Study on a seawater hydraulic piston pump with check valves for underwater tools

Abstract

The aim of this study is to develop a seawater hydraulic piston pump for the power pack of an underwater tool system. A pump with check valves and oil–water-separated structure was selected for the purpose of improving its tolerance to particles when applied in open-circuit system. A novel ‘anti-loosening’ structure was introduced for the piston/shoe assembly. To improve the anti-wear and anti-corrosion performances of the piston and sleeve pairs under seawater lubrication, carbon fibre-reinforced polyetheretherketone was injected as an inner of the sleeve, and synthesized WC was formed on the piston with improved surface hardness. The unbalance problem of the shaft assembly was solved based on Solidworks software by adjusting the centre of mass of the shaft to its rotation axis and making all the products of inertia close to zero for an arbitrary-given coordinate system in which one of its axes is at the rotation axis. Basic performances and reliability experiments for the pump were carried out on a test rig. The shaft assembly was verified by experiment to reach very desirable balance effect. The pump has relative high efficiency at 10 MPa rated pressure and 14 MPa maximum pressure. After 300 h durability test, neither excessive wear could be found for the piston/sleeve pairs as well as other parts in the pump, nor obvious performance degradation happened to the pump. The dynamic balancing method presented in this article provides an easy and effective way to solve the unbalance problem for a shaft with special structure and can be widely used in other rotating machines. New design on the seawater hydraulic pump was initially confirmed to be feasible, although further research needs to be conducted. The pump has been successfully applied in an underwater seawater hydraulic tool system.

Keywords

seawater hydraulics piston pump design dynamic balance reliability

Get full access to this article

View all access options for this article.

References

Black

S. A.

Kuehler

W. D.

Jr.

The development of a seawater hydraulic vane motor. In Proceedings of the National Conference on Fluid power: 37th annual meeting, Chicago, USA, 21–23 October 1981, vol. 35, pp. 111–118.

Brookes

C. A.

Fagan

M. J.

James

R. D.

Kerry

McConnachie

The development of water hydraulic pumps using advanced engineering ceramics. In Proceedings of the 4th Scandinavian International Conference on Fluid power, Tampere, Finland, 26–29 September 1995, pp. 965–977.

Drabls

L. S.

Testing of DanfossAPP1.0-2.2 with APP pumps as water hydraulic motors for energy recovery. Desalination, 2005, 183, 41–54.

Terävä

Kuikko

Vilenius

Development of seawater hydraulic power pack. In Proceedings of the 4th Scandinavian International Conference on Fluid power, Tampere, Finland, 26–29 September 1995, pp. 978–991.

Kitagawa

Co-operation between universities and water hydraulic companies in Japan. In Proceedings of the 6th Scandinavian International Conference on Fluid power, Tampere, Finland, 26–28 May 1999, vol. 2, pp. 35–50.

Van der Wijk

Herder

J. L.

Demeulenaere

Comparison of various dynamic balancing principles regarding additional mass and additional inertia. J.Mech. Rob., 2009, 1, 1–9.

ASTM-D1141-98 . Standard practice for the preparation of substitute ocean water. In Annual book of ASTM standards, 2004 (American Society for Testing and Materials, Philadelphia, Pennsylvania, USA).