Localized Effects in the Nonlinear Behavior of Sandwich Panels with a Transversely Flexible Core

Abstract

This paper presents the results of an investigation of the role of localized effects within the geometrically nonlinear domain on structural sandwich panels with a “compliant” core. Special emphasis is focused on the nonlinear response near concentrated loads and stiffened core regions. The adopted nonlinear analysis approach incorporates the effects of the vertical flexibility of the core, and it is based on the approach of the High-order Sandwich Panel Theory (HSAPT). The results demonstrate that the effects of localized loads, when taken into the geometrically nonlinear domain, change the response of the panel from a strength problem controlled by stress constraints into a stability problem with unstable limit point behavior when force-controlled loads are applied. The stability problem emerge as the nonlinear response develops with the formation of a small number of buckling waves in the compressed face sheet in the vicinity of the localized loads. The development of the nonlinear response is demonstrated through the numerical study of three-point bending of a unidirectional sandwich panel with an unstiffened core, and with a core stiffened in the vicinity of the loads, respectively. It is shown, that the change from unstiffened to stiffened core alters the nonlinear response significantly. The nonlinear response is described in terms of deflections and stress resultants in the face sheets, as well as in terms of the interfacial stress components at the upper and lower face–core interfaces. The overall nonlinear response is described through curves of the load versus the extreme absolute values of the aforementioned structural quantities. A very important finding of the study is that stiffening of the core may improve the performance in terms of local stresses to some extent, but at the same time it may lead to undesirable bifurcation-type or semi elastoplastic behavior in some cases.

Keywords

localized effects sandwich structures high-order theory geometric nonlinearity local buckling limit point behavior snap through failure modes reinforced cores

Get full access to this article

View all access options for this article.

References

Kim, J. and Swanson, S.R. (2001). Design of Sandwich Structures for Concentrated Loads , Composite Structures, 52(3–4): 365–373 .

Allen, H.G. (1969). Analysis and Design of Structural Sandwich Panels, Pergamon Press, London .

Plantema, F.J. (1966). Sandwich Construction, John Wiley and Sons, New York .

Enkert, D. (1995). An Introduction to Sandwich Construction, Chameleon Press Ltd, London .

Vinson, J.R. (1999). The Behavior of Sandwich Structures of Isotropic and Composite Materials, Technomic Publishing Co. Inc, Lancaster .

Noor, A.K. , Burton, W.S. and Bert, C.W. (1996). Computational Models for Sandwich Panels and Shells , Applied Mechanics Review, 49: 155–199 .

Mindlin, R.D. (1951). Influence of Transverse Shear Deformation on the Bending of Classical Plates, Transaction of ASME , Journal of Applied Mechanics, 8: 18–31 .

Reddy, J.N. (1984). Energy and Variational Methods in Applied Mechanics, John Wiley and Sons Inc., New York .

Thomsen, O.T. (1993). Analysis of Local Bending Effects in Sandwich Plates with Orthotropic Face Layers Subjected to Localised Loads , Composite Structures, 25: 511–520 .

10.

Thomsen, O.T. (1995). Theoretical and Experimental Investigation of Local Bending Effects in Sandwich Plates , Composite Structures, 30(1): 85–101 .

11.

Zenkert, D. (ed.) (1997). The Handbook of Sandwich Construction, North European Engineering and Science Conference Series, EMACS, UK .

12.

Frostig, Y. , Baruch, M. , Vilnay, O. and Sheinman, I. (1992). A High Order Theory for the Bending of Sandwich Beams with a Flexible Core , Journal of ASCE, EM Division, 118(5): 1026–1043 .

13.

Frostig, Y. (1992). Behavior of Delaminated Sandwich Beams with Transversely Flexible Core – High Order Theory , Composite Structures Journal, 20: 1–16 .

14.

Frostig, Y. and Baruch, M. (1993). Buckling of Simply-Supported Sandwich Beams with Transversely Flexible Core – A High Order Theory , Journal of ASCE, EM Division, 119(3): 476–495 .

15.

Frostig, Y. (1993). On Stress Concentration in the Bending of Sandwich Beams with Transversely Flexible Core , Composite Structures, 24: 161–169 .

16.

Frostig, Y. and Baruch, M. (1996). Localized Load Effects in High-Order Bending of Sandwich Panels with Transversely Flexible Core , Journal of ASCE, EM Division, 122(11): 1069–1076 .

17.

Frostig, Y. (1998). Buckling of Sandwich Panels with a Transversely Flexible Core – High-Order Theory , International Journal of Solids and Structures, 35(3–4): 183–204 .

18.

Thomsen, O.T. and Frostig, Y. (1997). Localized Bending Effects in Sandwich Panels: Photoelastic Investigation versus High-Order Sandwich Theory Results , Composite Structures, 37(1): 97–108 .

19.

Thomsen, O.T. and Rits, W. (1998). Analysis and Design of Sandwich Plates with Inserts – A High-Order Sandwich Plate Theory , Composites: Part B, Engineering, 29(6): 795–807 .

20.

Sokolinsky, V. and Frostig, Y. (2000). Branching Behavior in the Non-Linear Response of Sandwich Panels with a Transversely Flexible Core , International Journal of Solids and Structures, 37: 5745–5772 .

21.

Sokolinsky, V.S. , Frostig, Y. and Nutt, S.R. (2002). Special Behavior of Sandwich Panels with Transversely Flexible Core Under Statical Loading , International Journal of Non-Linear Mechanics, Special Issue in Honor of Prof. Johann Arbocz at his Retirement from the Delft University of Technology, 37(4–5): 869–895 .

22.

Swanson, S.R. (1999). An Examination of a High-Order Theory for Sandwich Beams , Composite Structures, 44(2–3): 169–177 .

23.

Petras, A. and Sutcliffe, M.P.F. (1999). Indentation Resistance of Sandwich Beams , Composite Structures, 46(4): 413–424 .

24.

Petras, A. and Sutcliffe, M.P.F. (2000). Indentation Failure Analysis of Sandwich Beams , Composite Structures, 50(3): 311–318 .

25.

Schwarts-Givli, H. and Frostig, Y. (2001). High-Order Behavior of Sandwich Panels with a Bilinear Transversely Flexible Core , Composite Structures, 53(1): 87–106 .

26.

Sokolinsky, V.S. , Shen, H. , Vaikhanski, L. and Nutt, S.R. (2003). Experimental and Analytical Study of Nonlinear Bending Response of Sandwich Beams , Composite Structures, 60(2): 219–229 .

27.

Swanson, S.R. and Kim, J. (2003). Design of Sandwich Structures under Contact Loading , Composite Structures, 59(3): 403–413 .

28.

Swanson, S.R. and Kim, J. (2002). Optimization of Sandwich Beams for Concentrated Loads , Composite Structures, Journal of Sandwich Structures and Materials, 4(3): 273–293 .

29.

Stoer, J. and Bulirsch, R. (1980). Introduction to Numerical Analysis, Springer, New York .

30.

Keller, H.B. (1992). Numerical Methods For Two-Point Boundary Value Problems, Dover Publications, New York .