Experimental analysis of the modal characteristics of rail fastening clips

Abstract

It is usually difficult to obtain the modal characteristics of the rail fastening clip analytically owing to its complex spatial structure and operating environments. Therefore, experimental modal testing is frequently adopted to identify the modal characteristics of rail fastening clips. This study takes the SKL 15 clip of the Vossloh 300-1 fastening system as the research object to analyse the following three aspects in great detail: (1) Locations of the measurement points are reasonably designed to capture all modes of the clip in the frequency range 0–1000 Hz. (2) The appropriate sensors are selected for the clip in different operating situations by comparing the measured results of three kinds of sensors, namely the accelerometer, laser vibrometer and sound pressure sensor. In addition, the test results suggest that the accelerometer which has a strong anti-disturbance ability in an ambient environment is recommended to be chosen in a noisy environment while the laser vibrometer and sound pressure sensor which have no added mass to the tested structures may be used in an indoor environment with suitable temperature and low noise. (3) In order to eliminate the effect of the additional mass on the modal characteristics of the clip, the accelerometer is recommended to be installed at the rear end of the side leg of the clips in the experimental modal test.

Keywords

Experimental modal analysis rail fastening clip natural frequency mode shape sensor selection accelerometer location selection

Get full access to this article

View all access options for this article.

References

Ling

Shang

, et al. Experimental and numerical investigation of the effect of rail corrugation on the behaviour of rail fastenings. Veh Syst Dyn 2014; 52: 1211–1231.

Zhao

Wen

Wang

, et al. Modeling of high-speed wheel-rail rolling contact on a corrugated rail and corrugation development. J Zhejiang Univ Sci A 2014; 15: 946–963.

Xiao JH, Yan ZQ, Tu YH, et al. On impact of wheel-rail vibration on HSR fastener damage. China Railway 2017; 11: 10–14. (in Chinese).

Zhu

Cai

Yin

, et al. Dynamic analysis of rail fastening clip in high-speed railway. Eng Mech 2013; 6: 038.

Zhang

. Research progress in failure of high-speed railway spring bar fastener. Value Eng 2017; 23: 108.

Noël

Renson

Kerschen

. Complex dynamics of a nonlinear aerospace structure: experimental identification and modal interactions. J Sound Vibr 2014; 333: 2588–2607.

Chang

Kim

. Modal-parameter identification and vibration-based damage detection of a damaged steel truss bridge. Eng Struct 2016; 122: 156–173.

Markine VL, De Man AP and Esveld C. Identification of dynamic properties of a railway track. In: IUTAM symposium on field analyses for determination of material parameters – experimental and numerical aspects. Dordrecht: Springer, 2003, pp.27–36.

Oregui

Dollevoet

. Identification of characteristic frequencies of damaged railway tracks using field hammer test measurements. Mech Syst Signal Process 2015; 54: 224–242.

10.

Kaewunruen

Remennikov

. Field trials for dynamic characteristics of railway track and its components using impact excitation technique. Ndt E Int 2007; 40: 510–519.

11.

Smutny

. Measurement and analysis of dynamic and acoustic parameters of rail fastening. NDT E Int 2004; 37: 119–129.

12.

Ewins DJ. Modal testing: theory, practice, and application. 2nd ed. England, UK: Research Studies Press, 2000.

13.

Vanlanduit

Daerden

Guillaume

. Experimental modal testing using pressurized air excitation. J Sound Vibr 2007; 299: 83–98.

14.

Zhu

Liu

, et al. A modal test method using sound pressure transducers based on vibro-acoustic reciprocity. J Sound Vibr 2014; 333: 2728–2742.

15.

Kaewunruen S and Remennikov A. Application of experimental modal testing for estimating dynamic properties of structural components. In: Proceedings of Australian Structural Engineering Conference 2005, Newcastle, Australia, 2005.

16.

De Man, AP. DYNATRACK: a survey of dynamic railway track properties and their quality. PhD Thesis, Delft University of Technology, Netherlands, 2002.