An experimental investigation on the interdependency between the maximal pressure and ion current in a spark-ignition engine was conducted in this work. Eight ion current sensors were located centrally symmetric in a gasket between the cylinder and its head. The measurements of the ion current and the start timing, peak timing and end timing of the ion current were compared and the optimized interdependency between the maximal pressure and characteristic parameter of ion current was investigated. Experimental results show that the peak timing and the end timing of the ion current depend strongly on the start timing of the ion current for each ion sensor. The interdependency between the maximal pressure and start timing detected from the sensors near the intake port is better than that of the exhaust port. Furthermore, interdependency between the maximal pressure and average start timing from sensors 3 to 7 were found to give the best performance regardless the engine test conditions. The maximum pressure and average start timings were found to vary inversely with increasing intake pressure, ignition timing and excess air fuel ratio.
AbhijitANaberJGeorgeG. Ionization signal response during combustion knock and comparison to cylinder pressure for SI engines. SAE paper 2008-01-0981, 2008.
2.
AbhijitANaberJGeorgeG. Correlation analysis of ionization signal and air fuel ratio for a spark ignited engine. SAE paper 2009-01-0584, 2009.
3.
SchneiderDLaiMD. Real-time air/fuel ratio control in a small SI engine using the ionic current signal. SAE paper 1999-01-3323, 1999.
4.
KlövmarkHRaskPForssellU. Estimating the air/fuel ratio from Gaussian parameterizations of the ionization currents in internal combustion SI engines. SAE paper 2000-01-1245, 2000.
5.
WilstermannHGreinerAHohnerP. Ignition system integrated AC ion current sensing for robust and reliable online engine control. SAE paper 2000-01-0553, 2000.
6.
UpadhyayDNarayananVYooI. AFR control on a single cylinder engine using the ionization current. SAE paper 980203, 1998.
7.
RivaraNDickinsonPShentonA. A transient virtual-AFR sensor using the in-cylinder ion current signal. Mech Systems Signal Process2009; 23(5): 1672–1682.
8.
KinoshitaMSaitoAMogiK. Study on ion current and pressure behavior with knocking in engine cylinder. JSAE Rev2000; 21(4): 483–488.
9.
DeeJKujawskiDTuzinkewichJ. System for producing product gas used in e.g. diesel engine comprises electric current applied to anode/cathode plates of electrolytic cell to generate the gas by dissociating stoichiometric mixture of hydrogen, hydroxide ions and oxygen. Inventor, US2011100803-A1, 2011.
10.
AttardPMicallefJ. Ion current combustion technology for controlled auto-ignition gasoline engines. Int J Engine Research2007; 8(5): 429–437.
11.
HellringMHolmbergU. A comparison of ion-current-based algorithms for peak pressure position control. SAE paper 2001-01-1920, 2001.
12.
SaitzkoffAMReinmannRMaussF. In-cylinder pressure measurements using the spark plug as an ionization sensor. SAE paper 970857, 1997.
13.
PeronLCharletAHigelinP. Limitations of ionization current sensors and comparison with cylinder pressure sensors. SAE paper 2000-01-2830, 2000.
14.
LitakGKaminskiTCzarnigowskiJ. Combustion process in a spark ignition engine: analysis of cyclic peak pressure and peak pressure angle oscillations. Meccanica2009; 44(1): 1–11.
15.
LeeJGKimKSantaviccaDA. Measurement of equivalence ratio fluctuation and its effect on heat release during unstable combustion. Proc Combust Inst2000; 28(1): 415–421.
16.
DrakeMCHaworthDC. Advanced gasoline engine development using optical diagnostics and numerical modeling. Proc Combust Inst2007; 31(1): 99–124.
17.
RivaraNDickinsonPShentonA. A neural network implementation of peak pressure position control by ionization current feedback. J Dyn Systems Measure Control2009; 131(5): 1–8.
18.
WickstromNTavenikuMLindeA. Estimating pressure peak position and air-fuel ratio using the ionization current and artificial neural networks. In: Intelligent transportation system, ITSC ’97, IEEE Conference, 1997, pp. 972–977.
19.
HellringMHolmbergU. An ion current based peak-finding algorithm for pressure peak position estimation. SAE paper 2000-01-2829, 2000.
20.
FrankeAReinmannRLarssonA. The role of the electrodes for the ionization sensor signal. SAE paper 2003-01-0714, 2003.
21.
YoshiyamaSTomitaEHamamotoY. Fundamental study on combustion diagnostics using a spark plug as ion probe. SAE paper 2000-01-2828, 2000.
22.
WuXMGaoZQJiangDM. Experimental investigation of the effect of electrodes on the ionization current during combustion. Energy Fuels2008; 22(5): 2941–2947.
23.
BoginGChenJYDibbleRW. The effects of intake pressure, fuel concentration and bias voltage on the detection of ions in a homogeneous charge compression ignition (HCCI) engine. Proc Combust Inst2009; 32(2): 2877–84.
24.
VressnerA. Studies on the load range of an HCCI engine using in-cylinder pressure ion current and optical diagnostics. in Department of Energy Sciences2007, Lund University, 2007.
25.
VressnerAHultqvistATunestalP. Fuel effects on ion current in an HCCI engine. SAE paper 2005-01-2093, 2005.
26.
VressnerAStrandhPHultqvistA. Multiple point ion current diagnostics in an HCCI engine. SAE paper 2004-01-0934, 2004.
27.
NaganoTWatanabeMAisawaN. Ignition device for internal combustion engine has control part, which controls electromagnetic wave supply part based on ion-current value measured by ion-current measurement part. Inventor, JP2011132900-A, 2011.
28.
KusuharaIYamagataKMinamiguchiM. Ion-current detection apparatus for use in internal combustion engine i.e. automobile engine, has resistive element positioned between connection point of diode and parallel circuit and secondary-coil. Inventor, JP2011117330-A, 2011.
29.
WitzePO. Interpretation of head-gasket ionization-probe measurements using a two-zone spherical flame model. In: Proceedings of International Symposium COMODIA, 1994, pp. 453–458.
30.
YoshiyamaSTomitaETabuchiN. Combustion diagnostics of a spark ignition engine by using gasket ion sensor. JSAE paper 2003-01-1801, 2003.
31.
YoshiyamaSTomitaETabuchiN. Detection of flame propagation pattern in a spark ignition engine using gasket ion sensor. SAE paper 2004-01-1919, 2004.
32.
BadawyTRaiNSinghJ. Effect of design and operating parameters on the ion current in a single-cylinder diesel engine. Int J Engine Research2011; 12(6): 601–616.
33.
HeywoodJB. Internal combustion engine fundamentals. New York: McGraw-Hill, 1988.
34.
ErikssonLNielsenL. Ionization current interpretation for ignition control in internal combustion engines. Control Eng Pract1997; 5(8): 1107–1113.
35.
CalcoteHF. Mechanisms for the formation of ions in flames. Combust Flame1957; 1(4): 385–403.
36.
HallMJ. The influence of fluid motion on flame kernel development and cyclic variation in a spark ignition engine. SAE paper 890991, 1989.
37.
ZhengSZZhangXSheZY. Study on cycle-by-cycle variations of ion current integral and pressure in spark ignition engine. In: International conference on electronic & mechanical engineering and information technology, 2011.
38.
ZhengJJHuangZHWangJH. Effect of compression ratio on cycle-by-cycle variations in a natural gas direct injection engine. Energy Fuels2009; 23(11): 5357–5366.
39.
ZervasE. Correlations between cycle-to-cycle variations and combustion parameters of a spark ignition engine. App Thermal Eng2004; 24(14–15): 2073–2081.
40.
RodgersJLNicewanderWA. Thirteen ways to look at the correlation coefficient. Am Stat1998; 42(1): 59–66.
41.
BrogdenHE. On the interpretation of the correlation coefficient as a measure of predictive efficiency. J Educ Psychol1946; 37(2): 65–76.
42.
ChatillonG. The balloon rules for a rough estimate of the correlation coefficient. Am Stat1984; 38(1): 58–60.
43.
MarksE. A note on the geometric interpretation of the correlation coefficient. J Educ Stat1982; 7(3): 233–237.
44.
EgolfopoulosFNChoPLawCK. Laminar flame speeds of methane-air mixtures under reduced and elevated pressures. Combust Flame1989; 76(3–4): 375–391.
45.
MoenIOLeeJHSHjertagerBH. Pressure development due to turbulent flame propagation in large-scale methane-air explosions. Combust Flame1982; 47(1): 37–52.
46.
KnopVMichelJBColinO. On the use of a tabulation approach to model auto-ignition during flame propagation in SI engines. App Energy2011; 88(12): 4968–4979.
47.
FriedmanRJohnstonW. The wall-quenching of laminar propane flames as a function of pressure temperature and air-fuel ratio. J App Phys1950; 21(8): 791–795.
48.
AleiferisPGTaylorAMKPIshiiK. The nature of early flame development in a lean-burn stratified-charge spark-ignition engine. Combust Flame2004; 136(3): 283–302.
