Mechanical testing of a flexible fixation device for the lumbar spine

Abstract

The aim of this study was to test mechanically a new flexible fixation system for the lumbar spine. This device incorporates loops of polyester braid which are secured by a crimped titanium sleeve. In tensile tests, all loops failed, by slippage through the crimped sleeve, at 434 ± 15 N (mean ± standard deviation from five loops) for a single crimp and 415 ± 15 N (from five loops) for two crimps. The intact system was then tested according to the ASTM standard. In a static test, all five specimens failed by slippage of the braid through the sleeve. Initial slippage occurred between 600 and 700 N, but the mean maximum load sustained was 1090 ± 140 N. Dynamic tests were performed on ten constructs at a frequency of 5 Hz, under a range of loading conditions. The maximum load applied in any of the tests was 825 N. Two constructs did not complete the required 5 × 10⁶ test cycles because of fracture of their spinous process hooks. However, other tests, under the same conditions, showed no signs of failure. Fracture occurred as a result of fretting damage from the recommended stainless steel roll pins.

Keywords

spine flexible stabilization mechanical testing

Get full access to this article

View all access options for this article.

References

Papp

Porter

R. W.

Aspden

R. M.

Shepherd

J. A. N.

An in vitro study of the biomechanical effects of flexible stabilisation on the lumbar spine. Spine, 1997, 22, 151–155.

Leahy

J. C.

Mathias

K. J.

Heaton

Shepherd

D. E. T.

Hukins

D. W. L.

Deans

W. F.

Brian

M. W.

Wardlaw

Design of spinous process hooks for flexible fixation of the lumbar spine. Proc. Instn Mech. Engrs, Part H, Journal of Engineering in Medicine, 2000, 214 (H5), 479–487.

BS 7252: Part 3: 1997 Metallic Material for Surgical Implants. Specification for Wrought Titanium 6-Aluminium 4-Vanadium Alloy, 1997 (British Standards Institution, London).

Rudisch

Kremser

Peer

Kathrein

Judmaier

Daniaux

Metallic artifacts in magnetic resonance imaging of patients with spinal fusion. A comparison of implant materials and imaging sequences. Spine, 1998, 23, 692–699.

ASTM F1717 Standard Test Methods for Static and Fatigue for Spinal Implant Constructs in a Corpectomy Model, 1996 (American Society for Testing and Materials, Philadelphia, Pennsylvania).

Collins

J. A.

Failure of Materials in Mechanical Design, 2nd edition, 1993 (Wiley-Interscience, New York).

Medical Device Directive. Official Journal of the European Community, 1993, 36, 1–43.