Effect of side stream obstruction on the results of an industrial three-stream cold box: Numerical study

Abstract

The cold box heat exchangers are used in petrochemical and gas refinery industries. Here, an industrial complex cold box equipped with a number of plate-fins is simulated by computational fluid dynamics. The model predicts the outlet vapor fraction, pressure drop, and outlet temperature with average absolute relative deviations of 0.17%, 3.3%, and 12.89% for all streams, respectively. The influence of obstruction in streams B and C on the computational fluid dynamics results are studied. When stream B or C is blocked, the remaining open streams experience an increase in pressure drop, temperature, and vapor fraction, which negatively affects the heat exchanger's performance over a long time. Finally, the computational fluid dynamics results of the cold box are compared with those of commercial software Aspen-EDR. Even though Aspen-EDR predicts an acceptable mean temperature and vapor fraction (phase change) along channels, it calculates pressure drop incorrectly. So, Aspen-EDR, computationally efficient software, can be used for modeling of mean temperature and phase change of flow in an industrial multi-stream cold box.

Keywords

Computational fluid dynamics plate-fin heat exchanger cold box stream blockage Aspen-EDR

Get full access to this article

View all access options for this article.

References

Wang

. Layer pattern thermal design and optimization for multistream plate-fin heat exchangers - A review. Renew Sustain Energy Rev 2016; 53: 500–514.

Sheik Ismail

Velraj

Ranganayakulu

. Studies on pumping power in terms of pressure drop and heat transfer characteristics of compact plate-fin heat exchangers-A review. Renew Sustain Energy Rev 2010; 14: 478–485.

Awais

Bhuiyan

. Heat transfer enhancement using different types of vortex generators (VGs): a review on experimental and numerical activities. Therm Sci Eng Prog 2018; 5: 524–545.

Awais

Bhuiyan

. Heat and mass transfer for compact heat exchanger (CHXs) design: a state-of-the-art review. Int J Heat Mass Transf 2018; 127: 359–380.

Awais

Bhuiyan

. Enhancement of thermal and hydraulic performance of compact finned-tube heat exchanger using vortex generators (VGs): a parametric study. Int J Therm Sci 2019; 140: 154–166.

Keramat

Izadpanah

. Thermo-hydraulic performance analysis of converging-diverging heat exchanger with inclined fins using computational fluid dynamics. J Taiwan Inst Chem Eng 2022; 132: 1–17.

Liu

Zhang

Zhao

, et al. Influence of fin arrangement on fluid flow and heat transfer in the inlet of a plate-fin heat exchanger. J Zhejiang Univ Sci A 2015; 16: 279–294.

Zhang

. CFD Simulation on inlet configuration of plate-fin heat exchangers. Cryogenics (Guildf) 2003; 43: 673–678.

Raul

Bhasme

Maurya

. A numerical investigation of fluid flow maldistribution in inlet header configuration of plate fin heat exchanger. Energy Procedia 2016; 90: 267–275.

10.

Habib

Ben-Mansour

Said

SAM

, et al. Correlations of flow maldistribution parameters in an air cooled heat exchanger. Int J Numer Methods Fluids 2008; 56: 143–165.

11.

Yang

Wen

, et al. A mathematical model for flow maldistribution study in a parallel plate-fin heat exchanger. Appl Therm Eng 2017; 121: 462–472.

12.

Haider

Freko

Acher

, et al. Influence of inlet configuration and distributor geometry on the performance of cryogenic plate-fin heat exchangers. Appl Therm Eng 2021; 195: 117197.

13.

Lee

Ling

, et al. A CFD assisted segmented control volume based heat exchanger model for simulation of air-to-refrigerant heat exchanger with air flow mal-distribution. Appl Therm Eng 2018; 131: 230–243.

14.

Liu

. Multi-objective shape optimization of a plate-fin heat exchanger using CFD and multi-objective genetic algorithm. Int J Heat Mass Transf 2017; 111: 65–82.

15.

Manglik

Zhang

Muley

. Low Reynolds number forced convection in three-dimensional wavy-plate-fin compact channels: fin density effects. Int J Heat Mass Transf 2005; 48: 1439–1449.

16.

Lindqvist

Skaugen

Meyer

OHH

. Plate fin-and-tube heat exchanger computational fluid dynamics model. Appl Therm Eng 2021; 189: 116669.

17.

Marcinkowski

Taler

, et al. Thermal calculations of four-row plate-fin and tube heat exchanger taking into account different air-side correlations on individual rows of tubes for low reynold numbers. Energies 2021; 14: 6978.

18.

Zhang

. The effect of heat conduction through fins on the performance of finned-tube CO2 supercritical gas coolers. Int J Heat Mass Transf 2021; 181: 121908.

19.

Zargoushi

Talebi

Hosseini

. Influence of fluid distributors on the performance of the industrial cold box with a plate-fin heat exchanger: a numerical study. Proc Inst Mech Eng Part C J Mech Eng Sci 2021; 235: 5160–5172.

20.

Zargoushi

Talebi

Hosseini

. CFD Modeling of industrial cold box with plate-fin heat exchanger: focusing on phase change phenomenon. Int J Heat Mass Transf 2020; 147: 118936.

21.

Haider

Freko

Acher

, et al. A transient three-dimensional model for thermo-fluid simulation of cryogenic plate-fin heat exchangers. Appl Therm Eng 2020; 180: 115791.

22.

Mahmoodi

Hossein

Raj

, et al. A new acid gas destruction kinetic model for reaction furnace of an industrial sulfur recovery unit: a CFD study. Chem Eng Sci 2022; 256: 117692.

23.

Menni

Ahmad

Ameur

, et al. Case studies in thermal engineering effects of two-equation turbulence models on the convective instability in finned channel heat exchangers. Case Stud Therm Eng 2022; 31: 101824.

24.

Hukkanen

Rangitsch

Witt

. Non-adiabatic multitubular fixed-bed catalytic reactor model coupled with shell-side coolant CFD model. Ind Eng Chem Res 2013; 52: 15437–15446.

25.

Wang

Guo

Zhang

, et al. Numerical study on hydrodynamic characteristics of plate-fin heat exchanger using porous media approach. Comput Chem Eng 2014; 61: 30–37.

Supplementary Material

Please find the following supplemental material available below.

For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.

For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.

0.00 MB

0.65 MB