Nucleation and subsequent cavitation in a hydraulic oil poppet valve

Abstract

If bubble nuclei are the cause of cavitation, how are they initially produced? According to what Washio et al. have found out so far, there are two possible ways for cavitation nuclei to be generated in liquid flows: separation of flow and a relative motion between solids contacting in liquid. The present article intends to reinforce that assertion by observing the cavitation occurring in an oil hydraulic poppet valve.

At a certain flowrate, a microscopic cavity suddenly emerged on the valve seat where the flow separated. As the flowrate increased, the cavity developed extending circumferentially on the seat and discharged bubbles by splitting. A collision of the poppet with the valve seat also caused the generation of a cavity. As the poppet was away from the seat after the collision, the cavity shrunk leaving behind a bubble.

Cavities generated on the seat by flow separation regularly repeated a process of growth and shrinkage accompanied by bubble discharge, which induced flow pulsation and consequently vibration of the poppet supported by a spring as well. Moreover, these cavities brought about so-called ‘choking’ in the poppet—seat constriction and acted to increase the pressure loss there by narrowing its cross-section.

Keywords

cavity generation cavitation inception bubble nuclei poppet valve flow separation solid contact oil hydraulic choking self-excited vibration pressure loss

Get full access to this article

View all access options for this article.

References

Washio

Takahashi

Uda

Sunahara

, ‘Study on cavitation inception in hydraulic oil flow through a long two-dimensional constriction’ Proc. IMechE, Part J: J. Engineering Tribology 215 J4 (2001): 373–386 DOI: 10.1243/1350650011543619.

Washio

Takahashi

Kawahara

Kishitani

, ‘Study on the cavitation mechanism in hydraulic oil flow using a needle projection’ Proc. IMechE, Part J: J. Engineering Tribology 216 J1 (2002): 27–34 DOI: 10.1243/1350650021543861.

Washio

Takahashi

Yoshimori

, ‘Study on cavitation starting at the point of separation on a smooth wall in hydraulic oil flow’ Proc. IMechE, Part C: J. Mechanical Engineering Science 217 C6 (2003): 619–630 DOI: 10.1243/095440603321919554.

Washio

Takahashi

Uemura

Iwamoto

Ogata

, ‘Singular properties of flow separation as a real cause of cavitation inception’ Proc. IMechE, Part C: J. Mechanical Engineering Science 222 C4 (2008): 667–678 DOI: 10.1243/09544062JMES835.

Washio

Takahashi

Murakami

Tada

Deguchi

, ‘Cavity generation by accelerated relative motions between solid walls contacting in liquid’ Proc. IMechE, Part C: J. Mechanical Engineering Science 222 C9 (2008): 1695–1705 DOI: 10.1243/09544062JMES965.

Oshima

Ichikawa

, ‘Cavitaion phenomena and performance of oil hydraulic poppet valve (2nd report)’ Bull. JSME 28–244 (1985): 2272–2279.

Oshima

Leino

Linjama

Koskinen

K. T.

Vilenius

, ‘Experimental study on cavitation in water hydraulic poppet valve’ Trans. Jpn. Fluid Power Sys. Soc. 33–2 (2002): 29–35.