On the stabilising effect of gyroscopic moments in an automotive turbocharger

Abstract

Automotive turbochargers, which operate at very high speeds, exceeding 180,000 r/min, exhibit two strong sub-harmonic modes of vibrations due to oil-whirl instability. These are a conical mode and an in-phase whirl mode. The gyroscopic effects can be very important in such a rotor system. This article presents a theoretical investigation into these effects on the conical whirl instability of a turbocharger induced by the angular (tilting) motion of a rigid rotor. A simplified linear model is used to analyse the rotor-bearing system by investigating the effects of the gyroscopic moment on the internal moments. A gyroscopic coefficient, defined by the geometry of the rotor, is shown to govern the stability of the conical whirl motion. A threshold value of ½ is determined for this coefficient to suppress the conical whirl. This value remains unaffected if the rotor is asymmetric and is supported by floating ring bearings, which is the case in a practical turbocharger.

Keywords

Gyroscopic effect linear analysis turbocharger conical whirl instability

Get full access to this article

View all access options for this article.

References

Kirk

Alsaeed

Liptrap

Lindsey

Sutherland

Dillon

. Experimental test results for vibration of a high speed diesel engine turbocharger. Tribol Trans 2008; 51(4): 422–427.

Holmes R. Turbocharger vibration - a case study. In: Proceedings of the institution of mechanical engineers, seventh international conference on turbochargers and turbocharging, Savoy Palace, London, UK, 14–15 May 2002, pp.91–100. London: Institution of Mechanical Engineers.

The death of whirl and whip - Use of externally pressurized bearings and seals for control of whirl and whip instability. ORBIT, Fourth Quarter, 2001.

Holt

San Andres

Sahay

Tang

La Rue

Gjika

. Test response and nonlinear analysis of a turbocharger supported on floating ring bearings. J Vib Acoust 2005; 127: 107–115.

Alsaeed A. Dynamic stability evaluation of an automotive turbocharger rotor-bearing system. Master’s Thesis, Mechanical Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA 2005.

Gunter

Chen

. Dynamics of rotor-bearing systems. Charlottesville, VA: RODYN Vibration Analysis Inc., 2003.

Gunter EJ and Chen WJ. Dynamic analysis of a turbocharger in floating bushing bearings. In: Proceedings of the third international symposium on stability control of rotating machinery (ISCORMA-3), Cleveland, OH, 19–23 September 2005. New York, NY: Hindawi Publishing Corporation.

San Andrés

Kerth

. Thermal effects on the performance of floating ring bearings for turbochargers. Proc IMechE Part J: J Engineering Tribology 2004; 218(5): 437–450.

Holmes R, Brennan MJ and Gottrand B. Vibration of an automotive turbocharger- a case study. In: Proceedings of the eighth international conference on Vibrations in Rotating Machinery (VIRM-8), Swansea, UK, 7–9 September 2004, pp.445–450. New York, NY: Wiley.

10.

Tondl A. Some problems of self-excited vibration of rotors. Monographs and memoranda of the National Research Institute for Machine Design. Monograph no. 17, 1974. Bechovice, Czech Republic: National Research Institute for Machine Design.

11.

Holmes

. Oil-whirl characteristics of a rigid rotor in 360° journal bearings. Proc Inst Mech Eng 1963; 177(11): 291–299.