Investigation of open air and under water laser surface texturing on surface roughness and wettability of Al-Mg alloy

Aluminum-Magnesium (Al-Mg) alloy is widely used in aerospace and marine related applications due to its high corrosion resistance, tensile strength and ductility properties. However, due to hydrophilic nature, its applications are restricted in areas where water absorption may cause problems like corrosion. In this research work, high speed laser texturing was carried out on Al-Mg alloy (AA5754) to improve hydrophobic properties of the material surface. Four different types of pattern, namely lines, grids, concentric circles and concentric rectangles were created on the material surface using a nanosecond fiber laser. Scanning speed was varied at two levels i.e., 500 mm/s and 1000 mm/s. Line density of texture designs was also varied at two levels of 10 lines per mm and 15 lines per mm. The texturing process was carried out in two different processing environment namely open air and in underwater condition. Distilled water with 1 mm thickness above the surface was used during underwater texturing condition. Surface morphology, surface roughness and wettability of all the surfaces were studied for all the experimental conditions. It was observed that lower scanning speed of 500 mm/s resulted in higher values of surface roughness and contact angles. Also, larger texture density leads to lower surface roughness and contact angles for all the pattern designs. Among all the studied texture patterns, grid structures, textured at 500 mm/s of scanning speed resulted in largest surface roughness and surface hydrophobicity.