A Stress Gradient-enhanced Piezoelectric Actuator Composite (GEPAC) with Integrated Ultrasonic NDE Capability for Continuous Health Monitoring

Abstract

Stress gradient-enhanced piezoelectric actuator composites (GEPACs) are unimorph, curved actuators that can be used as low-frequency actuators embedded, for instance, within an aircraft skin. The actuator is made of a thin PZT ceramic layer bonded between two composite layers with different coefficients of thermal expansion. These curved actuators provide large bending motion. Actuators have been manufactured with segmented upper electrodes so that they can also be used at ultrasonic frequencies to monitor continuously the integrity of the actuator itself. It is shown that the actuator can be used to detect interfacial defects such as debonding between the piezoelectric layer and the outer layers. The input signal is a one-cycle burst at 1 MHz. The time domain signals recorded experimentally are compared with predictions from a finite element model. It is shown that the presence of a debonding defect can convert a symmetric pulse into a primarily antisymmetric wave. A simple correlation technique is used to estimate the size of the debonding region.

Keywords

ultrasonic piezoelectric waveguides GEPAC actuators ultrasonic NDE

Get full access to this article

View all access options for this article.

References

Auld, B.A. 1990. Acoustic Fields and Acoustic Waves in Solids, 2nd edn, Krieger, Malabar .

Bechet, A. 2003. “Ultrasonic Detection of Debonding within a Gradient-Enhanced Piezoelectric Actuator Composite,” Master Thesis, Georgia Institute of Technology, Atlanta.

Bray, D.E. and Stanley, R.K. 1997. Nondestructive Evaluation, 2nd edn, CRC Press, Boca Raton .

Chen, W. and Lynch, C.S. 1998a. “A Model for Simulating Polarization Switching and AF-F Phase Changes in Ferroelectric Ceramics,” J. Intel. Mater. Syst. and Structures, 9: 427-431 .

Chen, W. and Lynch, C.S. 1998b. “A Micro Electromechanical Model for Polarization Switching in Ferroelectric Ceramics,” Acta Mater., 46(15): 5303-5311 .

Chimenti, D.E. 1997. “Guided Waves in Plates and their use in Materials Characterization,” Appl. Mech. Rev., 50(5): 247-284 .

Georgiou, G.A. and Bond, L.J. 1987. “Quantitative Studies in Ultrasonic Wave-defect Interaction,” Ultrasonics, 25: 328-333 .

Gex, D. 2004. “Ultrasonic NDE Testing of a GEPAC Undergoing Low Frequency Bending Excitation,” Master Thesis, Mechanical Engineering, Georgia Institute of Technology.

Goo, N.S. , Kim, C. , Park, H.C. and Yoon, K.J. 2001. “Performance Evaluation of Lightweight Piezocomposite Curved Actuators,” J. Intel. Mater. Syst. and Structures, 12(9): 639-646 .

10.

Haertling, G.H. 1994. “Rainbow Ceramic: A New Type of Ultra High Displacement Actuator,” Am. Ceram. Soc. Bull., 73: 93-96 .

11.

Ko, R.T. , Nagy, P.B. and Adler, L. 1992. “Experimental Study of Interface Properties Between Layer and Substrate,” Review of Progress in Quantitative Nondestructive Evaluation, 11: 1967-1973 .

12.

Lynch, C.S. 1998c. “On the Development of Multiaxial Phenomenoloical Cosntitutive Laws for Ferroelectric Ceramics,” J. Intel. Mater. Systems and Struct., 9(7): 24-30 .

13.

McCarthy, R.F. and Georgiou, G.A. 2000. “The Application of ABAQUS/Explicit to Ultrasonic Surface Wave Propagation Problems,” Insight, 42(11): 725-729 .

14.

Mossi, K.M. and Bishop, R.P. 1999. “Characterisation of Different Types of High Performance Thunder Actuators,” In: Proc. of SPIE Conference, Vol. 3675, pp. 43-52 .

15.

Nayfeh, A.H. 1995. Wave Propagation in Layered Anisotropic Media, North-Holland, Elsevier Science, Amsterdam .

16.

Nayfeh, A.H. and Chien, H.-T. 1992). “The Influence of Piezoelectricity on Free and Reflected Waves from Fluid-loaded Anisotropic Plates,” J. Acoust. Soc. Am., 91: 1250-1261 .

17.

Rose, J.L. 1999. Ultrasonic Waves in Solid Media, Cambridge University Press .

18.

Talreja, R. 1985. “Transverse Cracking and Stiffness Reduction in Composite Laminates,” J. Composite Materials, 19: 355-375 .

19.

Talreja, R. 1988). “Application of Acousto-ultrasonics to Quality Control and Damage Assessment of Composites,” In: Duke, J.C. (ed.), Acousto-Ultrasonics: Theory and Application, pp. 177-190, Plenum Publishing Co., New York .

20.

Valle, C. , Qu, J. and Jacobs, L.J. 1999. “Guided Circumferential Waves in Layered Cylinders,” Int. J. Eng. Science, 37: 1369-1387 .

21.

Viktorov, I.A. 1967. Rayleigh and Lamb Waves, Plenum Press, New York .

22.

Yoon, K.J. , Chung, J.H. , Goo, N.S. and Park, H.C. 2001. “Thermal Deformation and Residual Stress Analysis of Lightweight Piezo-composite Curved Actuator Device,” In: Proc. of SPIE Conference, Vol. 4333, pp. 418-425 .