Experimental investigation on the performance of a side channel pump under gas–liquid two-phase flow operating condition

Abstract

Side channel pump is a kind of small volume vane pump with low flow rate but high head and most side channel pumps can transport gas–liquid two-phase flow. In order to investigate the performance of this type of pump depending on the blade suction angle under gas–liquid two-phase flow operating condition, an experimental study has been carried out. The head and efficiency curves, and the influence of blade suction angle changes on these curves for different inlet gas volume fraction states are analyzed in detail. Moreover, the gas transporting capability of the impeller with three different blade suction angles (10°, 20°, 30°) are also compared. The results show that the head and efficiency performances of the three impellers decrease a large value when the side channel pump operates with a little gas inside, and the operating range narrows as well. With the increasing of inlet gas volume fraction, the performance of the side channel pump worsens. The head and efficiency performances in the single-phase state improve by increasing the blade suction angle, but decrease by increasing the blade suction angle in the gas–liquid two-phase flow state. The maximum gas transporting capability of the impeller with a small blade suction angle is better than a large blade suction angle. Analysis on the measured data allows a better understanding of the effect of inlet gas quantity on the performance of the side channel pump with different blade suction angles, and it could supply the design reference for two-phase flow side channel pumps.

Keywords

Side channel pump experiment two-phase flow pump performance decrease

Get full access to this article

View all access options for this article.

References

Ritter C. About self-priming centrifugal pumps and experiments on a new pump of this type. PhD Thesis, Technical University of Dresden, Germany, 1930.

Schmiedchen W. Studies on centrifugal pumps with side ring channel. PhD Thesis, Technical University of Dresden, Germany, 1932.

Surek

. Inﬂuence of blade geometry on the gradient of the characteristic curves of side-channel machines. Forsch Ingenieurwes 1998; 64: 173–182.

Fleder A and Böhle M. Numerical and experimental investigations on the influence of the blade shape on industrial side channel pumps. In: International rotating equipment conference, Düsseldorf, Germany, 2012, pp.289–298.

Fleder

Böhle

. A systematical study of the influence of blade length, blade width, and side channel height on the performance of a side channel pump. ASME J Fluids Eng 2015; 137: 121102–121102.

Böhle M and Müller T. Evaluation of the flow inside a side channel pump by the application of an analytical model and CFD. ASME paper no. FEDSM2009–78023, 2009.

Fleder A, Müller T and Böhle M. A theoretical method to improve the side channel pump efficiency. In: 9th European conference on turbomachinery, Istanbul, Turkey, 2011, pp.711–720.

Choi

Yoo

Park

et al.

Experimental study on the effect of blade angle on regenerative pump performance. Proc IMechE, Part A: J Power and Energy 2013; 227: 585–592.

Iversen

. Performance of the periphery pump. Trans ASME 1955; 77: 19–28.

10.

Pﬂeiderer C. Centrifugal pumps for liquids and gases. Vol. 3. Berlin: Springer Verlag, 1949.

11.

Engels H. Investigations of ring pumps (regenerative pumps). PhD Thesis, TH Hannover, 1940.

12.

Pfaff H. Comparative investigations of regenerative pumps with and without diffusor. PhD Thesis, TH Hannover, 1961.

13.

Fleder A and Böhle M. A study of the internal ﬂow structure in a side channel pump. In: Proceedings of the 14th international symposium on transport phenomena and dynamics of rotating machinery, Honolulu, 2012.

14.

Zhang

Böhle

Pei

et al.

Numerical simulation and verification on flow characteristics of impeller axial and radial gaps in side channel pump. Trans Chin Soc Agric Eng 2015; 31: 78–83.

15.

Murakami

Minemura

. Effects of entrained air on the performance of a centrifugal pump: 1st report, performance and flow conditions. Bull JSME 1974; 17: 1047–1055.

16.

Furukawa A. Fundamental studies on a tandem bladed impeller of gas-liquid two-phase centrifugal pump. Memoirs of the Faculty of Engineering, Kyushu University, Japan, 1988.

17.

Cappellino CA, Roll DR and Wilson G. Design considerations and application guidelines for pumping liquids with entrained gas using open impeller centrifugal pumps. In: Proceedings of the ninth international pump users symposium, Houston, USA, 1992, pp.51–60.

18.

Caridad

Asuaje

Kenyery

et al.

Characterization of a centrifugal pump impeller under two-phase flow conditions. J Petrol Sci Eng 2008; 63: 18–22.

19.

Yu ZY, Zhang QZ, Huang R, et al. Numerical analysis of gas-liquid mixed transport process in a multiphase rotodynamic pump. In: IOP conference series: Earth and environmental science. Bristol, UK: IOP Publishing, 2012.

20.

Zhang

Fleder

Böhle

et al.

Effect of suction side blade profile on the performance of a side channel pump. Proc IMechE, Part A: J Power and Energy 2016; 230: 586–597.