Geometrical Nonlinear Deformation Effects in Composite Sandwich Plates Subjected to In-Plane Shear Loads

Abstract

An experimental and analytical study is presented to investigate the nonlinear behavior of foam core sandwich plates subjected to in-plane shear loads. Due to the low flexural stiffness of sandwich structures, the geometrical nonlinear deformation effects tend to appear earlier in foam core sandwich plates than in other laminated and sandwich plates. However, the analysis performed is applicable to any laminated or sandwich composite plate. In studies presented herein the Theorem of Minimum Potential Energy has been used to determine the deflections, strains, and stresses in the plate. Polynomial functions are used that satisfy all of the boundary conditions. It is seen from the analytical results that the lateral deflection and the in-plane shear strains and stresses are nonlinear functions of the applied loads. In addition, the in-plane normal strains do occur under the laterally applied loads which cause the inequality of principle strains between the compressive face strains and the tensile face strains.

Keywords

Foam core sandwich in-plane shear loads nonlinear deformation

Get full access to this article

View all access options for this article.

References

1. Nadai, A. (1925). Die Elastischen Platten, Springer-Verlag, Berlin .

2. Vinson, J.R. (1997). In-plane Shear Strength Determination of Composite Materials in Laminated and Sandwich Panels , In: Proc., Appl. Mech. Rev., ASME, 50(11): Part 2, S237–S240 .

3. Ebrahimpour, A. , Vinson, J.R. and Thomsen, O.T. (2001). Experimental and Analytical Study on the Behavior of Foam Core Sandwich Composite Plates Subjected to In-plane Shear Stress, American Institute of Aeronautics and Astronautics, AIAA Paper-2001–1220.

4. Bau-Madsen, N. K. , Svendsen, K.-H. and Kildegaad, A. (1993). Large Deflection of Sandwich Plates – an Experimental Investigation , Composite Structures, 23: 47–52 .

5. Wennhauge, P. and Zenkert, D. (1998). Testing of Sandwich Panels Under Uniform Pressure , Journal of Testing and Evaluation, 26: 101–108 .

6. Riber, H.J. (1997). Non-linear Analytical Solutions for Laterally Loaded Sandwich Plates . Composite Structures, 39, 63–83 .

7. Chuen-Yuan Chia (1980). Nonlinear Analysis of Plates, McGraw-Hill, New York .

8. Vinson, J.R. and Sierakowski, R.L. (2002). The Behavior of Structures Composed of Composite Materials, 2nd edn, Kluwer Academic Publishers, Dordrecht, The Netherlands .

9. Wang, J. , Glancey, J.L. and Vinson, J.R. (November 2002) Transverse Shear Deformation Effects in Laminated and Sandwich Panels Subjected to In-plane Shear Loads , In: Proceedings of the 2002 ASME IMECE, New Orleans.