Paper 12: Generation of Hydraulic Noise in Centrifugal Pumps

Abstract

The production of hydraulic noise by two types of centrifugal pumps—volute pumps and diffuser pumps—was examined to determine the effect of design and operating conditions on the level of noise generated in the pumped liquid.

Experimental work with hydrophones in the exit and entrance to the pumps showed that for both pumps, the dominant frequencies in the noise spectrum were at rotational speed and blade number times rotational speed. It was also found that the distance between cutwater and impeller tip is critical in a volute pump as far as blade frequency noise is concerned.

Analysis of the relation between the noise measured by the hydrophones and the fluctuating pressure produced by the pump and the water flow in the inlet and outlet ducts showed that the noise can be interpreted as being directly related to the unsteady flow of water issuing from the impeller.

Test results of blade frequency noise levels were correlated with a theoretical analysis for static pressure fluctuations in the pump exit and were shown to be in good agreement. A correlation of general hydraulic noise level with pump specific speed and power consumption was also developed and shown to be reliable to within +2 dB.

Get full access to this article

View all access options for this article.

References

Lindros

‘Grand Coulee model-pump investigation of transient pressures and methods for their reduction’

Trans Am. Soc. mech. Engrs 1954 76 (July).

Parmakian

‘Vibration of the Grand Coulee pump-discharge lines’, Trans. Am. Soc. mech. Engrs 1954 76 (July).

Chen

T. N.

‘Water-pressure oscillations on the volute casings of storage pumps’, Sulzer Tech. Review 1961, Research Number.

Strub

R. A.

‘Pressure fluctuations and fatigue stresses in storage pump and pump turbines’, Am. Soc. mech. Engrs Paper 63-AHGT-11, 1963.

Preston

J. H.

‘The non-steady irrotational flow of an inviscid incompressible fluid with special reference to changes in total pressure through flow machines’, Aeronaut. Quart. 1961 (Nov.).

Kemp

N. H.

Sears

W. R.

‘Aerodynamic interference between moving blade rows’, J. aeronaut. Sci. 1953 (Sept.).

Kemp

N. H.

Sears

W. R.

‘The unsteady forces due to viscous wakes in turbo-machines’, J. aeronaut. Sci. 1955 (July).

Lighthill

M. J.

‘On sound generated aerodynamically—I’, Proc. R. Soc. Series A 1952 (Mar.).

Lighthill

M. J.

‘On sound generated aerodynamically—II’, Proc. R. Soc. Series A 1954 (Feb.).

10.

Notes for Lecture Series on Noise and acoustic fatigue in aeronautics conducted by the Staff of the Department of Aeronautics and Astronautics, University of Southampton; held in Dayton, Ohio 1961 (Sept.).

11.

Peistrup

C. F.

Wesler

J. E.

‘Noise of ventilating fans’, J. Am. acoust. Soc. 1963 25 (Mar., No. 2).

12.

Simpson

H. C.

Cinnamond

‘Studies of flow through centrifugal pump impeller’, Thermodynamics and Fluid Mechanics Convention (Cambridge) 1964 (Apr.) (Instn Mech. Engrs, London).

13.

Simpson

H. C.

Cinnamond

‘The quantitative study of three-dimensional flow patterns in centrifugal pumps’, I.A.H.R. Congress (London) 1963.

14.

Wood

F. J.

Corkill

‘Instrumentation for the measurement of hydraulic noise in centrifugal pumps’, Proc. Instn mech. Engrs 1966–67 181 (Pt 3A), 9.

15.

Simpson

H. C.

Clark

T. A.

Weir

‘A theoretical investigation of noise in pumps’ (to be published).

16.

Deisler

R. C.

‘Turbulent heat transfer and friction in the entrance regions of smooth passages’, Trans. Am. Soc. mech. Engrs 1955, 1221.

17.

Curle

‘The influence of solid boundaries upon aero-dynamic sound’, Proc. R. Soc. Series A 1955.

18.

Copley

D. M.

‘The fluctuating flow in centrifugal pumps and the possible causes of vibration’, I.A.H.R. Congress (London) 1963.