Experimental research on pumping losses and combustion performance in an unthrottled spark ignition engine

Abstract

A novel fully hydraulic variable valve system is described in this paper, which achieves continuous variations in maximum valve lift, valve opening duration, and the timing of valve closing. The load of the unthrottled spark ignition engine with fully hydraulic variable valve system is controlled by using an early intake valve closing rather than the conventional throttle valve. The experiments were carried out on BJ486EQ spark ignition engine with fully hydraulic variable valve system. Pumping losses of the throttled and unthrottled spark ignition engines at low-to-medium loads are compared and the reason of it decreasing significantly in the unthrottled spark igntion engine is analyzed. The combustion characteristic parameters, such as cyclic variation, CA50, and heat release rate, were analyzed. The primary reasons for the lower combustion rate in the unthrottled spark ignition engines are discussed. In order to improve the evaporation of fuel and mix with air in an unthrottled spark ignition engine, the in-cylinder swirl is organized with a helical intake valve, which can generate a strong intake swirl at low intake valve lifts. The effects of the intake swirl on combustion performance are investigated. Compared with the throttled spark ignition engine, the brake specific fuel consumption of the improved unthrottled spark ignition engine is reduced by 4.1% to 11.2%.

Keywords

Unthrottled spark ignition engine fully hydraulic variable valve system pumping losses intake swirl cyclic variation fuel consumption

Get full access to this article

View all access options for this article.

References

Fontana

Galloni

. Variable valve timing for fuel economy improvement in a small spark-ignition engine. Appl Energy 2009; 86: 96–105.

Catapano

Iorio

Sementa

et al.

Optimization of the compressed natural gas direct injection in a small research spark ignition engine. Int J Engine Res 2017; 18: 118–130.

Alkidas

. Combustion advancements in gasoline engines. Energy Convers Manage 2007; 48: 2751–2761.

Ravi

Porpatham

. Effect of piston geometry on performance and emission characteristics of an LPG fuelled lean burn SI engine at full throttle condition. Appl Therm Eng 2017; 110: 1051–1060.

et al.

Research on cycle-by-cycle variations of an SI engine with hydrogen direct injection under lean burn conditions. Appl Therm Eng 2016; 109: 569–581.

Brecq

Bellettre

Tazerout

et al.

Knock prevention of CHP engines by addition of N₂ and CO₂ to the natural gas fuel. Appl Therm Eng 2003; 23: 1359–1371.

Zhong

Daniel

et al.

Combustion and emissions of 2, 5-dimethylfuran in a direct-injection spark-ignition engine. Energy Fuel 2010; 24: 2891–2899.

Ding

Roberts

Fain

et al.

Fuel efficient exhaust thermal management for compression ignition engines during idle via cylinder deactivation and flexible valve actuation. Int J Engine Res 2016; 17: 619–630.

Pournazeri

Khajepour

. Precise lift control in a new variable valve actuation system using discrete-time sliding mode control. Mech Mach Theory 2016; 99: 217–235.

10.

Chang

Fan

et al.

Effects of electromagnetic intake valve train on gasoline engine intake charging. Appl Therm Eng 2016; 96: 708–715.

11.

Zhang

Wang

Zheng

et al.

Experimental investigations of gasoline partially premixed combustion with an exhaust rebreathing valve strategy at low loads. Appl Therm Eng 2016; 103: 832–841.

12.

Dalla Nora

Lanzanova

TDM

Zhao

. Effects of valve timing, valve lift and exhaust backpressure on performance and gas exchanging of a two-stroke GDI engine with overhead valves. Energy Convers Manage 2016; 123: 71–83.

13.

Bozza

De Bellis

Teodosio

. Potentials of cooled EGR and water injection for knock resistance and fuel consumption improvements of gasoline engines. Appl Energy 2016; 169: 112–125.

14.

Paden

Snyder

Paden

et al.

Modeling and control of an electromagnetic variable valve actuation system. IEEE-ASME T Mech 2015; 20: 2654–2665.

15.

De Bellis

. Performance optimization of a spark-ignition turbocharged VVA engine under knock limited operation. Appl Energy 2016; 164: 162–174.

16.

Chen

Xie

et al.

Methods to achieve HCCI/CAI combustion at idle operation in a 4VVAS gasoline engine. Appl Energy 2014; 116: 41–51.

17.

Knop

Mattioli

. An analysis of limits for part load efficiency improvement with VVA devices. Energy Convers Manage 2015; 105: 1006–1016.

18.

Cleary D and Silvas G. Unthrottled engine operation with variable intake valve lift, duration, and timing. SAE paper No. 2007-01-1282, 2007.

19.

Jiang

Chen

Yang

et al.

The principle of higher internal combustion engine, Xian: Xian Jiaotong University Press, 2007.

20.

Gao

Wang

et al.

The Miller cycle effects on improvement of fuel economy in a highly boosted, high compression ratio, direct-injection gasoline engine: EIVC vs. LIVC. Energy Convers Manage 2014; 79: 59–65.

21.

Zhu

Zhou

et al.

Experimental investigation on the influences of exhaust gas recirculation coupling with intake tumble on gasoline engine economy and emission performance. Energy Convers Manage 2016; 127: 424–436.

22.

Battistoni M and Mariani F. Fluid dynamic study of unthrottled part load si engine operations with asymmetric valve lifts. SAE paper no. 2009-24-0017, 2009.

23.

Millo

Luisi

Borean

et al.

Numerical and experimental investigation on combustion characteristics of a spark ignition engine with an early intake valve closing load control. Fuel 2014; 121: 298–310.

24.

Pischinger M, Salber W, van der Staay F, et al. Benefits of the electromechanical valve train in vehicle operation. SAE paper no. 2000-01-1223, 2000.

25.

Xie ZF, Zhang J and Chang YJ. Study on intake performance of unthrottled SI engine with fully variable hydraulic valve actuating system. SAE paper no. 2014-01-2872, 2014.

26.

Claudio

Cristian

Giulio

et al.

Numerical evaluation of the applicability of steady test bench swirl ratios to diesel engine dynamic conditions. Energy Procedia 2015; 81: 732–741.