Active Cooling of a Hypersonic Plane Using Hydrogen,Methane,Oxygen and Fluorine

Abstract

This paper studies active cooling of an aerospace plane using liquid hydrogen, liquid methane, liquid oxygen and liquid fluorine. An ascending optimized trajectory to minimize the heat load in the hypersonic part is used to perform the study, which includes cooling of the stagnation point, the leading edges of wings and engine and other parts of the aerospace plane that are close to the leading edges. The laminar case of the stagnation point and both laminar and turbulent cases for the leading edge heating have been considered. The amount of liquid coolant mass needed for cooling is calculated. A design of minimum inlet–outlet areas for the amount of liquid needed for cooling is made with consideration of the coolant's physical constraints in the liquid and gaseous states. The study shows that the ratio of masses of coolant to the initial total mass (initial total mass of the vehicle including fuel and coolant masses) is in the limit of the reachable range. The comparison shows that the hydrogen is a clear winner as a candidate for coolant and saves mass as compared to the other three coolants. The study shows that there are no fundamental barriers for the cooling system of the vehicle in terms of its coolant mass and area size for coolant passage.

Keywords

aerospace plane hypersonic cooling hydrogen

Get full access to this article

View all access options for this article.

References

Tauber

M. E.

Menees

G. P.

Aerothermodynamics of transatmospheric vehicles. AIAA/ASME Fourth Joint Conference on Thermophysics and heat transfer, Boston, Massachusetts, 2–4 June 1986, paper 86–1257 (American Institute of Aeronautics and Astronautics).

Krause

J. M.

Hartmann

G. L.

Ianculescu

G. D.

Active thermal control for hypersonic vehicles. Proceedings of the Twenty-ninth IEEE Conference on Decision and control, Honolulu, HI, 5–7 December 1990, Vol. 6, pp. 3347–3348 (IEEE Control System Society).

Krause

J. M.

Hartmann

G. L.

Ianculescu

G. D.

Thermal control of hypersonic vehicle propulsion. Proceedings of the American Control Conference, Green Valley, Arizona, 1991, Vol. 3, pp. 2961–2966.

Reich

Hinger

Huchler

Thermal protection systems for hypersonic transport vehicles. Twentieth Intersociety Conference on Environmental systems, Williamburg, Virginia, 9–12 July, 1990.

Rainey

S. M.

Veziroglu

T. N.

Computer modelling and comparison of hydrogen-fueled and methane-fueled hypersonic vehicles. Int. J. Hydrogen Energy, 1992, 17(1), 53–61.

Al-Garni

A. Z.

Sahin

A. Z.

Yilbas

B. S.

Ahmed

S. A.

Cooling of aerospace plane using liquid hydrogen and methane. Am. Inst. Aeronaut. Astronaut. J. Aircraft, May-June 1995, 32(3), pp. 539–546.

Vinh

N. X.

Optimal trajectories in atmospheric flight, 1981 (Elsevier Scientific Publishing Company, Amsterdam).

Al-Garni

A. Z.

Performance and control of ascending trajectories to minimize heat load for transatmospheric aero-space planes. PhD dissertation, Department of Aerospace Engineering, University of Maryland, College Park, Maryland, 1991.

Barlow

J. B.

Al-Garni

A. Z.

Ascending trajectories performance and control to minimize heat load for the transatmospheric aerospace plane. AIAA Conference on Atmospheric flight mechanics, Portland, Oregon, 20–22 August 1990, paper 90–2828 (American Institute of Aeronautics and Astronautics).

10.

Anderson

J. D.

Hypersonic and high temperature gas dynamics, 1989 (McGraw-Hill, New York).

11.

Schilichting

Boundary-layer theory, 7th edition, 1979, p. 599 (McGraw-Hill, New York).

12.

Roberson

J. A.

Crowe

C. T.

Engineering fluid mechanics, 3rd edition, 1980, pp. 694–695 (Houghton Mifflin, Boston, Massachusetts).

13.

Van Wylen

G. J.

Sonntag

R. E.

Fundamentals of classical thermodynamics, 3rd edition, 1985, pp. 103 and 651 (John Wiley, New York).

14.

Lide

D. R.

CRC handbook of chemistry and physics, 72nd edition, 1992, pp. 6–111, (CRC Press, Boca Raton, Florida).

15.

Cox

K. E.

Williamson

K. D.

Hydrogen: its technology and implications, Vol. II, Transmission and storage, 1977, p. 52 (CRC Press, Cleveland, Ohio).

16.

Perry

J. H.

Chemical engineers' handbook, 4th edition, 1963, pp. 3–228 (McGraw-Hill, New York).