A numerical study of the energy-absorption characteristics of metal tube-reinforced polymer foams

Abstract

This article investigates the energy-absorbing behaviour of lightweight foam structures reinforced with aluminium and steel cylindrical tubes. Initial testing focuses on establishing the influence of the inner diameter to thickness ratio (D/t) of the metal tubes on their specific energy-absorption characteristics under quasistatic compression and low velocity impact loading. Following this, individual metal tubes are embedded in a range of crosslinked PVC foams, and the specific energy-absorption characteristics of these reinforced systems are determined. The effect of increasing the number of tubes on the energy-absorbing response of the tube-reinforced structures is also studied. The crushing responses of both aluminium and steel structures are then predicted using the finite element analysis package Abaqus/Explicit, and the predictions of the load–displacement responses and the associated failure modes are compared to experimental results. Agreement between the numerical predictions and the experimental data is good across the range of structures investigated, with the model accurately predicting the compression response and failure characteristics observed in the structures. It has been shown that the stiffness of the foam does not significantly alter the energy-absorbing behaviour of the stiffer metal tubes, suggesting that the density of the foam should be as low as possible, whilst maintaining the structural integrity of the part.

Keywords

Energy absorption sandwich finite element aluminium tube steel tube PVC foams

Get full access to this article

View all access options for this article.

References

Alexander

. An approximate analysis of the collapse of thin cylindrical shells under axial loading. Q J Mech Appl Maths 1960; 9: 10–15.

Jones

. Energy-absorbing effectiveness factor. Int J Impact Eng 2010; 37: 754–765.

Reid

. Plastic deformation mechanisms in axially compressed metal tubes used as impact energy absorbers. Int J Mech Sci 1993; 35: 1035–1052.

Gupta

Venkatesh . A study of the influence of diameter and wall thickness of cylindrical tubes on their axial collapse. Thin Walled Struct 2006; 44: 290–300.

Jones

. Structural impact, 2nd ed. Cambridge: Cambridge University Press, 2011.

Davies

Magee

. The effect of strain-rate upon the tensile deformation of materials. J Eng Mater Technol 1975; 97: 151–155.

Hsu

Jones

. Dynamic axial crushing of aluminium alloy 6063-T6 circular tubes. Latin Am J Solids Struct 2004; 1: 277–296.

Seitzberger

Rammerstorfer

Degischer

. Crushing of axially compressed steel tubes filled with aluminium foam. Acta Mech 1997; 125: 93–105.

Kavi

Toksoy

Guden

. Predicting energy absorption in a foam-filled thin-walled aluminum tube based on experimentally determined strengthening coefficient. Mater Des 2006; 27: 263–269.

10.

Del Piero

Pampolini

. The influence of viscosity on the response of open-cell polymeric foams in uniaxial compression: experiments and theoretical model. Continuum Mech Thermodyn 2012; 24: 181–199.

11.

Found

Robinson

Carruthers

. The influence of FRP inserts on the energy absorption of a foam-cored sandwich panel. Compos Struct 1997; 38: 373–381.

12.

Al Galib

Limam

. Experimental and numerical investigation of static and dynamic axial crushing of circular aluminum tubes. Thin Walled Struct 2004; 42: 1103–1137.

13.

Yan

Durif

Yamada

Wen

. Crushing simulation of foam-filled aluminium tubes. Mater Trans 2007; 48: 1901–1906.

14.

Chen

Wierzbicki

. Relative merits of single-cell, multi-cell and foam-filled thin-walled structures in energy absorption. Thin Walled Struct 2001; 39: 287–306.

15.

Alia

Guan

Jones

. The energy-absorption characteristics of metal tube reinforced polymer foams. J Sandw Struct Mater 2014; 17: 74–94.

16.

Dassault Systèmes, Abaqus 6.13 documentation, 2013.

17.

Hooputra

Gese

Dell

. A comprehensive failure model for crashworthiness simulation of aluminium extrusions. Int J Crashworthiness 2004; 9: 449–464.

18.

Deshpande

Fleck

. Multi-axial yield behaviour of polymer foams. Acta Mater 2001; 49: 1859–1866.

19.

Pled F, Yan W and Wen C. Crushing modes of aluminium tubes under axial compression. In: Presented at the 5th Australasian Congress on Applied Mechanics, ACAM 2007, Brisbane, Australia, 2007.