Tunable yo-yo energy harvester with oblique springs

Abstract

In this study, a yo-yo vibrational energy harvesting device that can adjust its resonant frequency to the desired excitation frequency using geometrical control is proposed and investigated. The device employs a spring system, suspended proof mass, and set of reels and gears to convert translational input into rotational motion to power its generator. The spring system is composed of two symmetrical oblique springs, and its stiffness and the resonant frequency of the proposed harvester varies with the oblique angle between these springs. The characteristics of the oblique spring system are investigated accordingly, and it is shown that there exists a lower limit of stiffness; therefore, the achievable frequency bandwidth of the harvester can be determined. The method used to design the proposed tunable energy harvester so that it satisfies the desired frequency bandwidth is then provided. A prototype of the device was built and tested on a vibration table, and its performance is illustrated via a comparison with the results of numerical calculations. The results indicate that the proposed device is capable of harnessing the kinetic energy of the ocean waves.

Keywords

Rotational energy harvesting oblique spring system active tuning wide bandwidth energy harvester resonant frequency low frequency

Get full access to this article

View all access options for this article.

References

Jung

H-J

Kim

I-H

Jang

S-J

. An energy harvesting system using the wind-induced vibration of a stay cable for powering a wireless sensor node. Smart Mater Struct 2011; 20: 075001.

Kim

I-H

Jin

Jang

S-J

, et al. A performance-enhanced energy harvester for low frequency vibration utilizing a corrugated cantilevered beam. Smart Mater Struct 2014; 23: 037002.

Zhu

Tudor

Beeby

. Strategies for increasing the operating frequency range of vibration energy harvester: a review. Meas Sci Technol 2008; 21: 022001.

Shahruz

. Design of mechanical band-pass filters with large frequency bands for energy scavenging. Mechatronics 2006; 16: 523–531.

Ferrari

Guizzetti

, et al. Piezoelectric multifrequency energy converter for power harvesting in autonomous microsystems. Sens Actuat A 2008; 142: 329–335.

Wong ZJ, Yan J, Soga K, et al. A multi-degree-of-freedom electrostatic MEMS power harvester. In: Power micro electro mechanical systems, Washington, DC, 1–4 December 2009, pp.300–303.

Marin

Turner

, et al. Broadband electromagnetic vibration energy harvesting system for powering wireless sensor nodes. Smart Mater Struct 2013; 22: 075008.

Tang

Yang

, et al. Development of a broadband nonlinear two degree-of-freedom piezoelectric energy harvester. J Intell Mater Syst Struct 2014; 25: 1875–1889.

Zhang

Wang

Zhang

, et al. Electrostatic energy harvesting device with dual resonant structure for wideband random vibration sources at low frequency. Rev Scient Instrum 2016; 87: 125001.

10.

O'Donohue

Frizzell

Punch

. Scaling and characterisation of a 2-DoF velocity amplified electromagnetic vibration energy harvester. Smart Mater Struct 2018; 27: 075019.

11.

Ramlan

Brennan

Mace

, et al. Potential benefits of a non-linear stiffness in an energy harvesting device. Nonlin Dyn 2009; 59: 545–558.

12.

Cottone

Vocca

Gammaitoni

. Nonlinear energy harvesting. Phys Rev Lett 2009; 102: 080601.

13.

Tang

Yang

. A nonlinear piezoelectric energy harvester with magnetic oscillator. Appl Phys Lett 2012; 101: 094102.

14.

Nico

Boco

Frizzell

, et al. A high figure of merit vibrational energy harvester for low frequency applications. Appl Phys Lett 2016; 108: 013902.

15.

Wang

Tang

. Modeling and experiment of bistable two-degree-of-freedom energy harvester with magnetic coupling. Mech Syst Signal Process 2017; 86: 29–39.

16.

Jang

S-J

Rustighi

Brennan

, et al. Design of a 2dof vibrational energy harvesting device. J Intell Mater Syst Struct 2010; 22: 443–448.

17.

Kim

I-H

Jung

H-J

Lee

, et al. Broadband energy-harvesting using a two degree-of-freedom vibration body. Appl Phys Lett 2011; 98: 214102.

18.

Zhou

Penamalli

Zuo

. An efficient vibration energy harvester with a multi-mode dynamic magnifier. Smart Mater Struct 2011; 21: 015014.

19.

Park

S-B

Jang

S-J

Kim

I-H

, et al. Broadband vibration energy harvester utilizing three out-of-plane modes of one vibrating body. Smart Mater Struct 2017; 26: 105049.

20.

Gieras JF, Oh JH, Huzmezan M, et al. Electromechanical energy harvesting system. Patent Publication Number: WO2007070022(A2), WO2007070022(A3), 2007.

21.

Wu X, Lin J, Kato S, et al. A frequency adjustable vibration energy harvester. In: Proceedings of PowerMEMS 2008 + microEMS 2008, 9–12 November 2008, Sendai, Japan, pp.245–248.

22.

Challa

Prasad

Shi

, et al. A vibration energy harvesting device with bidirectional resonance frequency tunability. Smart Mater Struct 2008; 17: 015035.

23.

Zhu

Roberts

Tudor

, et al. Design and experimental characteristic of a tunable vibration-based electromagnetic micro-generator. Sens Actuat A 2010; 158: 284–293.

24.

Leland

Wright

. Resonance tuning of piezoelectric vibration energy scavenging generators using compressive axial preload. Smart Mater Struct 2006; 15: 1413–1420.

25.

Charnegie D. Frequency tuning concepts for piezoelectric cantilever beams and plates for energy harvesting. MSc Dissertation, University of Pittsburgh, USA, 2007.

26.

Jang

Kim

Jung

, et al. A tunable rotational energy harvester for low frequency vibration. Appl Phys Lett 2011; 99: 134102.

27.

Jang

Kim

Park

, et al. An enhanced tunable rotational energy harvester with variable stiffness system for low-frequency vibration. Proc IMechE, Part C: J Mechanical Engineering Science 2016; 230: 732–736.

28.

Harris

. Shock and vibration handbook, 4th ed. New York: McGraw-Hill, 1997.

29.

Elvin

Erturk

. Advances in energy harvesting methods, New York: Springer Science and Business Media, 2013.