Developing environmentally friendly rolling lubricants

Abstract

Swerea MEFOS pilot mill has been used as a rolling lubricant development tool. The objectives were to improve the lubrication during rolling and thereby improve the operation of the rolling mills. This was done taking into account both the technological aspect, rolling mill output, and the ecological aspect, investigating ways to use rolling lubricants that are more ecologic sustainable, i.e. alternatives to oil-based lubricants as well as the recycling/recovering of oil-based lubricants. Oil-in-water emulsions and an aqueous solution, by the producer termed a conditional emulsion, were tested where the lubricant formulation was altered to optimize the performance for hot rolling of aluminium. Cold-rolling tests were also run on steel coils, where the presence of rust protective oil was studied as well as the influence of aged emulsion behaviour compared with fresh emulsion. Finally, Sapa developed a vacuum evaporator system for recovering oil from dumped emulsion generated during aluminium hot rolling, followed by separation, centrifugation, and flocculation. The cleaned concentrates were reconditioned for reuse. The recycled and recovered emulsion was tested and compared with the original fresh emulsion in Swerea MEFOS pilot mill with results as good as the fresh emulsion.

Keywords

hot rolling cold rolling emulsion pilot mill recycling

Get full access to this article

View all access options for this article.

References

Schmid

S. R.

Wilson

W. R. D.

Lubrication mechanisms for oil-in-water emulsions. Lubr. Eng., 1996, 52, 168–175.

Kimura

Okada

Film thickness at elastohydrodynamic conjunctions lubricated with oil-in-water emulsions. Proc. IMechE, Part C: J. Mechanical Engineering Science, 1987, 176, 85–90.

Salagean

Spikes

H. A.

Riffe

H. L.

Optimizing film formation by oil-in-water emulsions. Tribol. Trans., 1997, 40, 569–578.

Chen

U. C.

Liu

Y. S.

Chang

C. C.

Lin

J. F.

The effect of additive concentration in emulsions to the tribological behaviour of a cold rolling tube under sliding contact. Tribol. Int., 2002, 35, 309–320.

Raulf, M., et al. Optimization of rolling lubricants for improved operation of cold rolling mills. RFCS Project RFC-CR-04019, 2009.

Österholm

L. H.

Recycling of rolling oil emulsions: Toward an environmentally friendly and sustainable process. RFCS 7210-PR/098., 2001.

Gemma

Alberto

José

M. B.

José

Carmen

Treatment of a waste oil-in-water emulsion from a copper-rolling process by ultrafiltration and vacuum evaporation. J. Hazard. Mater., 2011, 185, 1569–1574.

Gemma

Ángel

José

M. B.

Carmen

José

The effect of additives on the treatment of oil-in-water emulsions by vacuum evaporation. J. Hazard. Mater., 2007, 144, 649–654.

Salager, J. L. Formulation concepts for the emulsion maker. In Pharmaceutical emulsions and suspensions (Eds F. Nielloud and G. Marti-Mestres), Drugs and Pharmaceutical Science Series, vol. 105, 2000, ch. 2, pp. 19–72 (Marcel Dekker, New York).

10.

Bajouk

B. M.

Sköld

R. O.

Association and solubility studies of mixed polyglycol ether surfactants in water. Colloids Surf. A, 2003, 212, 65–77.