Dynamic modeling and experimental investigations of a magnetostrictive nozzle

Abstract

A magnetostrictive nozzle–flapper servovalve pilot stage is presented in this article, which is directly driven by a giant magnetostrictive actuator and features three nozzles for the development of large flow rate servovalve. According to the energy conversion sequence in this servovalve, a giant magnetostrictive actuator magnetization model, a giant magnetostrictive material rod eddy loss model and a servovalve dynamic pressure model are all established to enable quantitative depiction and modelling of the dynamic pressure response process of magnetostrictive nozzle–flapper servovalve pilot stage. Consequently, the matched simulation model of the magnetostrictive nozzle–flapper servovalve pilot stage with the mathematic model is followed to be established, and two unknown parameters of complex permeability are determined using the test data from the giant magnetostrictive actuator. By running this simulation model, flapper displacement and output pressure under different structural parameters and variational excited frequencies are determined, certain parameters that are sensitive to the dynamic characteristics of magnetostrictive nozzle–flapper servovalve pilot stage driven by giant magnetostrictive actuator are found and the accompanying rules are revealed. Finally, the experimental system of a magnetostrictive nozzle–flapper servovalve pilot stage driven by giant magnetostrictive actuator was built; both the step-input voltage response curve and the sine-input voltage response curve were captured; and these curves show that the amplitude bandwidth (−3 dB) and the phase bandwidth (−90°) of a magnetostrictive nozzle–flapper servovalve pilot stage can approach 150 and 110 Hz, respectively, which exhibit good agreement with the simulation results. Therefore, the magnetostrictive nozzle–flapper servovalve pilot stage offers a very promising prospect of the novel servovalves with the high-frequency response and the large flow rate.

Keywords

System modeling system simulation servohydraulic systems dynamic modeling physical modelling

Get full access to this article

View all access options for this article.

References

Merritt

Hydraulic control systems. New York: John Wiley & Sons, 1967.

Jiang

. 3-D magnetic field analysis of hydraulic servo valve torque motor with magnetic fluid. In: Proceedings of the eighth international conference on electrical machines and systems (ICEMS), Nanjing, China, 29 September 2005, vol. 3, pp.2447–2450. New York: IEEE.

Gao

Yang

Evaluation and compensation of steady gas flow force on the high-pressure electro-pneumatic servo valve direct-driven by voice coil motor. Energ Convers Manage 2013; 67: 92–102.

Jiao

Yan

. Development of a direct-drive servo valve with high frequency voice coil motor and advanced digital controller. IEEE-ASME T Mech 2014; 19(3): 932–942.

Lindler

Anderson

. Piezoelectric direct driveservovalve. In: Industrial and commercial applications of smart structures technologies, San Diego, CA, 17 March 2002, SPIE Paper 4698-53, pp.1–9. Bellingham, WA: SPIE.

Zhou

Tian

. Control of a new type of direct drive piezoelectric servo valve. In: Proceedings of the 2004 IEEE international conference on robotics and biomimetics, Shenyang, China, 22–26 August 2004, pp.795–798. New York: IEEE.

Bang

Joo

Lee

. Development of a two-stage high speed electro-hydraulic servovalve systems using stack-type piezoelectric-elements. In: Proceedings of the 2003 IEEE/ASME international conference on advanced intelligent mechatronics, Kobe, Japan, 20–24 July 2003, pp.131–136. New York: IEEE.

Sangiah

Plummer

Bowen

. A novel piezohydraulic aerospace servovalve. Part I: design and modelling. Proc IMechE, Part I: J Systems and Control Engineering 2013; 227(4): 371–389.

Hiratsuka

Urai

Magnetic circuit design of a giant magnetostrictive actuator and application to a direct-drive servo-valve. Nippon Kikai Gakkai Ronbunshu, B Hen/Trans Jpn Soc Mech Eng Part B 1994; 570: 479–483.

10.

Urai

Tanaka

Development of a giant magnetostrictive tandem actuator and application to a servovalve. Nihon Yukuatsu Gakkai Ronbunshu 2001; 32(3): 53–57.

11.

Ding

Wang

. The study of pneumatic servo valve and inchworm based on GMM. J China Coal Soc 2002; 27(4): 440–443.

12.

Wang

Ding

Fang

Control pressure characteristics of nozzle flapper valve based on GMA. J Mech Eng 2005; 41(5): 127–130.

13.

Wang

Ding

Cui

Dynamic characteristics of nozzle flapper servo valve based on GMA. J Mech Eng 2006; 42(10): 23–26.

14.

Karunanidhi

Singaperumal

Design, analysis and simulation of magnetostrictive actuator and its application to high dynamic servo valve. Sensor Actuat A: Phys 2010; 157: 185–197.

15.

Zhu

Parameter optimization of jet-pipe servovalve driven by giant magnetostrictive actuator. Acta Aeronaut Astronaut Sin 2011; 32: 1336–1344.

16.

Zhu

Development of a deflector-jet electrohydraulic servovalve using a giant magnetostrictive material. Smart Mater Struct 2014; 23: 115001.

17.

Zhu

Yang

Wang

Development of a four-nozzle flapper servovalve driven by a giant magnetostrictive actuator. Proc IMechE, Part I: J Systems and Control Engineering 2015; 229(4): 293–307.

18.

Aung

A numerical study of cavitation phenomenon in a flapper-nozzle pilot stage of an electrohydraulic servo-valve with an innovative flapper shape. Energ Convers Manage 2014; 77: 31–39.

19.

Aung

Yang

Chen

. CFD analysis of flow forces and energy loss characteristics in a flapper-nozzle pilot valve with different null clearances. Energ Convers Manage 2014; 83: 284–295.

20.

Zhang

Cavity shedding dynamics in a flapper-nozzle pilot stage of an electro-hydraulic servo-valve: experiments and numerical study. Energ Convers Manage 2015; 100: 370–379.

21.

Pan

Wang

Flow field simulation and a flow model of servo-valve spool valve orifice. Energ Convers Manage 2011; 52: 3249–3256.

22.

Zhu

Theoretical and experimental investigations of the temperature and thermal deformation of a giant magnetostrictive actuator. Sensor Actuat A: Phys 2014; 218: 167–178.

23.

Olabi

Grunwald

Design and application of magnetostrictive materials. Mater Design 2008; 29: 469–483.

24.

Pradhan

SC.

Vibration suppression of FGM shells using embedded magnetostrictive layers. Int J Solids Struct 2005; 42: 2465–2488.

25.

Shang

Pan

Qin

Mathematical modeling and numerical computation for the vibration of a magnetostrictive actuator. Smart Mater Struct 2008; 17: 045026.

26.

Sun

Zheng

Numerical simulation on coupling behavior of Terfenol-D rods. Int J Solids Struct 2006; 43: 1613–1623.

27.

Valadkhan

Morris

Shum

A new load-dependent hysteresis model for magnetostrictive materials. Smart Mater Struct 2010; 19: 125003.

28.

Zheng

Cao

Wang

. Hybrid genetic algorithms for parameter identification of a hysteresis model of magnetostrictive actuators. Neurocomputing 2007; 70: 749–761.

29.

Zhou

Zheng

Zhou

Active vibration control of nonlinear giant magnetostrictive actuators. Smart Mater Struct 2006; 15: 792–798.

30.

Jiles

DC.

Modelling the effects of eddy current losses on frequency dependent hysteresis in electrically conducting media. IEEE T Magn 1994; 30: 4326–4328.

31.

Zhu

A hysteresis nonlinear model of giant magnetostrictive transducer. J Intel Mat Syst Str 2015; 26(16): 2242–2255.

Dynamic modeling and experimental investigations of a magnetostrictive nozzle–flapper servovalve pilot stage

Abstract

Keywords

Get full access to this article

References