Abstract
The response to post-weld heat treatment of an 18%Ni (250 grade) gas tungsten arc weld metal has been investigated. The post-weld heat treatments are (a) direct aging at 480°C/3 h/air cooling, (b) solutionising at 815°C/1 h/air cooling+aging at 480°C/3 h/air cooling and (c) homogenisation at 1150°C/1 h/air cooling+solutionising at 815°C/1 h/air cooling+aging at 480°C/3 h/air cooling. Metallographic characterisation of fusion zone revealed pronounced segregation of titanium and molybdenum along the interdendritic and intercellular boundaries. This led, during subsequent aging, to austenite reversion at temperatures much lower than in wrought (unwelded) material. Solutionised treatment at 815°C does not remove the segregation. Homogenisation treatment (1150°C/1 h/air cooling) succeeded in making the composition become homogenised. Mechanical properties including tensile, hardness and impact toughness were evaluated. Tensile test results showed that directly aged weldments exhibited lower strength but higher ductility than the other cases; this was attributed to the presence of reverted austenite. Homogenisation at 1150°C/1 h/air cooling+solutionising at 815°C/1 h/air cooling+aging at 480°C/3 h/air cooling resulted in optimum tensile properties. A substantial increase in fusion zone toughness was observed after homogenisation+solutionising+aged condition due to a decrease in the content of austenite content compared to the directly aged condition. The reduction in microsegregation by diffusion of alloying elements from cell boundaries to the cell during homogenisation treatment is responsible for the decrease in austenite content.
Get full access to this article
View all access options for this article.