Industrial processes require significant amounts of hot air, emphasizing the importance of developing efficient solar thermal systems to reduce dependency on fossil fuels and mitigate environmental impact. Most of the early studies focus on small-scale setups with lower airflow rates, limiting their applicability to industrial applications that require higher volumes of hot air. The primary focus of this work is to evaluate the impact of series and parallel thermal networking on the energy and enviro-economic performance of evacuated tube-based solar air heating systems, specifically for industrial process heating applications with moderate flow rates up to 1000 kg/h. A medium scale 42kWth experimental setup which consists of a blower, 28 sets of Evacuate Tube Solar Collector (ETSC) modules with 4 series and 7 parallel arrangements, baffle plates, a header, and a common duct, is developed. The airflow rate was adjusted across modules between 150 kg/h and 500 kg/h, maintaining a total airflow of 1000 kg/h at the outlet using control valves. Results indicate that the maximum average outlet temperature of 356 K was achieved at 150 kg/h. On clear sky days, the designed system can deliver hot air over 323 K at an operational flow rate of 150 kg/h between 9:30 a.m. and 4:00 p.m. The highest thermal efficiency was obtained at the higher operating flow rate of 500 kg/h. For the operating flow rate of 150 kg/h, the cost per kWh to provide hot air between 343 and 358 K is projected to be 0.0083$ (0.63 INR). The highest and least CO2 emission reductions were identified in the operating flow rates of 500 and 150 kg/h respectively. The average reduction in CO2 emissions is 19.68 tCO2 per year. Utilization of solar evacuate tube solar collector thermal networking can be deployed to reduce the environmental impact and fossil fuel dependancy. The system is more suitable for industrial process heating applications such as food product drying, paint drying, etc.
KumarLHasanuzzamanMRahimNA. Global advancement of solar thermal energy technologies for industrial process heat and its future prospects: a review. Energy Convers Manag2019; 195: 885–908. DOI: 10.1016/j.enconman.2019.05.081.
FarjanaSHHudaNMahmudMP, et al.Solar process heat in industrial systems – a global review. Renew Sustain Energy Rev2018; 82: 2270–2286. DOI: 10.1016/j.rser.2017.08.065.
4.
TianYZhaoCY. A review of solar collectors and thermal energy storage in solar thermal applications. Appl Energy2013; 104: 538–553. DOI: 10.1016/j.apenergy.2012.11.051.
5.
KalogirouSA. Solar thermal collectors and applications. Prog Energy Combust Sci2004; 30(3): 231–295. DOI: 10.1016/j.pecs.2004.02.001.
6.
XuLWangZYuanG, et al.“A new dynamic test method for thermal performance of all-glass evacuated solar air collectors”, Sol Energy, A new dynamic test method for thermal performance of all-glass evacuated solar air collectors2012; 86: 1222–1231. DOI: 10.1016/j.solener.2012.01.015.
7.
ChopraKTyagiVVPandeyAK, et al.“PCM integrated glass in glass tube solar collector for low and medium temperature applications: thermodynamic & techno-economic approach”. Energy2020; 198: 117238. DOI: 10.1016/j.energy.2020.117238.
8.
SabihaMASaidurRMekhilefS, et al.Progress and latest developments of evacuated tube solar collectors. Renew Sustain Energy Rev2015; 51: 1038–1054. DOI: 10.1016/j.rser.2015.07.016.
9.
LiangH. Experimental research on the all-glass evacuated tube solar air collector. ISES Sol. World Congr2007; 1(5): 674–677. DOI: 10.1007/978-3-540-75997-3_125.
10.
KumarAKumarSNagarU, et al.Experimental study of thermal performance of one-ended evacuated tubes for producing hot air. J. Sol. Energy2013; 2013: 1–6. DOI: 10.1155/2013/524715.
11.
KabeelAEKhairat DawoodMMShehataAI. Augmentation of thermal efficiency of the glass evacuated solar tube collector with coaxial heat pipe with different refrigerants and filling ratio. Energy Convers Manag2017; 138: 286–298. DOI: 10.1016/j.enconman.2017.01.048.
12.
BabuSKumarSChinnaM. Experimental investigation on the forced type evacuated tube solar collectors with and without absorber plate. Available at: https://www.ijpam.eu/.
13.
ZhangXYouSXuW, et al.Experimental investigation of the higher coefficient of thermal performance for water-in-glass evacuated tube solar water heaters in China. Energy Convers Manag2014; 78: 386–392. DOI: 10.1016/j.enconman.2013.10.070.
14.
YadavABajpaiVK. Thermal performance of one-ended evacuated tube solar air collector at different flow rates: experimental investigation. Int J Ambient Energy2012; 33(1): 35–50. DOI: 10.1080/01430750.2011.636207.
15.
WangTZhaoYDiaoY, et al.Performance of a new type of solar air collector with transparent-vacuum glass tube based on micro-heat pipe arrays. Energy2019; 177: 16–28. DOI: 10.1016/j.energy.2019.04.059.
16.
SinghIVardhanS. Experimental investigation of an evacuated tube collector solar air heater with helical inserts. Renew Energy2021; 163: 1963–1972. DOI: 10.1016/j.renene.2020.10.114.
17.
HamedTAAlkharabshehS. Design and performance analysis of a new evacuated tube solar air heaters equipped with fins and coils. Int J Sustain Energy2020; 39: 1–12. DOI: 10.1080/14786451.2020.1798446.
18.
Veera KumarAArjunanTSeenivasanD, et al.Influence of twisted tape inserts on energy and exergy performance of an evacuated Tube-based solar air collector. Sol Energy2021; 225: 892–904. DOI: 10.1016/j.solener.2021.07.074.
19.
ParkSRPandeyAKTyagiV, et al.Energy and exergy analysis of typical renewable energy systems. Renew Sustain Energy Rev2014; 30: 105–123. DOI: 10.1016/j.rser.2013.09.011.
20.
DaghighRShafieianA. Energy and exergy evaluation of an integrated solar heat pipe wall system for space heating. Sādhanā2016; 41: 877–886. DOI: 10.1007/s12046-016-0517-4.
21.
AtaeeSAmeriM. Energy and exergy analysis of all-glass evacuated solar collector tubes with coaxial fluid conduit. Sol Energy2015; 118: 575–591. DOI: 10.1016/j.solener.2015.06.019.
22.
KalairARSeyedmahmoudianMSaleemMS, et al.A comparative thermal performance assessment of various solar collectors for domestic water heating. Int J Photoenergy2022; 2022: 1–17. DOI: 10.1155/2022/9536772.
23.
SchnitzerHBrunnerCGwehenbergerG. Minimizing greenhouse gas emissions through the application of solar thermal energy in industrial processes. J Clean Prod2007; 15(13–14): 1271–1286. DOI: 10.1016/j.jclepro.2006.07.023.
24.
A Veera KumarVSSeenivasanDArjunanTV, et al.Solar thermal conversion technologies for process heating applications in automobile industries. In: Solar Thermal Conversion Technologies for Industrial Process Heating. Boca Raton: CRC Press, 2023, pp. 119–147.
25.
SaleemMSHaiderAAbasN, “Review of solar thermal water heater simulations using TRNSYS”. Power Gener. Syst. Renew. Energy Technol. PGSRET; 2015: 1–6, 2015. DOI: 10.1109/PGSRET.2015.7312251.
26.
Eiamsa-ArdPPiriyarungrojNThianpongC, et al.“A case study on thermal performance assessment of a heat exchanger tube equipped with regularly-spaced twisted tapes as swirl generators”. Case Stud Therm Eng2014; 3: 86–102. DOI: 10.1016/j.csite.2014.04.002.
27.
SaleemMSAbasN. Optimizing renewable polygeneration: a synergetic approach harnessing solar and wind energy systems. Results Eng2024; 21: 101743. DOI: 10.1016/J.RINENG.2023.101743.
28.
SaleemMSAbasN. A solar assisted grid-tied polygeneration system for hydrogen and electricity production: future of energy transition from electrons to molecules. Int J Hydrogen Energy2024; 69: 559–569. DOI: 10.1016/J.IJHYDENE.2024.05.082.
29.
V. K. A.Dhiraj Kumar YadavNSMalakarS. Evacuated tube solar collector-based drying system: analytical modeling, influencing factors, and recent progress in drying of agri-commodities. Food Eng Rev2024; 16: 1–28.
30.
UniyalAPrajapatiYKKumarD. Investigation of thermal performance and charging/discharging characteristics of finned coaxial evacuated tube collector filled with phase change material. Appl Therm Eng2024; 238: 122048. DOI: 10.1016/J.APPLTHERMALENG.2023.122048.
31.
El-FakharanyMKAbo-SamraAEAAbdelmaqsoudAM, et al.Enhanced performance assessment of an integrated evacuated tube and flat plate collector solar air heater with thermal storage material. Appl Therm Eng2024; 243: 122653. DOI: 10.1016/J.APPLTHERMALENG.2024.122653.
32.
AbrofarakhMMoghadamH. Investigation of thermal performance and entropy generation rate of evacuated tube collector solar air heater with inserted baffles and metal foam: a CFD approach. Renew Energy2024; 223: 120022. DOI: 10.1016/J.RENENE.2024.120022.
33.
Veera KumarAArjunanTVSeenivasanD, et al.“Thermal performance of an evacuated tube solar collector with inserted baffles for air heating applications”Sol Energy2021; 215: 131-143. DOI: 10.1016/j.solener.2020.12.037.
34.
VenkatramananRArjunanTSeenivasanD, et al.Parametric study of evacuated tube collector solar air heater with inserted baffles on thermal network for low-temperature applications. J Clean Prod2022; 367: 132941. DOI: 10.1016/j.jclepro.2022.132941.
35.
HillJEJenkinsJPJonesDE. Experimental verification of a standard test procedure for solar collectors. Department of Commerce, National Bureau of Standards. 1979; 117.
36.
MNRE STD 01. “MNRE Standard All Glass (Glass in Glass) Evacuated Solar Collector Tubes”. New Delhi, India: Ministry of New and Renewable Energy, 2013.
37.
SampathkumarKArjunanTVEswaramoorthyM, et al.Thermal modeling of a solar still coupled with evacuated tube collector under natural circulation mode — an experimental validation. Energy Sources, Part A Recover. Util. Environ. Eff2013; 35: 1441–1455. DOI: 10.1080/15567036.2010.527901.
38.
Veera KumarAArjunanTSeenivasanD, et al.Techno-Economic evaluation of an evacuated tube solar air collector with inserted baffles. Proc Inst Mech Eng Part E J. Process Mech. Eng2021; 235: 1027–1038. DOI: 10.1177/0954408921989847.
39.
MatheswaranMMArjunanTVSomasundaramD. Analytical investigation of solar air heater with jet impingement using energy and exergy analysis. Sol Energy2018; 161: 25–37. DOI: 10.1016/j.solener.2017.12.036.
40.
DhimanPThakurNSKumarA, et al.An analytical model to predict the thermal performance of a novel parallel flow packed bed solar air heater. Appl Energy2011; 88(6): 2157–2167. DOI: 10.1016/j.apenergy.2010.12.033.
41.
VijayanSArjunanTVKumarA, et al.Experimental and thermal performance investigations on sensible storage based solar air heater. J Energy Storage2020; 31: 101620. DOI: 10.1016/j.est.2020.101620.
42.
AbuM, “Energy, exergy, economic and environmental ( 4E) analyses of fl at-plate and V-groove solar air collectors based on aluminium and copper,”. Solar Energy2017; 158: 259–277. DOI: 10.1016/j.solener.2017.09.045.
43.
MatheswaranMMArjunanTVSomasundaramD. Energetic, exergetic and enviro-economic analysis of parallel pass jet plate solar air heater with artificial roughness. J Therm Anal Calorim2019; 136(1): 5–19. DOI: 10.1007/s10973-018-7727-4.
44.
TripathiRTiwariGNDwivediVK. Overall energy, exergy and carbon credit analysis of N partially covered Photovoltaic Thermal (PVT) concentrating collector connected in series. Sol Energy2016; 136: 260–267. DOI: 10.1016/j.solener.2016.07.002.
