Estimation of transient wall and flow temperature distributions in a circular duct using an inverse approach

Abstract

Inverse methods have become a useful tool for estimating parameters that cannot be measured or calculated directly in engineering applications. Parameters characterizing unsteady heat convection in circular duct flows are associated with numerous uncertainties. This fact renders the inverse approach appropriate for the determination of these parameters.

An inverse problem for transient turbulent thermally developing and thermally developed forced-convection flow in a circular duct is formulated and discussed, and a simplified direct thermal model is presented. Parameters of the model are estimated by solving a minimization problem, using temperature data from the wall surface and/or the flow. A multivariable optimization algorithm is employed for this purpose. Furthermore, a model for the forced-convection heat-transfer coefficient is proposed and its effect on the results is discussed.

The validity of the proposed method is assessed using data from two different circular duct flows. The method is shown to provide a good prediction capability in computationally demanding transient heat-data sequences of different duct flows, both in terms of duct and of flow characteristics. Results show that a hyperbolic axial distribution of the forced-convection heat-transfer coefficient in the developing region of the flow is essential for good adaptation of the method to the test data.

Keywords

inverse transient circular duct heat transfer forced convection

Get full access to this article

View all access options for this article.

References

Beck

J.V.

Blackwell

Clair

St.

C. R.

Inverse heat conduction: ill-posed problems, 1985 (Wiley-Interscience Publication, New York).

Alifanov

O. M.

Inverse heat transfer problems, 1994 (Springer, New York).

Trujillo

D. M.

Busby

H. R.

Practical inverse analysis in engineering, 1997 (CRC Press, Florida, USA).

RTO-AVT-VKI Lecture Series at the Von Karman Institute, Belgium. Heat transfer and inverse analysis, 26–29 April 2004 (also RTO RTO-EN-AVT-117 report, August 2005).

Bokar

J. C.

Aziik

M. N.

An inverse analysis for estimating the time-varying inlet temperature in laminar flow inside a parallel plate duct. Int. J. Heat Mass Transf., 1995, 38(1), 39–45.

Liu

F. B.

Aziayik

M. N.

Estimation of inlet temperature profile in laminar duct flow. Inverse Probl. Eng., 1996, 3, 131–141.

Raghunath

Determining entrance conditions from downstream measurements. Int. Commun. Heat Mass Transf., 1993, 20(2), 173–183.

Moutsoglou

Solution of an elliptic inverse convection problem using a whole domain regularization technique. J. Thermophys. Heat Transf., 1990, 4(3), 341–348.

Huang

C. H.

Aziayik

M. N.

Inverse problem of determining unknown wall heat flux in laminar flow through a parallel plate duct. Numer. Heat Transf. A Appl., 1992, 21(1), 55–70.

10.

Liu

F. B.

Aziayik

M. N.

Inverse analysis of transient turbulent forced convection inside parallel-plate ducts. Int. J. Heat Mass Transf., 1996, 39(12), 2615–2618.

11.

H.-Y.

Yan

W.-M.

Inverse convection problem for determining wall heat flux in annular duct flow. J. Heat Transf., 2000, 122(3), 460–464.

12.

Liu

F. B.

Aziayik

M. N.

Simultaneous estimation of fluid thermal conductivity and heat capacity in laminar duct flow. J. Franklin Inst., 1996, 333(4), 583–591.

13.

Flach

G. P.

Aziayik

M. N.

Inverse heat conduction problems of simultaneously estimating spatially varying thermal conductivity and heat capacity per unit volume. Numer. Heat Transf. A Appl., 1989, 16(2), 249–266.

14.

Kim

S. K.

Lee

W. I.

An inverse method for estimating thermophysical properties of fluid flowing in a circular duct. Int. Commun. Heat Mass Transf., 2002, 29(8), 1029–1036.

15.

Aengel

Y. A.

Turner

R. H.

Fundamentals of thermal - fluid sciences, 2001 (McGraw-Hill International Editions, New York, USA).

16.

Aengel

Y. A.

Heat and mass transfer: a practical approach, 3rd edition, 2007 (McGraw-Hill, New York).

17.

Pianco

Wazelt

(Eds.). Suitable averaging techniques in non-uniform internal flows, 1983, AGARDAR-182 (Eng. AGARD, Essex, UK).

18.

Nelder

J. A.

Mead

A simplex method for function minimization. Comput. J., 1965, 7(4), 308–313.