Comparison of flow in numerical and physical models of a ventricular assist device using low- and high-viscosity fluids

Abstract

The flows in a model of a ventricular assist device (VAD) were investigated numerically and experimentally for two different Newtonian test fluids. These were a blood analogue fluid and a much higher viscosity fluid. A finite volume method was employed to solve the governing equations for a three-dimensional unsteady laminar flow on a transient grid. The numerical solutions were compared with experimental results from an identical physical model. The experimental flows were investigated by flow visualization and by laser Doppler velocity measurements at selected points in the flow field. The validation was based on comparisons of flow patterns and of one-component velocity-time histories. The maximum Reynolds numbers in the inflow tube of the model VAD were approximately 460 and 3300 using the high- and low-viscosity fluids respectively. The investigation showed that the flow patterns were better predicted for the high-viscosity fluid. However, the agreement between the velocity-time histories was found to be slightly better for the low-viscosity fluid. The discrepancies in the flow patterns may be due to intermittent turbulence with a further contribution from numerical diffusion.

Keywords

ventricular assist device model computational fluid dynamics unsteady flow laminar flow Newtonian moving boundaries experimental validation

Get full access to this article

View all access options for this article.

References

Jin

Engineering aspects of a ventricular assist device (VAD). PhD thesis, Brunel University, 1992.

Jin

Clark

Experimental investigation of unsteady flow behaviour within a sac type ventricular assist device. J. Biomechanics, 1993, 26 (6), 697–707.

Clark

Jin

Glaser

The fluid mechanics of a sac-type ventricular assist device. Int. J. Artif. Organs, 1990, 13 (12), 814–822.

Kim

S. H.

Chandran

K. B.

Chen

C. J.

Numerical simulation of flow in a total artificial heart. In Advances in Bioengineering, BED-Vol. 20, 1991, pp. 289–292 (American Society of Mechanical Engineers, New York).

Kim

S. H.

Chandran

K. B.

Chen

C. J.

Numerical simulation of steady flow in a two-dimensional total artificial heart model. Trans. ASME, J. Biomech. Engng, 1992, 114, 497–503.

Rogers

S. E.

Kwak

Kiris

Numerical solution of the incompressible Navier-Stokes equations for steady state and time-dependent problems. In Proceedings of the 27th Aerospace Science Meeting, Reno, Nevada, AIAA-89–0463, 1989, pp. 1–14 (American Institute of Aeronautics and Astronautics, New York).

Kiris

Computations of incompressible viscous flows through artificial heart devices with moving boundaries. PhD dissertation, Stanford University, Stanford, California, 1991.

Kiris

Rogers

Kwak

Chang

I.-D.

Computational approach for probing the flow through artificial heart devices. In Advances in Bioengineering, BED-Vol. 20, 1991, pp. 285–288 (American Society of Mechanical Engineers, New York).

Kiris

Chang

Rogers

S. E.

Kwak

Numerical simulation of the incompressible internal flow through a tilting disk valve. AIAA-90–0682, 1990, pp. 1–9 (American Institute of Aeronautics and Astronautics, New York).

10.

Baldwin

J. T.

Tarbell

J. M.

Deutsch

Geselowitz

D. B.

Mean flow velocity patterns within a ventricular assist device. ASAIO Trans., 1989, 35, 429–433.

11.

Chesler

N. C.

Kamm

R. D.

A systematic method for design and evaluation of a cardiac pumping chamber. In Advances in Bioengineering, BED-Vol. 28, 1994, pp. 401–402 (American Society of Mechanical Engineers, New York).

12.

Chesler

N. C.

Kamm

R. D.

Three-dimensional swirling flow in a counter-pulsating cardiac assist device. In Proceedings of the 1997 Bioengineering Conference, BED-Vol. 35, 1997, pp. 9–10 (American Society of Mechanical Engineers, New York).

13.

König

C. S.

Numerical and experimental investigation of flow in a model of a ventricular assist device (VAD). PhD thesis, Brunel University, 1997.