Influence of nitrogen on hot ductility of steels and its relationship to problem of transverse cracking

The present review examines the influence of nitrogen on the hot ductility of steels, with particular relevance to the problem of transverse cracking during continuous casting. Nitrogen itself is not detrimental to hot ductility, but when it is present with aluminium or microalloying additions, ductility can be adversely affected through the formation of nitrides or carbonitrides. The addition of aluminium to low nitrogen C–Mn steels (0·005%N)impairs ductility during casting at an acid soluble level as low as 0·02%Al. This arises because segregation of aluminium to the grain boundaries occurs on solidification, and the temperature cycling that takes place when the strand is cooled encourages AlN precipitation. However, for low nitrogen, high strength low alloy (HSLA) steels with carbon levels in the peritectic range 0·08–0·17%C, transverse cracking is not generally encountered until the aluminium level is >0·04%. Higher nitrogen levels are likely to cause problems even at very low aluminium levels, as precipitation of AlN is controlled by the product of the aluminium and nitrogen contents. The microalloying additions vanadium and niobium are detrimental to ductility but, of the two elements, niobium is more damaging, as it gives finer precipitation. Increasing the nitrogen level has a more pronounced influence on ductility in vanadium containing steels, since vanadium forms a nitride while niobium forms Nb (CN), which is mainly carbon based. Nevertheless, the product of vanadium and nitrogen contents has to approach 1·2 × 10^-3, for example 0·1%V and 0·012%N, before ductility deteriorates to that normally given by a niobium containing steel with 0·03%Nb and 0·005%N. When small titanium additions are made to low nitrogen C–Mn–Al steels (0·005%N), the best ductility is likely to be given by a high Ti/N ratio of 4–5 : 1; the excess titanium in solution encourages growth of the TiN particles. For high nitrogen steels (0·01%N), a low titanium level (0·01%)is recommended to limit the volume fraction of TiN particles. A low soluble aluminium level is also needed to prevent the excess nitrogen from combining to form AlN. For C–Mn–Nb–Al steels, similar recommendations can be made with regard to adding titanium. However, the presence of niobium and aluminium appears to have little influence on ductility, since these elements coarsen the titanium containing precipitates.