The determination of the pressure—viscosity coefficient of a lubricant through an accurate film thickness formula and accurate film thickness measurements
Restricted accessResearch articleFirst published online August, 2009
The determination of the pressure—viscosity coefficient of a lubricant through an accurate film thickness formula and accurate film thickness measurements
The pressure—viscosity coefficient is an indispensable property in the elastohydrodynamic (EHD) lubrication of hard contacts, but often not known. A guess will easily lead to enormous errors in the film thickness. This article describes a method to deduct this coefficient by adapting the value of the pressure—viscosity coefficient until the differences between accurate film thickness approxi-mation values and accurate film thickness measurements over a wide range of values are at a minimum. Eleven film thickness approximation formulas are compared in describing the film thickness of a test fluid with known value of the pressure—viscosity coefficient. The measurement method is based on spacer layer interferometry. It is concluded that for circular contacts the newer more versatile expressions are not better than some older approximations, which are limited to a smaller region of conditions, and that the older fits are as least as appropriate to find the pressure—viscosity coefficient of fluids, in spite of the limited data where they have been based on.
BairS.High pressure rheology for quantitative elastohydrodynamics (Amsterdam: Elsevier2007): 240 pp.
2.
JonesW. R.JohnsonR. L.WinerW. O.SanbornD. M.‘Pressure-viscosity measurements for several lubricants to 5.5 ×108 Newtons per square meter (8 × 104PSI) and 149 C (30 0F)’ASLE Trans.184 (1975): 249–262
3.
LarssonR.LarssonP. O.ErikssonE.SjöbergM.HöglundE.‘Lubricant properties for input to hydrodynamic and elastohydrodynamic lubrication analyses’Proc. IMechE, Part J: J. Engineering Tribology 214 J1 (2000): 17-27 DOI: 10.1243/1350650001542981.
4.
TaylorR. I.‘Lubrication, tribology and motorsport’SAE paper 2002-01-3355, 2002.
5.
JacobsonB. O.Rheology and elastohydrodynamic lubrication (Amsterdam: Elsevier1991): 382p. Tribology Series.
6.
SpikesH. A.CannP. M.‘The development and application of the spacer layer imaging method for measuring lubricant film thickness’Proc. IMechE, Part J: J. Engineering Tribology 215 J3 (2001): 261-217 DOI: 10.1243/1350650011543529.
7.
LuoJ.WenS.TottenG. E.LiangH.‘Measuring technique and characte-ristics of thin film lubrication at nanoscale’Mechanical tribology - materials, characterization, and applications (New York: Dekker2004): 257–306
8.
HartlM.KrupkaI.ZhuD.SnidleR. W.EvansH. P.‘EHL film thickness behaviour under high pressure - comparison between numerical and experimental results’Elastohydrodynamics and micro-elastohydrodynamics (Dordrecht: Springer2006): 217–228
MoesH.Lubrication and beyond (Enschede, The Netherlands: Twente University Press2000): 366p. Lecture Notes Code 115531.
11.
ChittendenR. J.DowsonD.DunnJ. F.TaylorC. M.‘A theoretical analysis of the isothermal elastohydrodynamic lubrication of concentrated contacts, part I: Direction of lubricant entrainment coincident with the major axis of the Hertzian contact ellipse’Proc. R. Soc. Lond. A 1813 (1985): 245–269
12.
HamrockB. J.SchmidS. R.JacobsonB.Fundamentals of fluid film lubrication (Basel: Dekker2004): 699pp.
13.
DowsonD.HigginsonG. R.Elastohydrodynamic lubrication (Oxford: Pergamon1966): 235- and 1977, SI edition, 235 pp.
14.
JohnsonK. L.‘Regimes of elastohydrodynamic lubrication’J. Mech. Eng. Sci.121 (1970): 9–16
15.
JohnstonG. J.WayteR.SpikesH. A.‘The measurement and study of very thin lubricant films in concentrated contacts’Tribol. Trans.342 (1991): 187–194
16.
ChooJ. W.GlovneaR. P.OlverA. V.SpikesH. A.‘The effects of three-dimensional model surface roughness features on lubricant film thickness in EHL contacts’J. Lubr. Technol.1253 (2003): 533–542
17.
ErtelA.von Mohrenstein‘Die Berechnung der hydrodynamischen Schmierung gekrümmter Oberflächen unter hoher Belastung und Relativbewegung’ 1984, 92 pp. VDI-Fortschrittberichte, Series 1, No. 115, Düsseldorf (authorized German translation of Ertel's Russian Dissertation from 1944, The calculation of the hydrodynamic lubrication with curved surfaces under high load and relative motion)†
18.
BarusC.‘Isothermals, isopiestics and isometrics relative to viscosity’Am. J. Sci.45 (1893): 87–96
19.
RoelandsC. J. A.Correlational aspects of the viscosity-temperature-pressure relationship of lubricating oils (1966) PhD Thesis.
20.
Ten NapelW. E.MoesH.BosmaR.‘Traction in elastohydrodynamic lubrication at low sliding speeds’In Proceedings of the 1971 Tribology Convention, Douglas, Isle of Man, UK, 12–15May 1971, pp. 142–150, paper C82/71 (Institution of Mechanical Engineers, London, UK).
21.
MoesH.BosmaR.‘Film thickness and traction in E.H.L. at point contact’In Proceedings of the Elastohydrodynamic Symposium,1972, pp. 149–152, paper C38/72 (Institution of Mechanical Engineers, London, UK).
22.
VennerC. H.Multilevel solution of the EHL line and point contact problems (1991) PhD Dissertation, 318 P.
23.
BlokH.MusterD.SternlichtB.‘Inverse problems in hydrodynamic lubrication and design for lubricated flexible surfaces’In Proceedings of the International Symposium on Lubrication and wear (Eds MusterD.SternlichtB.), Houston, 1963, pp. 1–151 (McCutchan Publishing Corp., Berkeley).
24.
BairS.‘An experimental verification of the significance of the reciprocal asymptotic isoviscous pressure for EHD lubricants’Tribol. Trans.362 (1993): 153–162
25.
HamrockB. J.DowsonD.‘Isothermal elastohydrodynamic lubrication of point contacts, part III - fully flooded results’Trans. ASME Series F, J. Lubr. Technol.992 (1977): 264–276
26.
GreenwoodJ. A.‘Film thicknesses in circular elastohydrodynamic contacts’Proc. IMechE, Part J: J. Engineering Tribology 202 C1 (1988): 11-17 DOI: 10.1243/PIME_PROC_1988_202_081_02.
27.
ArchardJ. F.CowkingE. W.‘Elastohydrodynamic lubrication at point contacts’Proc. Instn Mech. Engrs 180 Part 3B (1965-66): 47-56 DOI: 10.1243/PIME_CONF_1965_180_063_02. In Proceedings of the Symposium on Elastohydrodynamic Lubrication, Leeds, September 1965, paper 3.
28.
HamrockB. J.DowsonD.Ball bearing lubrication - the elastohydrodynamics of elliptical contacts (New York: John Wiley1981): 386pp.
29.
HamrockB. J.Fundamentals of fluid film lubrication (New York: McGraw-Hill1994): 690pp.
30.
HookeC. J.‘Minimum film thickness in lubricated point contacts operating in the elastic piezoviscous regime’Proc. IMechE, Part J: J. Engineering Tribology 202 C2 (1988): 73-84 DOI: 10.1243/PIME_PROC_1988_202_092_02.
31.
SutcliffeM. P. F.‘Central film thickness in elliptical contacts’Proc. IMechE, Part C: J. Mechanical Engineering Science203 (1989): 387-392 DOI: 10.1243/PIME_PROC_1989_203_132_02.
32.
VennerC. H.Ten NapelW. E.‘Multilevel solution of the elastohydrodynamically lubricated circular contact problem, part II: Smooth surface results’Wear1522 (1992): 369–381
33.
NijenbanningG.VennerC. H.MoesH.‘Film thickness in elastohydrodynamically lubricated elliptic contacts’Wear1762 (1994): 217–229
34.
HookeC. J.‘The influence of piezoviscosity on the mini-mum film thickness in heavily loaded elastohydrodynamic point contacts’Proc. IMechE, Part C: J. Mechanical Engineering Science204 (1990): 117-125 DOI: 10.1243/PIME_PROC_1990_204_085_02.
35.
HookeC. J.‘An interpolation procedure for the mini-mum film thickness in point contacts’Proc. IMechE, Part C: J. Mechanical Engineering Science204 (1990): 199-206 DOI: 10.1243/PIME_PROC_1990_204_095_02.
36.
BilloE. J.Excel for scientists and engineers: numerical methods (Hoboken: Wiley2007): 454p.
37.
VennerC. H.Software code ehl2d0. 2008, version 1.00.
38.
SpikesH. A.‘Thin films in elastohydrodynamic lubri- cation: The contribution of experiment’Proc. IMechE, Part J: J. Engineering Tribology 213 J5 (1999): 335-352 DOI: 10.1243/1350650991542712.
39.
BlokH.‘Correlational review of theoretical and experimental data on elasto-hydrodynamic lubrication’ Delft University Report, Laboratory of Machine Elements, 1959, citation from Dowson and Higginson [13] p. 224, Greenwood [26], p. 12, and from Moes [41], p. 215, who dates this reference at 1960.
40.
MoesH.‘Discussion on paper R1 by D. Dowson’Proc. Instn Mech. Engrs 180 Pt. 3B (1965-66): 244–245
41.
MoesH.A study of the inverse hydrodynamic lubrication theory and of the applications in calculating elastically highly deformed bearings. 1964, 235p. (in Dutch). MSc Thesis, Delft University.
42.
GuoF.FuZ.WongP. L.YangP.‘Experimental study on the lubrication regime variation in point contacts’Tribol. Int.41 (2008): 451–460
43.
BlokH.‘In VDI Berichte, Vol. 20, by W. Peppler, 1957, Die Theorie der hydrodynamischen Schmierung unter besonderer Berücksichtigung physikalischer Erweiterungen’. 1957, pp. 29–30
44.
BlokH.‘Communications’Proc. Instn Mech. Engrs 180 Part 3B (1965-66): 237-238 In Proceedings of the Symposium on Elastohydrodynamic Lubrication, Leeds, September 1965.
45.
KoetsO. J.A survey of the elastohydrodynamic lubrication theory (in Dutch). MSc Thesis, Delft University, Laboratory of Machine Elements, citation from Dowson and Higginson [13] p. 227 and Moes [41], p. 217.
46.
DowsonD.HigginsonG. R.‘The effect of material properties on the lubrication of elastic rollers’J. Mech. Eng. Sci.23 (1960): 188–194
MoesH.‘Optimum similarity analysis with applications to elastohydrodynamic lubrication’Wear1591 (1992): 57–66
49.
BlokH.‘Recent developments in gear tribology’Proc. Instn Mech. Engrs 184 Pt. 3O (1970): 21-29 In Proceedings of the Conference on Gearing in 1970, 17-18 September 1970, paper 3.
50.
BlokH.‘Discussion of a paper by E. McEwen, entitled the effect of variation of viscosity with pressure on the load carrying capacity of the oil film between gear teeth’J. Instn Petrol38344 (1952): 673–683
51.
LubrechtA. A.The numerical solution of the elastohydrodynamically lubricated line- and point contact problem, using multigrid techniques. PhD Dissertation, Twente University, Netherlands, 1987, 219 P.
