Physical and mechanical properties of electrospun polyvinyl alcohol (PVA) were related to electrospinning process parameters through fabricated structures, fiber morphology, and diameters. The effects of electrospinning voltage, flow rate and distance between needle tip and collector on tensile strength, strain at maximum load, burst strength, and air permeability were investigated. The results showed that higher applied voltage, lower flow rate, and shorter distance gave higher tensile strength. However, burst strength had critical points during the changes of the above three parameters while all the measured data were in a narrow range. Higher voltage and longer distance caused the lower air permeability. PVA/Laponite® nanocomposites were produced by electrospinning and tensile strength and flammability of electrospun PVA/Laponite® structures were studied. The results indicated that introduction of Laponite® nanoclay to electrospun PVA structure decreased the tensile strength and strain at maximum load. The low orientation of Laponite® nanoclay along the fibers due to the low aspect ratio of Laponite® resulted in lower tensile strength of electrospun PVA webs. The flammability of electrospun webs was characterized by burning rate. Electrospun PVA/Laponite® had slower burning rate than that of pure PVA and thus flame resistance of PVA webs was improved by adding Laponite® nanoclay. The increase in flame retardation is attributed to slower decomposition of PVA/Laponite ® membranes.
Kim, G.H. (2008). Electrospun PCL Nanofibers with Anisotropic Mechanical Properties as a Biomedical Scaffold, Biomedical Materials, 3(2): 1-8.
2.
Zhou, Y.S., Yang, D.Z. and Nie, J. ( 2007). Effect of PVA Content on Morphology, Swelling and Mechanical Property of Crosslinked Chitosan/PVA Nanofibre, Plastics Rubber and Composites, 36(6): 254-258.
3.
Huang, Z.M. , Zhang, Y.Z., Kotaki, M. and Ramakrishna , S. ( 2003). A Review on Polymer Nanofibers by Electrospinning and their Applications in Nanocomposites, Composites Science and Technology, 63(15): 2223-2253.
4.
Ding, Y., Zhang, P., Jiang, Y., Xu, F., Yin, J. and Zuo, Y. ( 2009). Mechanical Properties of Nylon-6/SiO2 Nanofibers Prepared by Electrospinning, Material Letters, 63: 34-36.
5.
Huang, Z.M., Zhang, Y.Z., Ramakrishna, S. and Lim, C.T. ( 2004). Electrospinning and Mechanical Characterization of Gelatin Nanofibers, Polymer, 45(15): 5361-5368.
6.
Zuo, W.W. , Zhu, M.F., Yang, W., Yu , H., Chen, Y.M. and Zhang, Y. (2005). Experimental Study on Relationship between Jet Instability and Formation of Beaded Fibers during Electrospinning, Polymer Engineering and Science, 45(5): 704-709.
7.
Zhang, C.X., Yuan, X.Y., Wu, L.L., Han, Y. and Sheng, J. ( 2005). Study on Morphology of Electrospun Poly(Vinyl Alcohol) Mats, European Polymer Journal, 41(3): 423-432.
8.
Yang, Y., Jia, Z.D., Li, Q. and Guan, Z.C. ( 2006). Experimental Investigation of the Governing Parameters in the Electrospinning of Polyethylene Oxide Solution, IEEE Transactions on Dielectrics and Electrical Insulation, 13(3): 580-585.
9.
Subbiah, T., Bhat, G.S., Tock, R.W., Pararneswaran, S. and Ramkumar, S.S. ( 2005). Electrospinning of Nanofibers, Journal of Applied Polymer Science, 96(2): 557-569.
10.
Lee, J.S. , Choi, K.H., Do Ghim, H., Kim , S.S., Chun, D.H., Kim , H.Y. and Lyoo, W.S. (2004). Role of Molecular Weight of Atactic Poly(Vinyl Alcohol) (PVA) in the Structure and Properties of PVA Nanofabric Prepared by Electrospinning, Journal of Applied Polymer Science, 93(4): 1638-1646.
11.
Daga, V.K., Helgeson, M.E. and Wagner, N.J. ( 2006). Electrospinning of Neat and Laponite-filled Aqueous Poly(Ethylene Oxide) Solutions, Journal of Polymer Science Part B-Polymer Physics, 44(11): 1608-1617.
12.
Deitzel, J.M. , Kleinmeyer, J.D., Hirvonen, J.K. and Tan , N.C.B. (2001). Controlled Deposition of Electrospun Poly(Ethylene Oxide) Fibers, Polymer, 42(19): 8163-8170.
13.
Zhang, C.X. , Yuan, X.Y., Wu, L.L. and Sheng, J. ( 2006). Properties of Ultrafine Fibrous Poly(Vinyl Alcohol) Membranes by Electrospinning, Acta Polymerica Sinica, (2): 294-297.
14.
Ding, B., Kim, H.Y., Lee, S.C., Shao, C.L., Lee, D.R., Park, S.J., Kwag, G.B. and Choi, K.J. ( 2002). Preparation and Characterization of A Nanoscale Poly(Vinyl Alcohol) Fiber Aggregate Produced by an Electrospinning Method , Journal of Polymer Science Part B-Polymer Physics, 40(13): 1261-1268.
15.
Shin, M.K., Kim, S.I., Kim, S.J., Kim, S.K. and Lee, H. ( 2006). Reinforcement of Polymeric Nanofibers by Ferritin Nanoparticles , Applied Physics Letters, 88(19): 1939011-1939013.
Jung, Y.H., Kim, H.Y., Lee, D.R., Park, S.Y. and Khil, M.S. ( 2005). Characterization of PVOH Nonwoven Mats Prepared from Surfactant-polymer System via Electrospinning, Macromolecular Research, 13(5): 385-390.
18.
Kim, G.M. , Lach, R., Michler , G.H. and Chang, Y.W. (2005). The Mechanical Deformation Process of Electrospun Polymer Nanocomposite Fibers , Macromolecular Rapid Communications, 26(9): 728-733.
19.
Fong, H., Liu, W.D., Wang, C.S. and Vaia, R.A. ( 2002). Generation of Electrospun Fibers of Nylon 6 and Nylon 6-montmorillonite Nanocomposite, Polymer, 43(3): 775-780.
20.
Hong, J.H., Jeong, E.H., Lee, H.S., Baik, D.H., Seo, S.W. and Youk J.H. ( 2005). Electrospinning of Polyurethane/Organically Modified Montmorillonite Nanocomposites, Journal of Polymer Science Part B-Polymer Physics, 43: 3171-3177.
21.
Prado, L.A.S.D. , Karthikeyan, C.S., Schulte, K., Nunes, S.P. and de Torriani , I.L. (2005 ). Organic Modification of Layered Silicates: Structural and Thermal Characterizations , Journal of Non-crystalline Solids , 351(12-13): 970-975.
22.
Loyens, W., Jannasch, P. and Maurer, F.H.J. ( 2005). Poly(Ethylene Oxide)/ Laponite Nanocomposites Via Melt-compounding: Effect of Clay Modification and Matrix Molar Mass, Polymer , 46(3): 915-928.
23.
Stefanescu, E.A., Schexnailder , P.J., Dundigalla, A., Negulescu, I.I. and Schmidt, G. ( 2006). Structure and Thermal Properties of Multilayered Laponite/PEO Nanocomposite Films, Polymer, 47(21): 7339-7348.
24.
Adanur, S. and Ascioglu, B. ( 2007). Nanocomposite Fiber Based Web and Membrane Formation and Characterization, Journal of Industrial Textiles, 36(4): 311-327.
25.
Zhang, S., Horrocks, A.R., Hull, R. and Kandola, B.K. ( 2005). Flammability, Degradation and Structural Characterization of Fibre-forming Polypropylene Containing Nanoclay-Flame Retardant Combinations , Polymer Degradation and Stability, 91: 719-725.
26.
Hassan, M.A. , Kozlowski, R., Obidzinski , B., Shehata, A.B. and Aziz, F.A. (2007). The Effect of New Flame Retardant Systems Containing Montmorillonite-butyl Acrylate Nanoclay on the Flammability Properties of Polyuerethane Polymer , Polymer-Plastics Technology and Engineering, 46(5): 512-527.
27.
Wang, Z.Y., Han, E.H. and Ke, W. ( 2007). Fire-resistant Effect of Nanoclay on Intumescent Nanocomposite Coatings, Journal of Applied Polymer Science , 103(3): 1681-1689.
28.
Gong, F.L., Feng, M., Zhao, C.G., Zhang, S.M. and Yang, M.S. ( 2004). Thermal Properties of Poly(Vinyl Chloride)/Montmorillonite Nanocomposites, Polymer Degradation and Stability, 84(2): 289-294.
29.
Ristolainen, N., Heikkila, P., Harlin , A. and Seppala, J. (2006). Poly(Vinyl Alcohol) and Polyamide-66 Nanocomposites Prepared by Electrospinning , Macromolecular Materials and Engineering, 291: 114-122.
30.
Aşcıoglu, B. ( 2005), Manufacturing and Heat Transfer Analysis of Nanomicrofiber Composites, PhD Dissertation, Auburn University, Auburn.
31.
Wang, K.H., Xu, M., Choi, Y.S. and Chung, I.J. ( 2001). Effect of Aspect Ratio of Clay on Melt Extensional Process of Maleated Polyethylene/Clay Nanocomposites, Polymer Bulletin , 46(6): 499-505.
32.
Roy, R. ( 2008). Structure and Properties of Polymers, Lecture Notes Department of Polymer and Fiber Engineering, Auburn University, Auburn, AL, USA.
