Detection of tooth breakage in end milling using machine tool axis control signals

Abstract

This paper considers the feasibility of utilizing existing machine tool axis drive control signals as a mechanism for the early identification of tool breakages. In particular the paper outlines the utilization of axis tachometer feedback signals as a means of monitoring the cutting process of a computer numerical control vertical milling machine. The work describes how a fault signature, corresponding to a tool breakage, can be identified in the axis tachometer signals at varying feed rates.

The results of the preliminary testing of a monitoring system utilizing existing axis feed drive signals are presented. The paper then outlines steps being taken to develop the application of the method to an increased range of cutting conditions. This work was based upon a study of the interrelationship between the axis control signals when cutting is proceeding in either the X - or the Y -axis direction, and when both the X axis and the Y axis are feeding simultaneously.

Keywords

tool breakage milling cutting process condition monitoring CNC machining

References

Altintas

In-process detection of tool breakages using time series monitoring of cutting forces. Int. J. Mach. Tools Mf., 1998, 28(2), 157–172.

Tlusty

Tarng

Y. S.

Sensing cutter breakage in milling. Ann. CIRP, 1988, 37(1), 45–51.

Hale

K. H.

Jones

B. E.

Tool wear monitoring sensors. In Proceedings of Conference on Condition Monitoring and Diagnostic Engineering Management, 1990, pp. 343–348.

Coker

S. A.

Shin

Y. C.

In-process control of surface roughness due to tool wear using a new ultrasonic system. Int. J. Mach. Tools Mf., 1996, 36(3), 411–422.

Reup

Machine management for increasing reliability, availability, and maintainability. Synthesis Report, 1995, Heckler and Koch GmbH, Oberndorf (N), Germany.

Drake

P. R.

Grosvenor

R. I.

Jennings

A. D.

Review of data acquisition system developed for the MIRAM project. In Proceedings of the Seventh Conference on Sensors and Their Application (Ed. Augousti

A. T.

), 1995, pp. 433–437 (Institute of Physics Publishing).

Tonshoff

H. K.

Wulfsberg

J. P.

Kals

H. J.

Konig

van Luttervelt

C. A.

Developments and trends in monitoring and control of machining processes. Ann. CIRP, 1988, 37(2), 611–622.

Jantunen

Jokinen

Milne

Flexible expert system for automated on-line diagnosis of tool condition. In Proceedings of the Technology Showcase on Integrated Monitoring, Diagnostics and Failure Pre6ention, Mobile, Alabama, 22–26 April 1996, pp. 1–12.

Martin

K. F.

A review by discussion of condition monitoring and fault diagnosis in machine tools. Int. J. Mach. Tools Mf., 1994, 34(4), 527–551.

10.

Ebrahimi

K. M.

Dynamic modelling of the cutting process for a CNC milling machine. PhD thesis, University of Wales Cardiff, 1989.

11.

Grosvenor

R. I.

Johns

Prickett

P. W.

Machine tool axis signals for condition monitoring. In Proceedings of Conference on Condition Monitoring and Diagnostic Engineering Management 1996, Sheffield, 16–18 July 1996, pp. 665–675.