Study on combustion characteristics of a methanol—diesel dual-fuel compression ignition engine

Abstract

There is an increasing interest in applying methanol to diesel engines so as to achieve fuel diversity and reduce engine emissions. Dual-fuel application is the most promising method, but its combustion characteristics have been less extensively studied. In this paper, with the measured cylinder pressures of the engine operated on pure diesel and on dual fuel (methanol—diesel), the engine combustion characteristics are investigated. The increase in methanol mass fraction lowers the polytropic index of compression and the temperatures at BDC and TDC, as well as the oxygen concentration in the mixture. This prolongs the ignition delay under the same engine load and speed condition by comparison with diesel operation. The combustion heat release rate changes from dual-peak mode to single-peak mode. The centre of the heat release rate curve moves near to TDC under high load conditions, which indicates a better fuel economy. The high methanol mass fraction will realize a simultaneous reduction in both smoke and NO _x under all the operating conditions. Meanwhile, the NO _x smoke trade-off curve disappears in combustion of the dual fuel, but CO and HC increase.

Keywords

diesel engine methanol dual fuel combustion characteristics

Get full access to this article

View all access options for this article.

References

Shi

S. X.

Zhao

K. H.

M. L.

Wang

S. K.

Sun

Z. Y.

An investigation of using methanol as an alternative fuel for diesel engines. In Proceedings of the 15th International Congress on Combustion Engines, 1983.

Huang

Z. H.

H. B.

Jiang

D. M.

Zeng

Liu

Zhang

J. Q.

Wang

X. B.

Combustion behaviors of a compression ignition engine fuelled with diesel/methanol blends under various fuel delivery advance angles. Bioresource Technology, 2004, 95(3), 331–341.

Bayraktar

An experimental study on the performance parameters of an experimental CI engine fueled with diesel-methanol-dodecanol blends. Fuel, 2008, 87(2), 158–164.

Shi

S. X.

M. L.

Zhang

D. X.

An investigation of burning methanol as alternative fuel by dual fuelling method in compression ignition engine. In Proceedings of 16th International Congress on Combustion Engines, Oslo, 1985.

Popa

M. J.

Negurescu

Pana

Results obtained by methanol fuelling diesel engine. SAE Paper 2001–01–3748, 2001.

Heywood

J. B.

Internal combustion engine fundamentals, 1988, pp. 491–514 (McGraw-Hill Book Company, New York).

Assanis

D. N.

Filipi

Z. S.

Fiveland

S. B.

Syrimis

A predictive ignition delay correlation under steady-state and transient operation of a direct injection diesel engine. Trans. ASME J. Engng for Gas Turbines and Power, 2003, 125(2), 450–457.

Prakash

Ramesh

An approach for estimation of ignition delay in a dual fuel engine. SAE Tran., 1999, 108(3), 399–405.

Hardenberg

H. O.

Hase

F. W.

An empirical formula for computing the pressure rise delay of a fuel from its cetane number and from the relevant parameters of direct-injection diesel engines. SAE Paper 790493, 1979.