Metallographic and OIM study of weld cracking in GTA weld build-up of polycrystalline,directionally solidified and single crystal Ni based superalloys

The repair of gas turbine components is of importance both commercially and scientifically to ensure cost effective repair schemes that will extend the lives of hot end components such as blades and stators. The present communication reports the results of a metallographic and orientation imaging microscopy study of weld cracking observed in the gas tungsten arc repair welds of a polycrystalline (IN738LC), a directionally solidified (Rene 80) and a proprietary single crystal (SX) alloy. The three alloys were welded with low, intermediate and high strength weld fillers, using a weld build-up approach rather than a conventional weld repair of a through thickness crack. This procedure would be applicable for example to worn area on the tips of turbine blades. Inhomogeneous initial microstructures and those from solidification processes led to extensive heat affected zone microfissuring in the IN738LC alloy, associated with MC carbide liquation, liquation of gamma prime (γ′), segregation of boron and strain effects from precipitation of γ′ in both single and double pass welds. As observed previously in a V shaped weld preparation, the extent of microfissuring in alloy IN738LC increased substantially from the use of the low and intermediate strength weld fillers, to extensive heat affected zone microfissuring by using the high strength IN738 filler. In the directionally solidified Rene 80 welds, due to the reduction in grain boundary area per unit volume, only minor heat affected zone cracking was observed, while the SX alloy did not crack at all. The absence of any cracks in the SX alloy welds despite the presence of stray grains in the fusion zone appears to be related to reduced stress levels in the welds due to the choice of welding technique and the welding parameters.