The quantitative characterization of the ignition process for a lean staged injector: Influence of the air split between pilot swirlers

Abstract

The ignition of a lean staged injector aimed at aeronautical application is a transient and complex phenomenon, which involves fluid dynamics, turbulent mixing, chemical kinetics, as well as their mutual interactions. In the present research, a staged injector, designed based on stratified partially premixed combustion concept, is introduced. The ignition performance of stratified partially premixed injectors with different air split ratios between pilot swirlers are experimentally acquired, which exhibits apparent distinctions. In order to make quantitative analyses, the classical physical ignition model is improved, in which the flame propagation process is further divided into the axial and radial propagation sub-processes. Nonreacting flow field and discrete phase simulations, validated by experiment results, are utilized to obtain the velocity and spray distributions. Physical parameters characterizing the ignition sub-processes are defined and calculated based on the numerical simulation results. Conclusions are made by comparing the physical parameters of the ignition sub-processes. The radial propagation of the ignition kernel is responsible for the ignition performance difference between the two injectors with different pilot air split ratios (PASR) in that the average equivalence ratio along the radial propagation route of PASR = 7:3 is one order richer than that of PASR = 2:8. The present ignition analysis and model can be further extended and developed for the optimization of ignition performance of lean staged injector.

Keywords

Ignition quantitative analysis axial propagation radial propagation flame stabilization

Get full access to this article

View all access options for this article.

References

Mongia HC. TAPS – a 4th generation propulsion combustor technology for low emissions. AIAA paper no. 2003-2657, 2003.

Foust MJ, Thomsen D, Stickles R, et al. Development of the GE aviation low emissions TAPS combustor for next generation aircraft engines. AIAA paper no. 2012-0936, 2012.

Lazik W, Doerr T, Bake S, et al. Development of lean-burn low-NOx combustion technology at Rolls-Royce Deutschland. In: Proceedings of ASME turbo expo 2008, ASME paper no. GT2008-51115, 2008. New York: ASME.

Lefebvre AH and Ballal DR. Gas turbine combustion alternative fuels and emissions. Boca Raton, FL: CRC Press, 2010.

Mastorakos

. Ignition of turbulent non-premixed flames. Prog Energy Combust Sci 2009; 35: 57–97.

Fu ZB, Lin YZ, Li JB, et al. Experimental investigation on ignition performance of LESS combustor. In: Proceedings of ASME turbo expo 2011, GT2011-45786, 2011. New York: ASME.

Wang

Zhang

Lin

, et al. Influence of main swirler vane angle on the ignition performance of TeLESS-II combustor. J Eng Gas Turbines Power 2017; 139: 011501.

Mi XT, Zhang C, Wang B, et al. Influence of main stage air splits on the ignition performance of TELESS-II combustor. In: Proceedings of ASME turbo expo 2017, GT2017-63216, 2017. New York: ASME.

Liu

Yang

, et al. Improvement on ignition and lean blowout performance of a pilot lean-burn combustor. Proc IMechE, Part A: J Power and Energy 2016; 230: 196–205.

10.

Liu

Yang

, et al. Experimental investigation of spray and combustion performances of a fuel-staged low emission combustor: effects of main swirl angle. J Eng Gas Turbines Power 2017; 139: 121502.

11.

Liu CX, Liu FQ, Yang JH, et al. Experimental investigation of spray and combustion performances of a fuel-staged low emission combustor, part II: effects of venturi angle. In: Proceedings of ASME turbo expo 2018, GT2018-76452, 2018. New York: ASME.

12.

Antoshkiv O and Berg HP. Spray phenomena and their influence on the ignition performance of a model aeroengine combustor. In: ILASS 2008, paper ID: ILASS08-11-1, 2008.

13.

Mosbach T, Sadanandan R and Meier W. Experimental analysis of altitude relight under realistic conditions using laser and high-speed video techniques. In: Proceedings of ASME turbo expo 2010, GT2010-22625, 2010. New York: ASME.

14.

Kobayashi M, Ogata H, Oda T, et al. Improvement on ignition performance for a lean staged low NOx combustor. In: Proceedings of ASME turbo expo 2011, ASME paper no. GT2011-46187, 2011. New York: ASME.

15.

Fujiwara H, Matsuura K, Shimodaira K, et al. Suppression of NOx emission of a lean staged combustor for an aircraft engine. In: Proceedings of ASME turbo expo 2011, ASME paper no. GT2011-46256, 2011. New York: ASME.

16.

Yang

Liu

, et al. Experimental and numerical study of the effect of main stage stratifier length on lean blow-out performance for a stratified partially premixed injector. Proc IMechE, Part A: J Power and Energy 2018; 232: 812–825.

17.

Yang JH, Wu HW, Liu CX, et al. Experimental investigation of ignition and LBO characteristics of SPP injector: the effect of pilot stage air split ratio. In: Proceedings of ASME turbo expo 2018, ASME paper no. GT2018-76282, 2018. New York: ASME.

18.

Stöhr

Boxx

Carter

, et al. Dynamics of lean blowout of a swirl-stabilized flame in a gas turbine model combustor. Proc Combust Inst 2011; 33: 2953–2960.

19.

Stöhr

Arndt

Meier

. Effects of Damköhler number on vortex–flame interaction in a gas turbine model combustor. Proc Combust Inst 2013; 34: 3107–3115.

20.

Shanbhogue

Sanusi

Taamallah

, et al. Flame macrostructures, combustion instability and extinction strain scaling in swirl-stabilized premixed CH₄/H₂ combustion. Combust Flame 2016; 163: 494–507.

21.

Morales

Lasky

Geikie

, et al. Mechanisms of flame extinction and lean blowout of bluff body stabilized flames. Combust Flame 2019; 203: 31–45.

22.

Lutz AE, Kee RJ, Grcar JF, et al. OPPDIF: a Fortran program for computing opposed-flow diffusion flames. Report no. SAND96-8243, Livermore, CA, USA, 1997.

23.

Kee

Miller

Evans

, et al. A computational model of the structure and extinction of strained, opposed flow, premixed methane-air flames. Proc Combust Inst 1988; 22: 1479–1493.

24.

Liu

Mao

, et al. Experimental investigation of performance of an air blast atomizer by planar laser sheet imaging technique. J Eng Gas Turbines Power 2014; 136: 021601.