Abstract
The influence of post-heat treatment on the microstructural and electropolishing characteristics of the laser powder bed fusion processed Inconel 718 is studied. The electropolishing results show a significant decrease in the surface roughness for as-printed (∼69%) and post-heat treatment conditions (∼74%) with increasing current density and polishing time. The surface morphology of the as-printed samples showed the presence of unaltered asperities on the electropolished surface, which can be attributed to the precipitation of non-conductive lave phases and metal carbides during laser powder bed fusion processing. The post-heat treatment homogenizes microstructure and dissolves these phases in the metal matrix along with the precipitation of strengthening phases. As a result, the surface morphology of post-heat treatment samples becomes more uniform, signifying fewer surface irregularities. The statistical parameters show a significant reduction in sharp asperities in the post-heat treatment condition. The material ratio curves revealed uniform material distribution in the post-heat treatment samples, signifying reduced surface asperities compared to as-printed conditions.
Keywords
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
