Determination of optimized non-gasketed flange geometry for safe stress and no leak condition: Finite-element analysis approach

Abstract

Performance of a flange joint is characterized mainly due to its ‘strength’ and ‘sealing capability’. Available design rules for flange joints are mainly concerned with the strength of the flanges and do not sufficiently consider for their sealing. Being continuous problems faced by the gasketed flange joints for strength and sealing based on concluded ‘dynamic mode of load’, non-gasketed joints are recommended as an alternative. The current paper presents three-dimensional non-linear finite-element analysis of non-gasketed flange joint with different flange surface profiles (positive taper, negative taper, and zero taper angles) to find out the most optimal flange geometry for safe stress and no-leak conditions under bolt up and internal pressure loading. Based on the results, optimum flange geometry is selected and further analysed under proof test pressure. A ‘static mode of load’ in positive taper angle flange is concluded, ensuring proper joint sealing, and strength.

Keywords

finite element simulation flange joint optimized stress leak

Get full access to this article

View all access options for this article.

References

1 BS 1560. Steel pipe flanges for the petroleum industry, 1989 (British Standards Institution, London, UK).

2 ASME boiler and pressure vessel code, section VIII, division 1. American Society of Mechanical Engineers, New York, 1998.

Abid

Nash

D. H.

Comparative study of the behaviour of conventional gasketed and compact nongasketed flanged pipe joints under bolt up and operating conditions. Int. J. Press. Vessels Pip., 2003, 80, 831–841.

Abid

Experimental and analytical studies of conventional (gasketed) and unconventional (non gasketed) flanged pipe joints (with special emphasis on the engineering of ‘joint strength’ and ‘sealing’). PhD Thesis, 2000.

Webjörn

Flange design in Sweden. In Proceedings of the Petrochemical Mechanical Engineering Conference, American Society of Mechanical Engineers, Philadelphia, September 1967, pp. 17–20.

Webjörn

The bolted joint - a series of problems. Linköping Studies in Science and Technology. Dissertation no. 130, 1985.

Abid

Nash

D. H.

Webjörn

The stamina of non-gasketed flanges. Fatigue 2000, Cambridge, April 2000, pp. 575–584.

Abid

Nash

D. H.

A parametric study of metal-to-metal contact flanges with optimised geometry for safe stress and no-leak conditions. Int. J. Press. Vessels Pip., 2004, 81, 67–74.

Spence

Macfarlane

D. M.

Tooth

A. S.

Metal-to-metal full face taper hub flanges: Finite element model evaluation and preliminary plastic analysis. Proc. Instn Mech. Engrs, Part E: J. Process Mechanical Engineering, 1998, 212(E), 57–69.

10.

Nash

D. H.

Spence

Tooth

A. S.

Abid

Power

D. J.

A parametric study of metal-to-metal full face taper hub flanges. Int. J. Press. Vessels Pip., 2000, 77(13), 791–798.

11.

Power

D. J.

A study of conventional and unconventional flanged pipe joint styles using non linear finite element analysis techniques. MPhil. Thesis, University of Strathclyde, Glasgow. 1997.

12.

Spence

Tooth

A. S.

Pressure vessel design - concepts and principles, 1994 (Chapman & Hall, UK).