Optimisation of a low-pressure multistage steam turbine towards decreasing the wetness losses and aerodynamic losses

Abstract

Aerodynamic losses and wetness losses are two crucial factors which contribute to the decrease in the efficiency of wet-steam turbines. In this study, the response surface method is used to optimise the final three stages of a low-pressure steam turbine in consideration of the combined influences of these losses. The selected optimisation variables are the stagger angles and the blade profile stacking lines along the spanwise direction of the stators in these stages. Results show that the pressure balance in the final three stages is changed by optimising the stagger angles, thus facilitating the redistribution of supercooling degrees. As a result, both non-equilibrium thermodynamic loss and droplet diameter are reduced, and the wetness losses are decreased by 20.71%. Moreover, the method of limiting the wetness losses by adjusting the stagger angles of the low-pressure steam turbine is summarised. The optimisation of the profile stacking lines can improve the reaction degree distribution, reduce the boundary layer separation and limit secondary losses. Consequently, the aerodynamic efficiency is enhanced, and the supercooling and the outlet velocity are altered, thereby shrinking the primary and secondary droplets considerably. The aerodynamic losses are reduced by 0.52%, and the wetness losses are further lowered by 9.48%.

Keywords

Low-pressure multistage steam turbine aerodynamic losses wetness losses response surface method optimisation

Get full access to this article

View all access options for this article.

References

Moore

Sieverding

. Two-phase steam flow in turbines and separators, Washington DC, USA: Hemisphere Publishing Corporation, 1976.

Box

Wilson

. On the experimental attainment of optimum conditions. J R Stat Soc Series B Methodol 1951; 13: 1–45.

Rubechini

Schneider

Arnone

. A redesign strategy to improve the efficiency of a 17-stage steam turbine. J Turbomach 2012; 134: 031021–031021.

Liang

Zhao

. Aerodynamic optimisation of a low-pressure multistage turbine using the response-surface method. J Mech Sci Technol 2013; 27: 2537–2546.

Laali

. A new approach for assessment of the wetness losses in steam turbines. Proc of the Inst of Mech Eng Turbomachinary: Latest Development in a Changing Scene 1991; 3: 155–165. .

Guo T, Sumner W and Hofer D. Development of highly efficient nuclear HP steam turbines using physics based moisture loss models. ASME Paper, GT2007-27960, 2007.

Kawagishi

Onoda

Shibukawa

. Development of moisture loss models in steam turbines. Heat Trans Asian Res 2013; 42: 651–664.

Liang

Xiaolong

. Quantitative evaluation of wetness losses in steam turbines based on three-dimensional simulations of non-equilibrium condensing flows. Proc IMechE, Part A: Journal of Power and Energy 2014; 228: 708–716.

Box

GEP

Draper

. Empirical model building and response surfaces, New York, NY: John Wiley & Sons, 1987.

10.

Liang

Yang

You

. Investigation of the vapour-liquid two-phase flow in the low-pressure cylinder of a 1000 MW nuclear power steam turbine. Proc IMechE, Part A: Journal of Power and Energy 2014; 228: 178–185.