Measurements and Predictions of the Fuel Consumption and Emission of a Spark Ignition Engine Fuelled with Hydrogen-Enriched Gasoline

Abstract

The effect of the amount of hydrogen addition on the fuel consumption and emission of a spark ignition engine has been studied. Dynamometer test results for a wide range of engine speeds, engine loads, equivalent ratio and hydrogen enrichment under steady state operation are presented, and the engine requirements for minimum b.s.f.c. are specified. A detailed model to simulate a four-stroke cycle of a spark ignition engine fuelled with hydrogen-enriched gasoline was used to predict the optimal amount of hydrogen supplement as well as the corresponding minimum best torque (MBT) optimal throttle position and emissions levels of CO and NO_x. It has been shown that a significant reduction in the b.s.f.c, in the order of 20 per cent, is achieved with hydrogen-enriched gasoline for a hydrogen-fuel mass ratio of 6 per cent and equivalence ratio of 0.65. A very smooth operation has been observed under these conditions. The energy conversion gain is prominent at partial loads and depends only to a limited extent on the engine speed.

Get full access to this article

View all access options for this article.

References

Hoehn

F. W.

Baisly

R. L.

Dowdy

M. W.

Advances in ultra-lean combustion technology using hydrogen-enriched gasoline. Proceedings of the Tenth Intersociety Energy Conversion Engineering Conference, paper 759173, 1975.

Sjostrom

Eriksson

Landqvist

On-board hydrogen generation for hydrogen injection into internal combustion engines. SAE paper 810348, 1981.

Lucas

G. G.

Richards

W. L.

The hydrogen/petrol engine —the means to give good part-load thermal efficiency. SAE paper 820315, 1982.

Schafer

An investigation of the addition of hydrogen to methanol on the operation of an unthrottled Otto engine. SAE paper 810776, 1981.

Sher

Hacohen

On the modeling of a SI 4-stroke cycle engine with hydrogen-enriched gasoline. Int. J. Hydrogen Energy, 1987, 12, 773–781.

Annand

W. J. D.

Heat transfer in the cylinders of reciprocating internal combustion engines. Proc. Instn Mech. Engrs, 1963, 177, 973–989.

Hires

S. D.

Tabaczynski

R. J.

Novac

J. M.

The predictions of ignition delay and combustion intervals for a homogeneous charge, spark ignition engine. SAE paper 780232, 1978.

Law

C. K.

Laminar flame speeds of hydrocarbon + air mixtures with hydrogen addition. Combust. and Flame, 1986, 63, 339–347.

Metghalchi

Keck

J. C.

Burning velocities of mixtures of air with methanol, isooctane, and indolene at high pressure and temperature. Combust. and Flame, 1982, 48, 191–210.

10.

Lavoie

Heywood

J. B.

Keck

C. J.

Experimental and theoretical study of nitric oxide formation in internal combustion engines. Combust. Sci. Technol., 1970, 1, 313–326.

11.

Weinberg

F. J.

Explicit equations for the calculation, by successive approximation of equilibrium gas compositions at high temperature: The hydrogen + carbon + oxygen and hydrogen + carbon + oxygen + nitrogen systems without solid carbon formation. Proc. R. Soc., 1957, 241, 132–140.

12.

Strehlow

R. A.

Combustion fundamentals, 1984 (McGraw-Hill).

13.

Starkman

E. S.

Newhall

Characteristics of the expansion of reactive gas mixtures as occurring in internal combustion engine cycles. SAE paper 650509, 1965.

14.

Benson

R. S.

Baruah

P. C.

Performance and emission predictions for a multi-cylinder spark ignition engine. Proc. Instn Mech. Engrs, 1977, 191, 339–354.

15.

SAE recommended practice engine test code. SAE paper J816b, in SAE handbook, 1979, p. 24. 08.