Influence of air–water two-phase flow on the performance of a high-speed inducer

Abstract

This study is to reveal the influence of incoming flow containing air on the internal flow and performance of a high-speed inducer. Numerical calculations were performed herein under different air volume fraction conditions based on the shear-stress transport turbulence model and the Eulerian–Eulerian heterogeneous flow model. The external characteristic, cavitation performance and visualization experiment were conducted under the air–water two-phase condition. As a result, the effect of incoming flow containing air under small flow rate condition on the decline of the inducer head was larger than that under large flow rate condition. The proper air volume fraction was beneficial to the improvement of the inducer cavitation performance. As the air volume fraction increased, the pressure gradients in the axial and radial directions of the inducer gradually reduced and the supercharging performance of the inducer also worsened. The flow near the hub in the flow channel became messy, and the turbulence energy increased. The air mainly concentrated in the leading edge rim and the low blade height region near the hub in the flow channel. The air expanded in the circumferential, radial and axial direction as the air volume fraction increased.

Keywords

Inducer high speed air-water two-phase flow numerical simulation experiment

Get full access to this article

View all access options for this article.

References

Cui

Chen

. Visual experiment and numerical simulation of cavitation instability in a high-speed inducer. Proc IMechE, Part A: J Power and Energy 2020; 234: 470–480.

Mansour

Wunderlich

Thévenin

. Effect of tip clearance gap and inducer on the transport of two-phase air-water flows by centrifugal pumps. Exp Therm Fluid Sci 2018; 99: 487–509.

Mansour

Parikh

Engel

, et al. Numerical investigations of gas–liquid two-phase flow in a pump inducer. J Fluids Eng 2020; 142: 021302.

Kang

. Effect of the number of blades on the performance and cavitation instabilities of a turbopump inducer with an identical solidity. J Mech Sci Technol 2015; 29: 5251–5256.

Kim

Choi

Kim

, et al. Effects of tip clearance on performance and characteristics of backflow in a turbopump inducer. Proc IMechE, Part A: J Power and Energy 2013; 227: 847–857.

Karakas

Watanabe

Aureli

, et al. Cavitation performance of constant and variable pitch helical inducers for centrifugal pumps: effect of inducer tip clearance. J Fluids Eng 2020; 142: 021101.

Yuan

Zhang

KYQSR

. Numerical investigation of gas-liquid two-phase flow in centrifugal pumps based on inhomogeneous model. Trans Chin Soc Agric Mach 2017; 48: 89–95.

Caridad

Kenyery

. CFD analysis of electric submersible pumps (ESP) handling two-phase mixtures. J Energy Resour Technol 2004; 126: 99–104.

Miao

Liu

Zhao

, et al. A numerical study on the influence of gas-liquid two phase flow on the rotary pump performances. Mater Sci Eng 2013; 52: 062070.

10.

Müller T, Limbach P and Skoda R. Numerical 3D RANS simulation of gas-liquid flow in a centrifugal pump with an Euler-Euler two-phase model and a dispersed phase distribution. In: Proceedings of 11th European conference on turbomachinery fluid dynamics and thermodynamics, Madrid, Spain, 2015.

11.

Zhang

Cai

, et al. Visualization study of gas-liquid two-phase flow patterns inside a three-stage rotodynamic multiphase pump. Exp Therm Fluid Sci 2016; 70: 125–138.

12.

Neumann

Schäfer

Bieberle

, et al. An experimental study on the gas entrainment in horizontally and vertically installed centrifugal pumps. J Fluids Eng 2016; 138: 091301.

13.

Zhu

Zhang

. A review of experiments and modeling of gas-liquid flow in electrical submersible pumps. Energies 2018; 11: 180–221.

14.

Zhang

Shi

Chen

, et al. Numerical simulations and visualized experiments of tip leakage vortex and associated cavitation in axial-flow pump. Chin J Hydrodyn 2017; 32: 565–574.

15.

Murakami

Minemura

Takimoto

. Effects of entrained air on the performance of centrifugal pumps under cavitating conditions. Bull JSME 1980; 23: 1435–1442.

16.

Cappellino CA, Roll DR and Wilson G. Design considerations and application guidelines for pumping liquids with entrained gas using open impeller centrifugal pumps. In: Proceedings of the 9th international pump users symposium, 1992, pp. 262–264. Turbomachinery Laboratories, Department of Mechanical Engineering, Texas A&M University.

Supplementary Material

Please find the following supplemental material available below.

For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.

For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.

0.00 MB

0.01 MB