Compressor performance recovery system: which solution and when

Abstract

During normal operation, compressor is mainly affected by fouling due to air pollution, which causes its performance to degrade over time. The main solutions to reduce compressor fouling are off-line compressor washing, on-line compressor washing, and advanced air filtration systems. Overall, the choice of the best recovery system for each gas turbine in the specific power plant is not trivial. The aim of this study is to provide a guide to identify the best washing or filter devices for a gas turbine (GT) in a specific power plant site, using literature information and GT users data.

Two procedures were conceived in order to have an user-friendly tool. ‘Best cleaning device’ was developed to help a GT user in the choice of the best devices for recovering compressor performance. Gathering information about GT performance and environmental conditions from real applicatios and literatures, a value of recommendation for each technology is provided.

‘Best cleaning time’ is based on the thermoeconomics theory of ‘best maintenance time’ and it provides the user an estimation about the best time to perform a compressor off-line or on-line washing.

Both procedures have been proved on a few real cases, showing good results and indications to more in-depth development.

Keywords

gas turbine combined cycle compressor fouling compressor washing air filter systems thermo-economics

Get full access to this article

View all access options for this article.

References

Schneider

Demircioglu

Franco

Therkorn

Analysis of compressor on-line washing to optimize turbine power plant performance. Proccedings of the ASME Turbo Expo 2009 on Power for land, sea, and air. 8–12 June 2009, Orlando, Florida, USA, ASME paper GT2009-59356.

Kalyanaraman

Water washing is it good for your gas turbine?. Turbomach. Int. Mag., 2009, 50(4), 12–14.

Korakianitis

Papagiannidis

Vlachopoulos

N. E.

Unsteady-flow/quasi-steady heat transfer computations on a turbine rotor and comparison with experiments. Trans. ASME J. Turbomach., 2002, 124, 152–159.

Syverud

Axial compressor performance deterioration and recovery through on-line washing, 2007, PhD, NTNU.

Meher-Homji

C. B.

Bromley

Gas turbine axial compressor fouling and washing. In Proceedings of the 33rd Turbomachinery Symposium. 20–23 September 2004, Houston, Texas, available from http://turbolab.tamu.edu/pubs/Turbo33/T33pg163.pdf (acce-ssed October 2009), 163–192.

Massardo

A. F.

Simulation of fouled axial multistage compressors. In Proceedings of the IMechE Conference on Turbomachinery. 1991, London, UK, paper no. C423/048, 243–252.

Haub

G. L.

Hauhe

W. E.

Jr . Field evaluation of on-line compressor cleaning in heavy duty industrial gas turbines. In Proceedings of the ASME Gas turbine and Aeroengine Congress and Exposition. 11–14 June 1990, Brussels, Belgium, ASME paper no. 90-GT-107.

Turnbull

Clément

Ekberg

Gas turbine combustion air filtration: its impact on compressor efficiency and hot end component life. In Proceedings of the ETN Annual Workshop. Copenhagen, Denmark, October 2009, position paper.

Cafaro

Napoli

Traverso

Massardo

A. F.

Monitoring of the thermoeconomic performance in an actual combined cycle power plant bottoming cycle. Energy, 2010, 35, 902–910.

10.

Napoli

Massardo

A. F.

Traverso

Cafaro

Thermoeconomic diagnostics of large size combined cycles, 2008, Master Thesis, University of Genova, Genova, Italy).

11.

Gülen

S. C.

Griffin

P. R.

Paolucci

Real-time on-line performance diagnostics of heavy duty industrial gas turbines. In Proceedings of the ASME Turbo Expo 2000. 8–11 May 2000, Munich, Germany, 2002, 124, ASME paper no. 2000-GT-0312. J. End. Gas Turbines Power, 910–921.

12.

Veer

Haglerod

K. K.

Bolland

Measured data correction for improved fouling and degradation analysis of offshore gas turbines. In Proceedings of the ASME Turbo Expo. 2004, Vienna, ASME paper no. GT2004-53760.

13.

Cafaro

Veer

Diagnostics of combined cycle power plants: real applications to condition based maintenance. In Proceedings of the 9th International Conference on Heat engines and environmental protection. 2009, Balatonfüred, Hungary.