The influence of blade trailing edge modification on the pressure pulsation inside a two-stage centrifugal pump

Abstract

Adjusting the clearance between the rotor and the stator in the centrifugal pump is an effective measure to reduce the pressure pulsation. In this paper, we investigated the influence of blade trailing edge modification on the internal unsteady flow and the performance of a two-stage centrifugal pump with the V-type trailing edge (VTE) and elliptic trailing edge (ETE). The pressure pulsation on the spherical casing and the performance were analyzed based on the experimental results for the pump with the modified blade trailing edges of the cutting depths 1 mm, 2 mm and 2.5 mm. Also the unsteady flow in the pump was numerically simulated, and the velocity and the axial vorticity intensity were analyzed to evaluate the influence of the flow on the pressure pulsation and the performance of the pump. The results show that cutting the blade trailing edge will reduce the head and efficiency of the two-stage pump, and different outlet shapes under the same cutting depth have little effect on the performance. The modified impeller makes the high velocity areas at the blade outlet away from the spherical casing wall and reduces the pressure pulsation amplitude at the main frequency. At the design flow rate, the heads decrease by 7.3%, 9.8% and 11.3%, the efficiencies decrease by 2.8%, 3.5% and 4.0%, and the pressure pulsation amplitudes at the main frequency are reduced by 29%, 10.1% and 28.7% for the ETE1, ETE2, ETE2.5 blade compared with that of original impeller. Also, the heads decrease by 6.3%, 8.0% and 9.1%, the efficiencies decrease by 3.5%, 3.9% and 4.1%, and the pressure pulsation amplitudes at the main frequency are reduced by 3.2%, 11.7% and 38.1% for VTE1, VTE2, VTE2.5 blade. When the cutting depth is large, the trailing edge of the blade has a large vortex intensity. This may cause the energy loss and lead to the decrease of the efficiency and head. Considering the performance and unsteady pressure pulsation of the two-stage pump, the impeller with VTE1 blade has certain reference significance for engineering application.

Keywords

Multistage centrifugal pump blade outlet shape pressure pulsation unsteady flow

Get full access to this article

View all access options for this article.

References

Brennen

. Hydrodynamics of pumps. Oxford, UK: concepts NREC and Oxford University Press, 2011.

Al-Obaidi

Mishra

. Experimental investigation of the effect of air injection on performance and detection of cavitation in the centrifugal pump based on vibration technique. Arab J Sci Eng 2020; 45: 5657–5671.

Al-Obaidi

. Experimental comparative investigations to evaluate cavitation conditions within a centrifugal pump based on vibration and acoustic analyses techniques. Arch Acoust 2020; 45: 541–556.

Al-Obaidi

. Experimental investigation of cavitation characteristics within a centrifugal pump based on acoustic analysis technique. Inter J Fluid Mech Res 2020; 47; 501–515.

Zhang

Gao

, et al. Dynamic measurements on unsteady pressure pulsations and flow distributions in a nuclear reactor coolant pump. Energy 2020: 198; 117305.

Al-Obaidi

Mohammed

. Numerical investigations of transient flow characteristic in axial flow pump and pressure fluctuation analysis based on the CFD technique. J.Eng Sci Tech Rev 2019; 12; 70–79.

Al-Obaidi

. Numerical investigation of flow field behaviour and pressure fluctuations within an axial flow pump under transient flow pattern based on CFD analysis method. J Phys : Conf Ser 2019; 1279; 012069.

Al-Obaidi

. Analysis of the effect of various impeller blade angles on characteristic of the axial pump with pressure fluctuations based on time-and frequency-domain investigations. Iran J Sci Technol Trans Mech Eng 2021; 45: 441–459.

Kye

Park

Choi

, et al. Flow characteristics in a volute-type centrifugal pump using large eddy simulation. Int J Heat Fluid Flow 2018; 72: 52–60.

10.

Yan

Meng

GQQG

. Pressure fluctuation characteristics of centrifugal pump at low flow rate. IOP Conf Ser: Earth Environ Sci 2018; 163: 012023.

11.

Yang

S-S

Liu

H-L

Kong

F-Y

, et al. Effects of the radial gap between impeller tips and volute tongue influencing the performance and pressure pulsations of pump as turbine. J Fluids Eng 2014; 136; 054501.

12.

Xiao

Tan

. Design method of controllable velocity moment and optimization of pressure fluctuation suppression for a multiphase pump. Ocean Engineering 2021; 220: 108402.

13.

Liu

Tan

Cao

. Influence of geometry of inlet guide vanes on pressure fluctuations of a centrifugal pump. J Fluids Eng 2018; 140; 091204.

14.

Liu

Tan

, et al. Optimization design method of multi-stage multiphase pump based on Oseen vortex. J Pet Sci Eng 2020; 184: 106532.

15.

Al-Obaidi

Qubian

. Effect of outlet impeller diameter on performance prediction of centrifugal pump under single-phase and cavitation flow conditions. Int J Nonlin Sci Num 2022; 23: 1203–1229.

16.

Al-Obaidi

. Detection of cavitation phenomenon within a centrifugal pump based on vibration analysis technique in both time and frequency domains. Exp Tech 2020; 44: 329–347.

17.

Al-Obaidi

. Experimental investigation of the effect of suction valve opening on the performance and detection of cavitation in the centrifugal pump based on acoustic analysis technique. Arch Acoust 2019: 44(1); 59–69.

18.

Al-Obaidi

. Numerical investigation on effect of various pump rotational speeds on performance of centrifugal pump based on CFD analysis technique. Int J Model Simul Sci Comput 2021; 12: 2150045.

19.

Zhang

Gao

Wang

, et al. Effects of cutting the blade on the performance and pressure pulsation of a centrifugal pump. Energy Sci Eng 2020; 8: 1510–1523.

20.

E Khalifa

. Effect of blade exit shape on performance and vibration of a double volute centrifugal pump. Int J Mater Mech Manuf 2014; 2: 261–264.

21.

Zhang

Liu

Gao

, et al. Effects of modifying the blade trailing edge profile on unsteady pressure pulsations and flow structures in a centrifugal pump. Int J Heat Fluid Flow 2019; 75: 227–238.

22.

Gao

Zhang

, et al. Influence of the blade trailing edge profile on the performance and unsteady pressure pulsations in a low specific speed centrifugal pump. J Fluids Eng 2016; 138: 051106.

23.

Zhang

, et al. Effects of blade pressure side modification on unsteady pressure pulsation and flow structures in a centrifugal pump. J Fluids Eng 2021; 143: 111208.

24.

Zheng

, et al. Improve of unsteady pressure pulsation based on jet–wake suppression for a low specific centrifugal pump. J Fluids Eng 2021; 143: 111202.

25.

Al-Qutub

Khalifa

Khulief

. Experimental investigation of the effect of radial gap and impeller blade exit on flow-induced vibration at the blade-passing frequency in a centrifugal pump. Int J Rotating Mach 2014; 2009: 9.

26.

Al-Qutub

Khalifa

Al-Sulaiman

. Exploring the effect of V-shaped cut at blade exit of a double volute centrifugal pump. J Press Vessel Technol 2012; 134: 021301.

27.

Lin

, et al. Influence of impeller sinusoidal tubercle trailing-edge on pressure pulsation in a centrifugal pump at nominal flow rate. Energy Sci. Eng 2020; 143: 091205.

28.

Ding

Lin

Chang

, et al. Numerical study on the effect of blade trailing edge filing on performance and unsteady pressure pulsation in low specific speed centrifugal pump. J Vib Eng Technol 2023: 1–13.

29.

Cui

Zhang

. Effect of blade trailing edge cutting angle on unstable flow and vibration in a centrifugal pump. J Fluids Eng 2020; 142: 101203.

30.

Menter

. Two-equation eddy-viscosity turbulence models for engineering applications. AIAA J 1994; 32: 1598–1605.