Thermal modelling of modern diesel engines: proposal of a new heat transfer coefficient correlation

Abstract

Existing methods for predicting heat fluxes and temperatures in internal combustion engines, which take the form of correlations to estimate the heat transfer coefficient on the gas-side of the combustion chamber, are based on methodology developed over the past 50 years, often updated in view of more recent experimental data. The application of these methods to modern diesels engines is questionable because key technologies found in current engines did not exist or were not widely used when those methods were developed. Examples of such technologies include: high-pressure common rail and variable fuel injection strategies including retarded injection for nitrogen oxides emission control; exhaust gas re-circulation; high levels of intake boost pressure provided by a single- or double-stage turbocharger and inter-cooling; multiple valves per cylinder and lower swirl; and advanced engine management systems. This suggests a need for improved predicting tools of thermal conditions, specifically temperature and heat flux profiles in the engine block and cylinder head. In this paper a modified correlation to predict the gas-side heat transfer coefficient in diesel engines is presented. The equation proposed is a simple relationship between Nu and Re calibrated to predict the instantaneous spatially averaged heat transfer coefficient at several operating conditions using air as gas in the model. It was derived from the analysis of experimental data obtained in a modern diesel engine and is supported by a research methodology comprising the application of thermodynamic principles and fundamental equations of heat transfer. The results showed that the new correlation adequately predicted the instantaneous coefficient throughout the operating cycle of a high-speed diesel engine. It also estimated the corresponding cycle-averaged heat transfer coefficient within 10 per cent of the experimental value for the operating conditions considered in the analysis.

Keywords

heat transfer coefficient heat flux in-cylinder heat transfer models diesel engine

Get full access to this article

View all access options for this article.

References

Finol

C. A.

Robinson

Thermal modelling of modern engines: a review of empirical correlations to estimate the in-cylinder heat transfer coefficient. Proc. IMechE, Part D: J. Automobile Engineering, 2006, 220(12), 1765–1781.

Finol

Heat transfer investigations in a modern diesel engine. PhD Thesis. University of Bath, 2008.

Finol

C. A.

Robinson

Thermal profile of a modern passenger car diesel engine. SAE paper 2006-01-3409, 2006.

Eichelberg

Some investigations on old combustion-engine problems. Engineering, 1939, 148(I, II), 463–466, 547–550.

Annand

W. J. D.

Heat transfer in the cylinders of reciprocating internal combustion engines. Proc. Instn Mech. Engrs, 1963, 177(36), 973–990.

Woschni

A universally applicable equation for the instantaneous heat transfer coefficient in the internal combustion engine. SAE paper 670931, 1967.

Sitkei

Ramanaiah

G. V.

A rational approach for calculation of heat transfer in diesel engines. SAE paper 720027, 1972.

Hohenberg

G. F.

Advanced approaches for heat transfer calculation. SAE paper 790825, 1979.

Han

B. S.

Chung

Y. J.

Kwon

Y. J.

Lee

Empirical formula for instantaneous heat transfer coefficient in spark ignition engines. SAE paper 972995, 1997.

10.

Stone

Introduction to internal combustion engines, third edition, 1999 (Macmillan Press).

11.

Heywood

J. B.

Internal combustion engine fundamentals, 1988 (McGraw-Hill International Editions).

12.

Incropera

F. P.

DeWitt

D. P.

Bergman

T. L.

Lavine

A. S.

Fundamentals of heat and mass transfer, sixth edition, 2007 (Wiley, New York).

13.

Watson

Janota

M. S.

Turbo charging the internal combustion engine, 1982 (Macmillan Education).

14.

Schubert

Wimmer

Chmela

Advanced heat transfer model for CI engines. SAE paper 2005-01-0696, 2005.

15.

Chang

Güralp

Filipi

Assanis

Kuo

Najt

Rask

New heat transfer correlation for an HCCI engine derived from measurements of instantaneous surface heat flux. SAE, paper 2004-01-2996, 2004.

16.

Holman

J. P.

Experimental methods for engineers, sixth edition, 1994 (McGraw-Hill, Inc.).

17.

National Physical Laboratory. Thermal conductivity of an aluminium alloy. Test report, reference PP11/N00/004, October, 2000.