A numerical and experimental friction analysis of reciprocating hydraulic ‘U’ rod seals

Abstract

This article is focused on the comparison between experimental and numerical friction forces obtained for a typical hydraulic ‘U’ rod seal. The numerical results are obtained by the inverse hydrodynamic lubrication method. The experimental results have been obtained on an original experimental device capable of measuring the friction force between a rod and two seals. The reciprocating rod speed, the temperature and pressure in the test cell are controlled. Despite the fact that the numerical results correspond to an idealized hydrodynamic problem for smooth surfaces, it was found that the numerical model agrees with experimental data when the predicted film thickness is higher than the rod roughness but largely lower than the seal roughness. This suggests that the roughness of the seal disappears under the pressure in the sealed contact and do not play an essential role in the lubrication mechanisms. However, it is clear that for very small film thickness, the full film lubrication theory for smooth surfaces is not convenient. This may imply that in these conditions mixed lubrication cannot be ignored or that adhesion phenomena, not taken into account by the lubrication theory, can appear in the contact areas.

Keywords

Elastomeric seals rod seals inverse hydrodynamic lubrication

Get full access to this article

View all access options for this article.

References

White

Denny

. The sealing mechanism of flexible packings. Scientific and Technical Memorandum 3/47, 1947, UK Ministry of Supply.

O’Donoghue

Lawrie

. The mechanism of lubrication in a reciprocating seal. In: Proceedings of the second BHRA international conference on fluid sealing, Cranfield, UK, 6–8 April 1964, vol. B6, paper no. H2, pp.H2-17–H2-32. Barlow: BHRA.

Kanters

AFC

Vissher

. Lubrication of reciprocating seals: experiments on the influence of surface roughness on friction and leakage. In: Proceedings of the 31st Leeds– Lyon symposium on tribology, University of Leeds, UK, 1989, Tribology Series, vol. 14, pp.69–77. New York: Elsevier.

Rana

Sayles

Nikas

. An experimental technique for investigating the sealing principles of reciprocating elastomeric seals for use in linear hydraulic actuator assemblies. In: Proceedings of the 2nd world tribology congress, Vienna, Austria, 3–7 September 2001, CD-ROM.

Rana

Sayles

. An experimental study on the friction behavior of aircraft hydraulic actuator elastomeric reciprocating seals. Tribol Interface Eng Ser 2005; 48: 507–515.

Nau

. An historical review of studies of polymeric seals in reciprocating hydraulic systems. Proc IMechE Part J: J Engineering Tribology 1999; 213(3): 215–226.

Nikas

. Eighty years of research on hydraulic reciprocating seals: review of tribological studies and related topics since the 1930s. Proc IMechE Part J: J Engineering Tribology 2010; 224(1): 1–23.

Salant

Maser

Yang

. Numerical model of a reciprocating hydraulic rod seal. ASME J Tribol 2007; 129: 91–97.

Thate

Salant

. Transient EHL analysis of an elastomeric hydraulic seal. Tribol Int 2009; 42(10): 1424–1432.

10.

Kanters

AFC

Verest

JFM

Visscher

. On reciprocating elastomeric seals: calculation of film thicknesses using the inverse hydrodynamic lubrication theory. Tribol Trans 1990; 33(3): 301–306.

11.

Nikas

Burridge

Sayles

. Modelling and optimization of rotary vane seals. Proc IMechE Part J: J Engineering Tribology 2007; 221(6): 699–715.

12.

Nikas

. Transient elastohydrodynamic lubrication of rectangular elastomeric seals for linear hydraulic actuators. Proc IMechE Part J: J Engineering Tribology 2003; 217(6): 461–473.

13.

Fatu

Hajjam

. Numerical modelling of hydraulic seals by inverse lubrication theory. Proc IMechE Part J: J Engineering Tribology 2011; 225(12): 1159–1173.

14.

Nikas

Sayles

. Study of leakage and friction of flexible seals for steady motion via a numerical approximation method. Tribol Int 2006; 39(9): 921–936.