Performance and pressure distribution changes in a centrifugal pump under two-phase flow

Abstract

Pump performance characteristics change drastically under two-phase flow conditions from those of single-phase flow. This is due to a change in flow characteristics in the impeller. Owing to a positive pressure gradient the air bubble moves more slowly than the water in the impeller channel, but in the suction surface region of the impeller inlet, where a negative pressure gradient prevails, the bubbles move more quickly than the water. Thus, in the space just after this region the distributions of the void fraction obtained are considerably higher and uneven. The change in the pressure distribution owing to air admission is also particularly evident in the inlet region of the impeller. These changes bring about an alteration of the whole flow pattern in the impeller and also cause a drop in pump performance. The Reynolds-averaged Navier-Stokes equations for two-phase flow in a centrifugal pump impeller are solved using a finite volume method to obtain the pressure, velocities and void fraction respectively. Good agreement is achieved when the predicted results are compared with those measured experimentally within the range of bubbly flow conditions.

Keywords

centrifugal pump two-phase flow void fraction IPSA

Get full access to this article

View all access options for this article.

References

Hench

J. E.

Johnston

J. P.

Two-dimensional diffuser performance with subsonic, two-phase, air-water flow

Trans. ASME, J. Basic Engng, 1972, 94(1), 105–121.

Zakem

Analysis of gas accumulation and slip velocity in a rotating impeller. In Proceedings of ASME Forum on Cavitation and Polyphase Flow, 1980, pp. 32–34 (American Society of Mechanical Engineers, New York).

Tamamidis

Aanis

D. N.

Prediction of three-dimensional steady incompressible flows using body-fitted coordinates

Trans. ASME, J. Fluids Engng, 1993, 115, 457–462.

Harlow

F. H.

Amsden

A. A.

Numerical calculation of multiphase fluid flow

J. Computational Phys., 1975, 17, 19–52.

Spalding

D. B.

‘IPSA 1981’ new developments and computed results. CFDU Report HTS/81, Imperial College of Science and Technology, London, 1981.

Minemura

Murakami

Katagiri

Characteristics of centrifugal pumps handling air-water mixtures and size of air bubbles in pump impellers

Bull. Jap. Soc. Mech. Engrs, 1985, 28(244), 2310–2318.

Minemura

Murakami

Kataoka

Pressure distribution in a centrifugal impeller handling air-water mixtures

Bull. Jap. Soc. Mech. Engrs, 1983, 26(220), 1727–1734.

Eckardt

Detailed flow investigations within a high-speed centrifugal compressor impeller. Trans. ASME, J. Fluids Engng, 1976, 98, 390–402.

Kim

J. H.

Perspectives on two-phase flow pump modeling for nuclear reactor safety analysis. In Proceedings of ASME Forum on Cavitation and Multiphase Flow, 1983, pp. 27–33 (American Society of Mechanical Engineers, New York).

10.

Minemura

Uchiyama

Three-dimensional calculation of air-water two-phase flow in centrifugal pump impeller based on a bubbly flow model. Trans. ASME, J. Fluids Engng, 1993, 115, 766–771.

11.

Minemura

Uchiyama

Prediction of pump performance under air-water two-phase flow based on a bubbly flow model. Trans. ASME, J. Fluids Engng, 1993, 115, 781–783.

12.

Moore

J. G.

Calculation of three-dimensional, viscous flow and wake development in a centrifugal impeller. In Proceedings of 25th Annual International Gas Turbine Conference, New Orleans, Louisiana, 9-13 March 1984, pp. 61–67.

13.

Moore

J. G.

Timmis

P. H.

Performance evaluation of centrifugal compressor impeller using threedimensional viscous flow calculations. Trans. ASME, J. Engng for Gas Turbines and Power, 1984, 106, 475–486.