considered to produce toughened epoxy thermosets in industrial scale.

Keywords

Epoxy resin poly(furfuryl alcohol) bio-resin toughness mechanical properties

Get full access to this article

View all access options for this article.

References

Chen

Fan

. Exploring the application of sustainable poly(propylene carbonate) copolymer in toughening epoxy thermosets. ACS Sustain Chem Eng 2015; 3: 2077–2083.

Naguib

Sangermano

Capozzi

. Non-reactive and reactive block copolymers for toughening of UV-cured epoxy coating. Prog Org Coat 2015; 85: 178–188.

Parameswaran Pillai

Pionteck

Häßler

. Effect of cure conditions on the generated morphology and viscoelastic properties of a poly(acrylonitrile–butadiene–styrene) modified epoxy–amine system. Ind Eng Chem Res 2012; 51: 2586–2595.

Feng

Wang

. Fabrication of spirocyclic phosphazene epoxy-based nanocomposites with graphene via exfoliation of graphite platelets and thermal curing for enhancement of mechanical and conductive properties. Ind Eng Chem Res 2013; 52: 10160–10171.

Fan

Zhang

. Curing kinetics and shape-memory behavior of an intrinsically toughened epoxy resin system. J Therm Anal Calorim 2015; 119: 537–546.

Sahoo

Mohanty

Nayak

. Toughened bio-based epoxy blend network modified with transesterified epoxidized soybean oil: synthesis and characterization. RSC Adv 2015; 5: 13674–13691.

Ratna

Handbook of thermoset resins. Shawbury, Shrewsbury: iSmithers, 2009.

Levita

De Petris

Marchetti

. Crosslink density and fracture toughness of epoxy resins. J Mater Sci 1991; 26: 2348–2352.

Kong

Tang

Zhang

. Synergic effect of acrylate liquid rubber and bisphenol A on toughness of epoxy resins. Polym Bull 2008; 60: 229–236.

10.

Cardwell

Yee

. Rate and temperature effects on the fracture toughness of a rubber-modified epoxy. Polymer 1993; 34: 1695–1701.

11.

Domun

Hadavinia

Zhang

. Improving the fracture toughness and the strength of epoxy using nanomaterials – a review of the current status. Nanoscale 2015; 7: 10294–10329.

12.

Pearson

Yee

. Toughening mechanisms in thermoplastic-modified epoxies: 1. Modification using poly(phenylene oxide). Polymer 1993; 34: 3658–3670.

13.

Liu

Zhou

Goh

HLS

. From waste to functional additive: toughening epoxy resin with lignin. ACS Appl Mater Interfaces 2014; 6: 5810–5817

14.

McCarron

A synergistic approach to modeling crack propagation in nanoreinforced polymer composites 2008. Amherst: University of Massachusetts.

15.

Auvergne

Caillol

David

. Biobased thermosetting epoxy: present and future. Chem Rev 2013; 114: 1082–1115.

16.

Ünver

Öktem

. Controlled cationic polymerization of furfuryl alcohol. Eur Polym J 2013; 49: 1023–1030.

17.

Nagaraja

Kumar

Shasikala

. A highly efficient Cu/MgO catalyst for vapour phase hydrogenation of furfural to furfuryl alcohol. Catal Commun 2003; 4: 287–293.

18.

J-M

Guigo

Mija

. Valorization of biorefinery side-stream products: combination of humins with polyfurfuryl alcohol for composite elaboration. ACS Sustain Chem Eng 2014; 2: 2182–2190.

19.

Sari

Ramezanzadeh

Shahbazi

. Influence of nanoclay particles modification by polyester-amide hyperbranched polymer on the corrosion protective performance of the epoxy nanocomposite. Corros Sci 2015; 92: 162–172.

20.

Conley

Metil

. A study of the oxidative degradation of furfuryl alcohol polycondensates by infrared spectroscopy. J Appl Polym Sci 1963; 7: 1083–1091.

21.

Conley

Metil

. An investigation of the structure of furfuryl alcohol polycondensates with infrared spectroscopy. J Appl Polym Sci 1963; 7: 37–52.

22.

Hayaty

Honarkar

Beheshty

. Curing behavior of dicyandiamide/epoxy resin system using different accelerators. Iran Polym J 2013; 22: 591–598.

23.

Karayannidou

Achilias

Sideridou

. Cure kinetics of epoxy–amine resins used in the restoration of works of art from glass or ceramic. Eur Polym J 2006; 42: 3311–3323.

24.

Bobrowski

Grabowska

. The impact of temperature on furan resin and binders structure. Metall Foundry Eng 2012; 38: 73–80.

25.

Deka

Misra

Mohanty

. Renewable resource based “all green composites” from kenaf biofiber and poly (furfuryl alcohol) bioresin. Ind Crops Prod 2013; 41: 94–101.

26.

Choura

Belgacem

Gandini

. Acid-catalyzed polycondensation of furfuryl alcohol: mechanisms of chromophore formation and cross-linking. Macromolecules 1996; 29: 3839–3850.

27.

De Vergara

Sarrionandia

Gondra

. Polymerization and curing kinetics of furan resins under conventional and microwave heating. Thermochim Acta 2014; 581: 92–99.

28.

Maciel

Chuang

I-S

Myers

. Carbon-13 NMR study of cured furfuryl alcohol resins using cross polarization and magic-angle spinning. Macromolecules 1982; 15: 1218–1220.

29.

Veisi

Azadbakht

Ezadifar

. An efficient and green procedure for synthesis of pyrrole derivatives by paal–knorr condensation using sodium dodecyl sulfate in aqueous micellar. J Heterocyclic Chem 2013; 50: E241.

30.

Chen

J-X

Liu

M-C

Yang

X-L

. Indium (III)-catalyzed synthesis of N-substituted pyrroles under solvent-free conditions. J Braz Chem Soc 2008; 19: 877–883.

31.

Banik

Samajdar

Banik

. Simple synthesis of substituted pyrroles. J Org Chem 2014; 69: 213–216.

32.

Zhao

Abu-Omar

. Biobased epoxy nanocomposites derived from lignin-based monomers. Biomacromolecules 2015; 16: 2025–2031.

33.

Guo

Peng

. Toughening epoxy thermosets with block ionomer complexes: a nanostructure–mechanical property correlation. Macromolecules 2012; 45: 3829–3840.

34.

Thomas

Yumei

Yuelong

. Miscibility, morphology, thermal, and mechanical properties of a DGEBA based epoxy resin toughened with a liquid rubber. Polymer 2008; 49: 278–294.

35.

Menard

. Dynamic mechanical analysis: a practical introduction. New York: CRC press 2008, pp. 91–121.

36.

El Homrany

Maaroufi

Benavente

. Improvement of mechanical performance of epoxy resins filled with cobalt and chromium powders. J Appl Polym Sci 2010; 118: 3701–3706.

37.

Koleske

JV.

Paint and coating testing manual, the Gardner-Sward handbook; Paint Testing Manual. 14th ed. Philadelphia: Wiley, 1995, pp. 534–547.

38.

Kyritsis

Vikelis

Maroulas

. Polymer dynamics in epoxy/alumina nanocomposites studied by various techniques. J Appl Polym Sci 2011; 121: 3613–3627.

39.

Oishi

Rezende

Origo

. Viscosity, pH, and moisture effect in the porosity of poly (furfuryl alcohol). J Appl Polym Sci 2013; 128: 1680–1686.

40.

Principe

Ortiz

Martínez

. An NMR study of poly(furfuryl alcohol) prepared with p-toluenesulphonic acid. Polym Int 1999; 48: 637–641.

41.

Kalakkunnath

. Viscoelastic relaxation characteristics of rubbery polymer networks and engineering polyesters, PhD Dessertation, University of Kentucky, USA, 2007.

42.

Campbell

Goodwin

Simon

. Dielectric relaxation studies of miscible polycarbonate/polyester blends. Polymer 2001; 42: 4731–4741.

43.

Musto

Ragosta

Abbate

. Photo-oxidation of high performance epoxy networks: correlation between the molecular mechanisms of degradation and the viscoelastic and mechanical response. Macromolecules 2008; 41: 5729–5743.

44.

Lach

Grellmann

. Time-and temperature-dependent fracture mechanics of polymers: general aspects at monotonic quasi-static and impact loading conditions. Macromol Mater Eng 2008; 293: 555–567.

45.

Fernández-García

de la Fuente

Cerrada

. Preparation of poly (tert-butyl acrylate-g-styrene) as precursors of amphiphilic graft copolymers. 1. Kinetic study and thermal properties. Polymer 2002; 43: 3173–3179.

46.

Thomas

Sinturel

Pionteck

. In-situ cure and cure kinetic analysis of a liquid rubber modified epoxy resin. Ind Eng Chem Res 2012; 51: 12178–12191.

47.

Shukla

Srivastava

. Blends of modified epoxy resin and carboxyl-terminated polybutadiene. I. J Appl Polym Sci 2006; 100: 1802–1808.

48.

Yang

S-Y

Yang

J-P

. Preparation and mechanical properties of modified epoxy resins with flexible diamines. Polymer 2007; 48: 302–310.

49.

Xiao

. Enhancing the thermal and mechanical properties of epoxy resins by addition of a hyperbranched aromatic polyamide grown on microcrystalline cellulose fibers. RSC Adv 2014; 4: 14928–14935.

50.

Dadfar

Ghadami

. Effect of rubber modification on fracture toughness properties of glass reinforced hot cured epoxy composites. Mater Des 2013; 47: 16–20.

51.

Sherman

Zeigler

Verghese

. Structure–property relationships of controlled epoxy networks with quantified levels of excess epoxy etherification. Polymer 2008; 49: 1164–1172.

52.

Zhou

Liang

. Tough silica-hybridized epoxy resin/anhydride system with good corona resistance and thermal stability for permanent magnet synchronous wind-driven generators through vacuum pressure impregnation. Ind Eng Chem Res 2015; 54: 7102–7112.

53.

Mathew

Sinturel

George

. Epoxy resin/liquid natural rubber system: secondary phase separation and its impact on mechanical properties. J Mater Sci 2010; 45: 1769–1781.

54.

Boesl

Fracture toughening mechanisms in nanoparticle and micro-particle reinforced epoxy systems using multi-scale analysis. PhD Dessertation, University of Florida, USA

55.

Builes

Hernandez

Mondragon

. Relationship between the morphology of nanostructured unsaturated polyesters modified with PEO-b-PPO-b-PEO triblock copolymer and their optical and mechanical properties. J Phys Chem C 2013; 117: 3563–3571.